Search

The C4F7N/CO2 mixture is considered one of the most promising alternatives to sulfur SF6. Recent studies have shown that the addition of O2 to the C4F7N/CO2 mixture can suppress carbon precipitation following electric arc discharges. This paper conducts arc-burning experimental research on SF6, 10%C4F7N/90%CO2, and 10%C4F7N/85%CO2/5%O2 mixtures. Measurements were taken of the arc voltage and arc current under a 10 kA breaking current for these three gases. Additionally, the pressure at the nozzle throat during arc and cold flow conditions, as well as the pressure in the storage chamber, were measured. The post-arc current and Rate of Rise of Recovery Voltage (RRRV) for the three gases were calculated. The study also compared the solid precipitates in the gas medium after multiple arc-burning experiments. The results indicate that adding O2 to the C4F7N/CO2 mixture can increase the pressure at the nozzle throat during the arc phase, and the inclusion of O2 has minimal impact on the peak arc-extinguishing voltage and critical RRRV. It is hypothesized that a small amount of oxygen has a negligible effect on the thermal recovery properties of the C4F7N/CO2 mixture, while also inhibiting the precipitation of carbon following electric arc discharges. This research could provide a reference for developing and optimizing eco-friendly high-voltage circuit breakers.

In recent years, the C4F7N mixed gas has attracted considerable attention for its outstanding insulation and arc-extinguishing capabilities, positioning it as a potential substitute for sulfur hexafluoride, SF6. However, there remains a limited understanding of the arc-extinguishing and insulation performance of C4F7N/CO2 mixed gas. In addition, there is limited research on high-current breaking in circuit breakers. Therefore, this study aims to investigate the arc characteristics and breaking behavior of 10%C4F7N/90%CO2 and 15%C4F7N/85%CO2 mixed gases using a magnetohydrodynamic model based on the 252kV air pressure circuit breaker. The dynamic characteristics of this mixed gas are compared with pure SF6 under short-circuit current breaking conditions, while analyzing different parameters of the C4F7N configuration. The results indicate that the mixed gas exhibits lower levels in terms of arc temperature, axial diffusion distance and pressure difference at the moment of arc initiation compared to pure SF6. Furthermore, increasing the inflating pressure can effectively enhance the breaking performance of the circuit breaker with 0.6 MPa, making it more suitable. Additionally, increasing the proportion of C4F7N in the mixed gases will cause the arc temperature to rise slightly at the initial arc and current crossing zero, but decrease at the peak current. The core pressure also rises significantly, with a greater pressure difference established in the compressor at moment of arc initiation. This study provides a reference for the design of an environmentally friendly circuit breaker and the selection of the mixed gas ratio.

Blast furnace ironmaking is one of the most serious carbon dioxide emission processes. To reduce energy consumption and CO2 emissions, fluidized bed ironmaking technology with hydrogen as a reducing agent has attracted more and more attention. An inclined agitator was added to the fluidized bed reactor to address the sticking issue in the conventional fluidized bed ironmaking process. In this research, numerical simulation was used to examine the impacts of reducing gas composition and agitation speed on the gas-solid fluidization quality in the cold fluidization of iron ore powder in the fluidized bed with an inclined agitator. The results indicate that the fluidization effect of iron ore powder is better when the volume ratios of H2 to CO and H2 to N2 are 1:1. Under the intensive shear action of the agitator, the standard deviation of pressure drop constantly decreases with the increase in agitation speed, and the decreasing range is smaller and smaller. The fluidization state of the iron ore powder particles in the bed stabilized when the agitation speed reached 160 rpm.