Search

A 1550 nm all-fiber dual-polarization coherent Doppler lidar (DPCDL) was constructed to measure the depolarization ratio of atmospheric aerosols. In lidar systems, the polarization state of the laser source is typically required to be that of linearly parallel polarization. However, due to the influence of the fiber-optical transmission and the large-mode field output of the telescope, the laser polarization state changes. Hence, a polarizer was mounted to the emitting channel of the telescope to eliminate the depolarization effect. A fiber-optical polarization beam splitter divided the backscattered light into components with parallel and perpendicular polarization. The DPCDL used two coherent channels to receive each of these two polarization components. A calibration procedure was designed for the depolarization ratio to determine the differences in gain and non-responsiveness in the two polarization channels. The calibration factor was found to be 1.13. Additionally, the systematic error and the measured random error of the DPCDL were estimated to evaluate the performance of the system. The DPCDL’s systematic error was found to be about 0.0024, and the standard deviation was lower than 0.0048. The Allan deviations of a 1-min averaging window with a low SNR of 19 dB and a high SNR of 27 dB were 0.0104 and 0.0031, respectively. The random errors at different measured heights were mainly distributed below 0.015. To confirm the authenticity of the atmospheric depolarization ratio measured with the DPCDL, two field observations were conducted with the use of a co-located DPCDL and micro-pulse polarization lidar to perform a comparison. The results showed that the correlation coefficients of the aerosol depolarization ratios were 0.73 and 0.77, respectively. Moreover, the two continuous observations demonstrated the robustness and stability of the DPCDL. The depolarization ratios were detected in different weather conditions.

The direct and indirect radiation forcing of aerosol particles deeply affect the energy budget and the atmospheric chemical and physical processes. To retrieve the vertical aerosol mass fluxes and to investigate the vertical transport process of aerosol by a coherent Doppler lidar (CDL), a practical method for instrumental calibration and aerosol optical properties retrieval based on CDL and sun photometer synchronization observations has been developed. A conversion of aerosol optical properties to aerosol microphysical properties is achieved by applying a well-developed algorithm. Furthermore, combining the vertical velocity measured simultaneously with a CDL, we use the eddy covariance (EC) method to retrieve the vertical turbulent aerosol mass fluxes by a CDL and sun photometer with a spatial resolution of 15 m and a temporal resolution of 1 s throughout the planetary boundary layer (PBL). In this paper, we present a measurement case of 24-h continuous fluxes observations and analyze the diurnal variation of the vertical velocity, the aerosol backscatter coefficient at 1550 nm, the mean aerosol mass concentration, and the vertical aerosol mass fluxes on 13 April 2020. Finally, the main relative errors in aerosol mass flux retrieval, including sample error σF,S, aerosol optical properties retrieval error σF,R, and error introduced from aerosol microphysical properties retrieval algorithm σF,I, are evaluated. The sample error σF,S is the dominating error which increases with height except during 12:00–13:12 LST. The aerosol optical properties retrieval error σF,R is 21% and the error introduced from the aerosol microphysical properties retrieval algorithm σF,I is less than 50%.

Revealing brain functional connection pathways is of great significance in understanding the cognitive mechanism of the brain. In this paper, we present a novel rough set based dynamic multi-reduction algorithm (DMRA) to analyze brain functional connection pathways. First, a binary discernibility matrix is introduced to obtain a reduction, and a reduction equivalence theorem is proposed and proved to verify the feasibility of reduction algorithm. Based on this idea, we propose a dynamic single-reduction algorithm (DSRA) to obtain a seed reduction, in which two dynamical acceleration mechanisms are presented to reduce the size of the binary discernibility matrix dynamically. Then, the dynamic multi-reduction algorithm is proposed, and multi-reductions can be obtained by replacing the non-core attributes in seed reduction. Comparative performance experiments were carried out on the UCI datasets to illustrate the superiority of DMRA in execution time and classification accuracy. A memory cognitive experiment was designed and three brain functional connection pathways were successfully obtained from brain functional Magnetic Resonance Imaging (fMRI) by employing the proposed DMRA. The theoretical and empirical results both illustrate the potentials of DMRA for brain functional connection pathways analysis.

Optical and geometrical characteristics of the cirrus clouds over Naqu (4508 m a.s.l., 31.48° N, 92.06° E), in the Tibetan Plateau were determined from LiDAR and radiosonde measurements performed during the third TIbetan Plateau EXperiment of atmospheric sciences (TIPEX III) campaign from July to August 2014. For the analysis of the temperature dependence, the simultaneous observations with LiDAR and radiosonde were conducted. Cirrus clouds were generally observed ranging from 5.2 km to 12 km above ground level (AGL) (i.e., 9.7 km to 16.5 km a.s.l.), with the midcloud temperatures ranging from −79.7 to −26.0 °C. The cloud thickness generally differed from 0.12 to 2.55 km with a mean thickness of 1.22 ± 0.70 km, and 85.7% of the measurement cases had thickness smaller than 1.5 km. The retrievals of linear particle depolarization ratio, extinction coefficient, and optical depth of cirrus clouds were provided. Moreover, the multiple scattering effect inside of cirrus clouds was corrected. The linear particle depolarization ratio of the cirrus clouds varied from 0.36 to 0.52, with a mean value of 0.44 ± 0.04. The optical depth of the cirrus clouds was between 0.01 and 3 following the scheme of Fernald-Klett method. Sub-visual, thin, and opaque cirrus clouds were observed at 4.76%, 61.90% and 33.34% of the measured cases, respectively. The temperature and thickness dependencies of the optical properties were studied in detail. A maximum cirrus thickness of around 2 km was found at temperatures between −60 and −50 °C. This study shows that the mean extinction coefficient of the cirrus clouds increases with the increase of temperature. Conversely, the measurements indicate that the linear particle depolarization ratio decreases with the increasing temperature. The relationships between the existence of cirrus clouds and the temperature anomaly (temperature difference from the mean value of the temperature during July and August 2014 over Naqu) and deep convective activity are also discussed. The formation of cirrus clouds is investigated and also its apparent relationship with the South Asia High Pressure, the dynamic processes of Rossby wave, and deep convective activity over the Tibetan Plateau. The outgoing longwave radiation of cirrus clouds is calculated with the Fu-Liou model and is shown to increases monotonously with the increase of optical depth.

A brief description of the Water vapor, Cloud and Aerosol Lidar (WACAL) system is provided. To calibrate the volume linear depolarization ratio, the concept of “ Δ 90 ° -calibration” is applied in this study. This effective and accurate calibration method is adjusted according to the design of WACAL. Error calculations and analysis of the gain ratio, calibrated volume linear depolarization ratio and particle linear depolarization ratio are provided as well. In this method, the influences of the gain ratio, the rotation angle of the plane of polarization and the polarizing beam splitter are discussed in depth. Two groups of measurements with half wave plate (HWP) at angles of (0 ° , 45 ° ) and (22.5 ° , −22.5 ° ) are operated to calibrate the volume linear depolarization ratio. Then, the particle linear depolarization ratios measured by WACAL and CALIOP (the Cloud-Aerosol Lidar with Orthogonal Polarization) during the simultaneous observations were compared. Good agreements are found. The calibration method was applied in the third Tibetan Plateau Experiment of Atmospheric Sciences (TIPEX III) in 2013 and 2014 in China. Vertical profiles of the particle depolarization ratio of clouds and aerosol in the Tibetan Plateau were measured with WACAL in Litang (30.03° N, 100.28° E, 3949 m above sea level (a.s.l.)) in 2013 and Naqu (31.48° N, 92.06° E, 4508 m a.s.l.) in 2014. Then an analysis on the polarizing properties of the aerosol, clouds and cirrus over the Tibetan Plateau is provided. The particle depolarization ratio of cirrus clouds varies from 0.36 to 0.52, with a mean value of 0.44 ± 0.04. Cirrus clouds occurred between 5.2 and 12 km above ground level (a.g.l.). The cloud thickness ranges from 0.12 to 2.55 km with a mean thickness of 1.22 ± 0.70 km. It is found that the particle depolarization ratio of cirrus clouds become larger as the height increases. However, the increase rate of the particle depolarization ratio becomes smaller as the height increases.