Search

Electrodialysis (ED) has been recently proposed to desalinate polymer-flooding produced water (PFPW), a byproduct stream from the oil and gas industry rich in charged polymers. However, process performance is limited by fouling occurring on the ion-exchange membranes, particularly on the anionic ones (AEMs). Thus, this study aimed to correlate the properties of different AEMs with their performance while desalinating PFPW, ultimately evaluating their significance when fouling is to be minimized and operation improved. Six stacks containing different homogeneous and commercially available AEMs were employed to desalinate synthetic PFPW during 8-days ED experiments operated in reversal mode. AEMs recovered from the stacks were analyzed in terms of water uptake, ion-exchange capacity, permselectivity, and area resistance, and compared with virgin AEMs. Relatively small changes were measured for most of the parameters evaluated. For most AEMs, the water uptake and resistance increased, while the ion-exchange capacity (IEC) and permselectivity decreased during operation. Ultimately, AEMs with high area resistance were linked to the fast development of limiting current conditions in the stack, so this property turned out to be the most relevant when desalinating PFPW.

This study examines the effect of mixing on the performance of anaerobic digestion of cow manure in Chinese dome digesters (CDDs) at ambient temperatures (27−32 °C) in comparison with impeller mixed digesters (STRs) and unmixed digesters (UMDs) at the laboratory scale. The CDD is a type of household digester used in rural and pre-urban areas of developing countries for cooking. They are mixed by hydraulic variation during gas production and gas use. Six digesters (two of each type) were operated at two different influent total solids (TS) concentration, at a hydraulic retention time (HRT) of 30 days for 319 days. The STRs were mixed at 55 rpm, 10 min/hour; the unmixed digesters were not mixed, and the Chinese dome digesters were mixed once a day releasing the stored biogas under pressure. The reactors exhibited different specific biogas production and treatment efficiencies at steady state conditions. The STR 1 exhibited the highest methane (CH4) production and treatment efficiency (volatile solid (VS) reduction), followed by STR 2. The CDDs performed better (10% more methane) than the UMDs, but less (approx. 8%) compared to STRs. The mixing regime via hydraulic variation in the CDD was limited despite a higher volumetric biogas rate and therefore requires optimization.

Chinese dome digesters are usually operated at long hydraulic retention times (HRT) and low influent total solids (TS) concentration because of limited mixing. In this study, a newly optimised Chinese dome digester with a self-agitating mechanism was investigated at a pilot scale (digester volume = 500 L) and compared with a conventional Chinese dome digester (as blank) at 15% influent TS concentration at two retention times (30 and 40 days). The reactors were operated at ambient temperature: 27−33 °C. The average specific methane production, volatile fatty acids and percentage of volatile solids (VS) reduction are 0.16 ± 0.13 and 0.25 ± 0.05L CH4/g VS; 1 ± 0.5 and 0.7 ± 0.3 g/L; and 51 ± 14 and 57 ± 10% at 40 days HRT (day 52−136) for the blank and optimised digester, respectively. At 30 days HRT (day 137−309) the results are 0.19 ± 0.12 and 0.23 ± 0.04 L CH4/g VS; 1.2 ± 0.6 and 0.7 ± 0.3 g/L; and 51 ± 9 and 58 ± 11.6%. Overall, the optimised digester produced 40% more methane than the blank, despite the high loading rates applied. The optimised digester showed superior digestion treatment efficiency and was more stable in terms of VFA concentration than the blank digester, can be therefore operated at high influent TS (15%) concentration.