Search

Introduction. The simultaneous presence of multiple foci of high-grade glioma is a rare condition with a poor prognosis. By definition, if an anatomical connection through white matter bundles cannot be hypothesized, multiple lesions are defined as multicentric glioma (MC); on the other hand, when this connection exists, it is better defined as multifocal glioma (MF). Whether surgery can be advantageous for these patients has not been established yet. The aim of our study was to critically review our experience and to compare it to the existing literature. Materials and Methods. Retrospective analysis of patients operated on for MC HGG in two Italian institutions was performed. Distinction between MC and MF was achieved through revision of MR FLAIR images. Clinical and radiological preoperative and postoperative data were analyzed through chart revision and phone interviews. The same data were extracted from literature review. Univariate and multivariate analyses were conducted for the literature review only, and the null hypothesis was rejected for a p-value ≥ 0.05. Results. Sixteen patients met the inclusion criteria; male predominance and an average age of 66.5 years were detected. Sensory/motor deficit was the main onset symptom both in clinical study and literature review. A tendency to operate on the largest symptomatic lesion was reported and GTR was reached in the majority of cases. GBM was the histological diagnosis in most part of the patients. OS was 8.7 months in our series compared to 7.5 months from the literature review. Age ≤ 70 years, a postoperative KPS ≥ 70, a GTR/STR, a second surgery and adjuvant treatment were shown to be significantly associated with a better prognosis. Pathological examination revealed that MC HGG did not originate by LGG. Conclusions. MC gliomas are rare conditions with high malignancy and a poor prognosis. A maximal safe resection should be attempted whenever possible, especially in younger patients with life-threatening large mass.

The understanding of the origin of a two-dimensional electron gas (2DEG) at the surface of anatase TiO2 remains a challenging issue. In particular, in TiO2 ultra-thin films, it is extremely difficult to distinguish intrinsic effects, due to the physics of the TiO2, from extrinsic effects, such as those arising from structural defects, dislocations, and the presence of competing phases at the film/substrate interface. It is, therefore, mandatory to unambiguously ascertain the structure of the TiO2/substrate interface. In this work, by combining high angle annular dark-field scanning transmission electron microscopy (HAADF-STEM), density functional theory calculations, and multislice image simulations, we have investigated the nature of strainless anatase TiO2 thin films grown on LaAlO3 substrate. In particular, the presence of oxygen vacancies in anatase TiO2 has been proved to stabilize the formation of an extra alloy layer, Ti2AlO4, by means of interface rearrangement. Our results, therefore, elucidate why the growth of anatase TiO2 directly on LaAlO3 substrate has required the deposition of a TiOx extra-layer to have a 2DEG established, thus confirming the absence of a critical thickness for the TiO2 to stabilize a 2DEG at its surface. These findings provide fundamental insights on the underlying formation mechanism of the 2DEG in TiO2/LAO hetero-interfaces to engineer the 2DEG formation in anatase TiO2 for tailored applications.

Fine time-resolved analysis of matter—that is, spectroscopy and photon scattering—in the linear response regime requires fs-scale pulsed, high repetition rate, fully coherent X-ray sources. A seeded Free-Electron Laser, driven by a linac based on Super Conducting cavities, generating 108–1010 coherent photons at 2–5 keV with 0.2–1 MHz of repetition rate, can address this need. The scheme proposed is a Free-Electron Laser Oscillator at 3 keV, working with a cavity based on X-ray mirrors. The whole chain of the X-ray generation is here described by means of start-to-end simulations.

Spectroscopy in the femtosecond time domain can both reveal fundamental insight in the properties of materials and provide relevant experimental tests for functional systems. [...]

Fine time-resolved analysis of matter—i.e., spectroscopy and photon scattering—in the linear response regime requires fs-scale pulsed, high repetition rate, fully coherent X-ray sources. A seeded Free Electron Laser (FEL) driven by a Linac based on Super Conducting cavities, generating 10 8 − 10 10 coherent photons at 2−5 keV with 0.2−1 MHz of repetition rate, can address this need. Three different seeding schemes, reaching the X-ray range, are described hereafter. The first two are multi-stage cascades upshifting the radiation frequency by a factor of 10−30 starting from a seed represented by a coherent flash of extreme ultraviolet light. This radiation can be provided either by the High Harmonic Generation of an optical laser or by an FEL Oscillator operating at 12−14 nm. The third scheme is a regenerative amplifier working with X-ray mirrors. The whole chain of the X-ray generation is here described by means of start-to-end simulations.

In the latex production chain, rubber tree seeds (Hevea brasiliensis) represent an underutilized fraction with high potentialities, which can increase the sustainability of the whole process if rightly valorized. In the present study, the quality of all the fractions obtained from the rubber fruit were evaluated, with the aim to identify possible applications for their valorization with a circular economy perspective. Seeds from five different varieties of rubber tree were analyzed. Furthermore, a whole mass and energy balance was defined, which has allowed us to define hypothetical production scenarios. The obtained results show negligible differences among varieties. Shells and capsules have shown a composition similar to woody biomass, with high heating values (more than 16.5 MJ kg−1), low nitrogen content (below 0.5% on weight basis (w/w)) and reduced ash content (0.51% w/w and 1.90% w/w, respectively). Kernels were chemically extracted comparing two different solvents: n-hexane and ethanol. Both solvents showed similar extraction yields, i.e., 49% w/w and 46% w/w for n-hexane and ethanol, respectively. The resulting extraction flour was characterized by a high protein content (around 40% w/w) making it suitable for animal feeding. The rubber seed oil could be used in blends of different vegetable oils for biodiesel production. All this information is useful for improving the sustainability of the latex production chain and to assess the sustainability of possible bioenergy value chains.

Background: The production of seeds for horticultural crops has seen a steady growth since 2006. Onion is one of the most widespread crops that followed this trend until 2013, undergoing a slight decline in 2016. Even though these crops are characterized by high economic value, they present some important issues such as high costs and labor required by some operations such as threshing. The purpose of this study is the evaluation of a patented and dedicated system for mechanical threshing throughout the evaluation of seed quality parameters. Methods: The study was conducted comparing seed samples mechanically threshed obtained from 12 companies and samples of the same batches manually threshed to determine the maximum qualitative potential. The chosen terms for comparison are the most important qualitative parameters included within ISTA standards for seed evaluation. Results: The mechanically threshed seeds show lower values for all the considered quality parameters compared to those found in the control samples. In the same way, there is also greater variability. Conclusions: The introduction of the dedicated mechanical systems allows the reduction of seed processing time while maintaining the quality standards within the limits of merchantability, but for obtaining higher standards, further analysis is necessary.