Search

The effluents generated by the tannery industry have a high content of chromium and other toxic elements, representing a potential threat to ecosystems. An eco-friendly alternative to treat these effluents is the use of microorganisms, such as fungi, with the capacity to biosorb heavy metals. The present work aims to determine the effect of the molasses concentration, pH variation, and time on the removal of total chromium using the filamentous fungus Trichoderma spp. An experimental design was adopted using pH (4 and 6), concentrations of molasses (0.5 and 1%), and time (8 and 12 days) as independent variables. The Trichoderma inoculum was constant in all the treatments. The different treatments were evaluated after 0, 8, and 12 days by taking 50 mL of sample from each bioreactor. The chromium concentration was subsequently determined in each sample. The results show that treatment 3 (1% molasses and pH 4) showed higher chromium removal after both 8 and 12 days. The concentrations of total chromium decreased from 665 mg/mL to values of 568 mg/mL by day 8 and 486 mg/mL by day 12. These values are, however, still above the maximum threshold imposed by Peruvian law regarding the discharge of non-domestic effluents into the sewage system. The results show that Trichoderma spp. can increasingly remove chromium from the effluent with longer incubation periods. However, future studies are necessary to determine the mechanisms of chromium biosorption by the fungus and the influence of other physicochemical parameters.

This research aimed to use kiwi waste as fuel to generate bioelectricity through microbial fuel cells. It was possible to generate an electrical current and voltage peaks of 3.807 ± 0.102 mA and 0.993 ± 0.061 V on day 11, showing an electrical conductivity of 189.82 ± 3.029 mS/cm and an optimum operating pH of 5.966 ± 0.121. The internal resistance of the cells was calculated using Ohm’s Law, resulting in a value of 14.957 ± 0.394 Ω, while the maximum power density was 212.68 ± 26.84 mW/m2 at a current density of 4.506 A/cm2. Through the analysis of the FTIR spectra carried out on the substrate, a decrease in the characteristic organic peaks was observed due to their decomposition during the electricity-generation process. In addition, it was possible to molecularly identify the bacteria Comamonas testosteroni, Sphingobacterium sp., and Stenotropho-monas maltophila adhered to the anodized biofilm. Finally, the capacity of this residue to generate bioelectricity was demonstrated by lighting an LED bulb with a voltage of 2.85 V.

Pollution generated by the misuse of large amounts of fruit and vegetable waste has become a major environmental and social problem for developing countries due to the absence of specialized collection centers for this type of waste. This research aims to generate electricity in an eco-friendly way using red dragon fruit (pitahaya) waste as the fuel in single-chamber microbial fuel cells on a laboratory scale using zinc and copper electrodes. It was possible to generate voltage and current peaks of 0.46 ± 0.03 V and 2.86 ± 0.07 mA, respectively, with an optimum operating pH of 4.22 ± 0.09 and an electrical conductivity of 175.86 ± 4.72 mS/cm at 8 °Brix until the tenth day of monitoring. An internal resistance of 75.58 ± 5.89 Ω was also calculated with a maximum power density of 304.33 ± 16.51 mW/cm2 at a current density of 5.06 A/cm2, while the FTIR spectra showed a decrease in the initial compounds and endings, especially at the 3331 cm−1 peaks of the O–H bonds. Finally, the yeast-like fungus Geotrichum candidum was molecularly identified (99.59%). This research will provide great opportunities for the generation of renewable energy using biomass as fuel through electronic devices with great potential to generate electricity.

The compatibility between biocontrol agents and pesticides seems to be a sustainable control strategy in agriculture. Therefore, the in vitro compatibility of three native isolates of Trichoderma was evaluated in three concentrations of chlorpyrifos (960, 1200, and 1440 mg/L), by determining the effect on spore germination, mycelial growth, and the antagonistic capacity. The isolates correspond to Trichoderma asperellum TCA 3, Trichoderma asperellum TCA 21 and Trichoderma harzianum TCA 23. Both spore germination and mycelial growth were performed using the poisoned medium method, while the antagonistic capacity was evaluated against Botrytis sp. in a dual culture. The results showed that TCA 21 strain had a higher germination percentage (79.46, 59.79, and 37.43%) than the TCA 3 and TCA 23 strains, in the three concentrations of chlorpyrifos. Regarding the mycelial growth of the three native strains in chlorpyrifos are affected when concentration of chlorpyrifos increase (p < 0.05). Finally, the antagonistic capacity of the three strains was not affected by any concentration of chlorpyrifos, where strains TCA 21 and TCA 23 presented a degree of antagonism of one, while TCA 3 presented a degree of two, according to the scale used by Bell. In conclusion, T. asperellum TCA 21 was the one that presented the best in vitro compatibility with chlorpyrifos at concentrations of 960 and 1200 mg/L, compared to T. asperellum TCA 3 and TCA 23. These results are favorable for field application since these native strains can also have the ability to degrade the insecticide, representing a sustainable and eco-friendly alternative to the environment.

The objective was to determine the effect of inoculum concentration on the degradation of Diesel 2 by a microbial consortium called BIOT.PD001. For this, five systems were designed (in triplicate), which Contained Davis Minimum Medium, 5% Diesel 2 as a carbon source, and a suspension of the microbial consortium BIOT.PD001 (9 × 108 cells/mL) in concentrations of 2, 4, 6, 8, and 10% of the final volume. The monitoring of the degradation of Diesel 2 was carried out indirectly through the bacterial counts by the plate count method, the Biochemical Oxygen Demand (BOD5) by the Winkler Method modified according to Alsterberg, and the concentration of total fats by Gerber’s method. The retention time was 15 days. It was observed that the percentage of efficiency of the process increases as the concentration of inoculum increases, obtaining the highest percentage of efficiency (94.77%) when using 10% of inoculum (v/v), while when using inoculum concentrations of 2 and 4% (v/v), the efficiency percentages are the lowest, (68.4 and 66.6%, respectively). On the other hand, the variance analysis indicated that there is a significant difference between the averages of these values. The regression analysis indicated that the inoculum concentration significantly affects the efficiency of Diesel 2 degradation and that this is 86% explained by a linear regression model. There is a linear relationship between the inoculum concentration of the BIOT.PD001 microbial consortium and the BOD5 tend to decrease as a function of time. It is concluded that the inoculum concentration significantly affects the efficiency of the degradation of Diesel 2 by the BIOT.PD001 consortium.

Papaya (Carica papaya) waste cause significant commercial and environmental damage, mainly due to the economic losses and foul odours they emit when decomposing. Therefore, this work provides an innovative way to generate electricity for the benefit of society and companies dedicated to the import and export of this fruit. Microbial fuel cells are a technology that allows electricity generation. These cells were produced with low-cost materials using zinc and copper electrodes, while a 150 mL polymethylmethacrylate tube was used as a substrate collection chamber (papaya waste). Maximum values of 0.736 ± 0.204 V and 5.57 ± 0.45 mA were generated, while pH values increased from 3.848 to 8.227 ± 0.35 and Brix decreased slowly from the first day. The maximum power density value was 878.38 mW/cm2 at a current density of 7.245 A/cm2 at a maximum voltage of 1072.77 mV. The bacteria were identified with an identity percentage of 99.32% for Achromobacter xylosoxidans species, 99.93% for Acinetobacter bereziniae, and 100.00% for Stenotrophomonas maltophilia. This research gives a new way for the use of papaya waste for bioelectricity generation.

Research on the use of microbial biosensors for monitoring wastewater contaminants is a topic that covers few publications compared to their applicability in other fields, such as biomedical research. For this reason, a systematic analysis of the topic was carried out, for which research-type articles were reviewed during the period 2012 to September 2022. For this, different search platforms were used, including PubMed, ScienceDirect, Springer Link, and Scopus, and through the use of search equations a relevant bibliography was located. After that, the research articles were selected based on exclusion criteria. As a result, it was found that, of the 126 articles, only 16 articles were strictly related to the topic, since there was a duplication of articles among the different databases. It was possible to demonstrate the usefulness of microorganisms as components of biosensors to monitor BOD, heavy metals, and inorganic contaminants in wastewater that also had a high sensitivity. Additionally, recombinant DNA techniques were shown to improve the performance of this type of biosensor and can finally be coupled to other emerging technologies, such as microbial fuel cells (MFCs). In conclusion, it was established that microbial biosensors have high acceptability and monitoring characteristics that make them a useful tool to detect low concentrations of pollutants in wastewater that can also provide results in real-time, thus generating forms of ecological safety and social responsibility in companies where wastewater is generated.

The biosorption of arsenic (As) with macroalgae has aroused much interest as a clean and low-cost technology. To evaluate arsenic biosorption by Chondracanthus chamissoi and Cladophora sp., approximately 5 kg of algae was collected from Huanchaco’s beach and Sausacocha lake (Huamachuco), La Libertad. As biosorption was carried out in four column systems, with 2 g of algae pellets each, circulating As solutions of 0.25 and 1.25 ppm, respectively, at 300 mL/min cm2. As concentration was determined at 3 and 6 h of treatment by flame atomic absorption spectrophotometry. Data were analyzed using Student’s t-test with 95% confidence. At 6 h, Chondracanthus chamissoi presented an As biosorption of 95.76% in a 0.25 ppm mg/L solution and 85.33% in a 1.25 mg/L solution. Cladophora sp., at 6 h, presented an As biosorption of 95.76% in a 0.25 mg/L solution and 42.03% in a 1.25 mg/L solution. It was concluded that Chondracanthus chamissoi achieves higher percentages of biosorption than Cladophora sp. in solutions of 1.25 mg/L As (p < 0.05), and that there is no significant difference between the biosorption percentages of Chondracanthus chamissoi and Cladophora sp. in a 0.25 mg/L solution of As at 6 h of treatment (p > 0.05).

Global warming and the increase in organic waste from agro-industries create a major problem for the environment. In this sense, microbial fuel cells (MFC) have great potential for the generation of bioelectricity by using organic waste as fuel. This research produced low-cost MFC by using zinc and copper electrodes and taking blueberry waste as fuel. A peak current and voltage of 1.130 ± 0.018 mA and 1.127 ± 0.096 V, respectively, were generated. The pH levels were acid, with peak conductivity values of 233. 94 ± 0.345 mS/cm and the degrees Brix were descending from the first day. The maximum power density was 3.155 ± 0.24 W/cm2 at 374.4 mA/cm2 current density, and Cándida boidinii was identified by means of molecular biology and bioinformatics techniques. This research gives a new way to generate electricity with this type of waste, generating added value for the companies in this area and helping to reduce global warming.

The accelerated increase in energy consumption by human activity has generated an increase in the search for new energies that do not pollute the environment, due to this, microbial fuel cells are shown as a promising technology. The objective of this research was to observe the influence on the generation of bioelectricity of sucrose, with different percentages (0%, 5%, 10% and 20%), in papaya waste using microbial fuel cells (MFCs). It was possible to generate voltage and current peaks of 0.955 V and 5.079 mA for the cell with 20% sucrose, which operated at an optimal pH of 4.98 on day fifteen. In the same way, the internal resistance values of all the cells were influenced by the increase in sucrose, showing that the cell without sucrose was 0.1952 ± 0.00214 KΩ and with 20% it was 0.044306 ± 0.0014 KΩ. The maximum power density was 583.09 mW/cm2 at a current density of 407.13 A/cm2 and with a peak voltage of 910.94 mV, while phenolic compounds are the ones with the greatest presence in the FTIR (Fourier transform infrared spectroscopy) absorbance spectrum. We were able to molecularly identify the species Achromobacter xylosoxidans (99.32%), Acinetobacter bereziniae (99.93%) and Stenotrophomonas maltophilia (100%) present in the anode electrode of the MFCs. This research gives a novel use for sucrose to increase the energy values in a microbial fuel cell, improving the existing ones and generating a novel way of generating electricity that is friendly to the environment.

The large amounts of organic waste thrown into the garbage without any productivity, and the increase in the demand for electrical energy worldwide, has led to the search for new eco-friendly ways of generating electricity. Because of this, microbial fuel cells have begun to be used as a technology to generate bioelectricity. The main objective of this research was to generate bioelectricity through banana waste using a low-cost laboratory-scale method, achieving the generation of maximum currents and voltages of 3.71667 ± 0.05304 mA and 1.01 ± 0.017 V, with an optimal pH of 4.023 ± 0.064 and a maximum electrical conductivity of the substrate of 182.333 ± 3.51 µS/cm. The FTIR spectra of the initial and final substrate show a decrease in the peaks belonging to phenolic compounds, alkanes, and alkenes, mainly. The maximum power density was 5736.112 ± 12.62 mW/cm2 at a current density of 6.501 A/cm2 with a peak voltage of 1006.95 mV. The molecular analysis of the biofilm formed on the anode electrode identified the species Pseudomonas aeruginosa (100%), and Paenalcaligenes suwonensis (99.09%), Klebsiella oxytoca (99.39%) and Raoultella terrigena (99.8%), as the main electricity generators for this type of substrate. This research gives a second use to the fruit with benefits for farmers and companies dedicated to exporting and importing because they can reduce their expenses by using their own waste.