Search

The Total Carbon Column Observing Network (TCCON) and the Infrared Working Group of the Network for the Detection of Atmospheric Composition Change (NDACC-IRWG) are two ground-based networks that provide the retrieved concentrations of up to 30 atmospheric trace gases, using solar absorption spectrometry. Both networks provide reference measurements for the validation of satellites and models. TCCON concentrates on long-lived greenhouse gases (GHGs) for carbon cycle studies and validation. The number of sites is limited, and the geographical coverage is uneven, covering mainly Europe and the USA. A better distribution of stations is desired to improve the representativeness of the data for various atmospheric conditions and surface conditions and to cover a large latitudinal distribution. The two successive Fiducial Reference Measurements for Greenhouse Gases European Space Agency projects (FRM4GHG and FRM4GHG2) aim at the assessment of several low-cost portable instruments for precise measurements of GHGs to complement the existing ground-based sites. Several types of low spectral resolution Fourier transform infrared (FTIR) spectrometers manufactured by Bruker, namely an EM27/SUN, a Vertex70, a fiber-coupled IRCube, and a Laser Heterodyne spectro-Radiometer (LHR) developed by UK Rutherford Appleton Laboratory are the participating instruments to achieve the Fiducial Reference Measurements (FRMs) status. Intensive side-by-side measurements were performed using all four instruments next to the Bruker IFS 125HR high spectral resolution FTIR, performing measurements in the NIR (TCCON configuration) and MIR (NDACC configuration) spectral range. The remote sensing measurements were complemented by AirCore launches, which provided in situ vertical profiles of target gases traceable to the World Meteorological Organization (WMO) reference scale. The results of the intercomparisons are shown and discussed. Except for the EM27/SUN, all other instruments, including the reference TCCON spectrometer, needed modifications during the campaign period. The EM27/SUN and the Vertex70 provided stable and precise measurements of the target gases during the campaign with quantified small biases. As part of the FRM4GHG project, one EM27/SUN is now used as a travel standard for the verification of column-integrated GHG measurements. The extension of the Vertex70 to the MIR provides the opportunity to retrieve additional concentrations of N2O, CH4, HCHO, and OCS. These MIR data products are comparable to the retrieval results from the high-resolution IFS 125HR spectrometer as operated by the NDACC. Our studies show the potential for such types of spectrometers to be used as a travel standard for the MIR species. An enclosure system with a compact solar tracker and meteorological station has been developed to house the low spectral resolution portable FTIR systems for performing solar absorption measurements. This helps the spectrometers to be mobile and enables autonomous operation, which will help to complement the TCCON and NDACC networks by extending the observational capabilities at new sites for the observation of GHGs and additional air quality gases. The development of the retrieval software allows comparable processing of the Vertex70 type of spectra as the EM27/SUN ones, therefore bringing them under the umbrella of the COllaborative Carbon Column Observing Network (COCCON). A self-assessment following the CEOS-FRM Maturity Matrix shows that the COCCON is able to provide GHG data products of FRM quality and can be used for either short-term campaigns or long-term measurements to complement the high-resolution FTIR networks.

One of the major challenges for the Australian feedlot and meat sectors is to have accurate and robust long-term greenhouse gas (GHG) emissions data. Long-term measurements of methane (CH4) emissions (2015–2017) were made at two Australian beef feedlots having different climates, cattle types, and management practices. Emissions were measured using the inverse-dispersion model (IDM) micrometeorological technique, using CH4 concentrations measured at the feedlots with a closed-path Fourier transform infrared spectroscopic technique (CP-FTIR). The emissions data were used to evaluate methods used by the Department of Climate Change, Energy, the Environment and Water to estimate CH4 emissions from feedlots in Australian national inventory calculations. Expressed as a CH4 yield (emissions per unit dry matter intake, DMI), the two feedlots had emissions of 13.1 and 18.9 g CH4 kg−1 DMI. The lower-emitting feedlot had emissions that were 30% lower than the national inventory calculations based on feed intakes, while the second feedlot had emissions that were similar to the inventory calculations. The accurate quantification of emissions from feedlots, as demonstrated as part of this study, is important for validating the national accounting methods and therefore the sector’s GHG emissions profile.

In Australia, bushfires are a natural part of the country’s landscape and essential for the regeneration of plant species; however, the 2019–20 bushfires were unprecedented in their extent and intensity. This paper is focused on the 2019–20 Australian bushfires and the resulting surface and column atmospheric carbon monoxide (CO) anomalies around Wollongong. Column CO data from the ground-based Total Carbon Column Observing Network (TCCON) and Network for the Detection of Atmospheric Composition Change (NDACC) site in Wollongong are used together with surface in situ measurements. A systematic comparison was performed between the surface in situ and column measurements of CO to better understand whether column measurements can be used as an estimate of the surface concentrations. If so, satellite column measurements of CO could be used to estimate the exposure of humans to CO and other fire-related pollutants. We find that the enhancements in the column measurements are not always significantly evident in the corresponding surface measurements. Topographical features play a key role in determining the surface exposures from column abundance especially in a coastal city like Wollongong. The topography at Wollongong, combined with meteorological effects, potentially exacerbates differences in the column and surface. Hence, satellite column amounts are unlikely to provide an accurate reflection of exposure at the ground during major events like the 2019–2020 bushfires.

The proxy method, using the ratio of total column CH4 to CO2 to reduce the effects of common biases, has been used to retrieve column-averaged dry-air mole fraction of CH4 from satellite data. The present study characterizes the remaining scattering effects in the CH4/CO2 ratio component of the Greenhouse gases Observing SATellite (GOSAT) retrieval and uses them for bias correction. The variation of bias between the GOSAT and Total Carbon Column Observing Network (TCCON) ratio component with GOSAT data-derived variables was investigated. Then, it was revealed that the variability of the bias could be reduced by using four variables for the bias correction—namely, airmass, 2 μm band radiance normalized with its noise level, the ratio between the partial column-averaged dry-air mole fraction of CH4 for the lower atmosphere and that for the upper atmosphere, and the difference in surface albedo between the CH4 and CO2 bands. The ratio of partial column CH4 reduced the dependence of bias on the cloud fraction and the difference between hemispheres. In addition to the reduction of bias (from 0.43% to 0%), the precision (standard deviation of the difference between GOSAT and TCCON) was reduced from 0.61% to 0.55% by the correction. The bias and its temporal variation were reduced for each site: the mean and standard deviation of the mean bias for individual seasons were within 0.2% for most of the sites.

Airborne particulate matter (PM) is a major health risk in urban settings. Ammonia (NH3) from vehicle exhaust is an under-recognised ingredient in the formation of inorganic PM and there remains a shortage of data to properly quantify the role of NH3 from vehicles in PM formation. An Open-path Fourier transform infra-red (OP-FTIR) spectrometer measured atmospheric NH3, carbon monoxide (CO) and carbon dioxide (CO2) at high temporal resolution (5 min) in Western Sydney over 11 months. The oxides of nitrogen (NO2 and NO; NOx) and sulphur dioxide (SO2) were measured at an adjacent air quality monitoring station. NH3 levels were maxima in the morning and evening coincident with peak traffic. During peak traffic NH3:CO ratio ranged from 0.018 to 0.022 ppbv:ppbv. Results were compared with the Greater Metropolitan Region 2008 (GMR2008) emissions inventory. Measured NH3:CO was higher during peak traffic times than the GMR2008 emissions estimates, indicating an underestimation of vehicle NH3 emissions in the inventory. Measurements also indicated the urban atmosphere was NH3 rich for the formation of ammonium sulphate ((NH4)2SO4) particulate was SO2 limited while the formation of ammonium nitrate (NH4NO3) was NH3 limited. Any reduction in NOx emissions with improved catalytic converter efficiency will be accompanied by an increase in NH3 production and potentially with an increase in NH4NO3 particulate.

We present findings from the Measurements of Urban, Marine and Biogenic Air (MUMBA) campaign, which took place in the coastal city of Wollongong in New South Wales, Australia. We focus on a few key air quality indicators, along with a comparison to regional scale chemical transport model predictions at a spatial resolution of 1 km by 1 km. We find that the CSIRO chemical transport model provides accurate simulations of ozone concentrations at most times, but underestimates the ozone enhancements that occur during extreme temperature events. The model also meets previously published performance standards for fine particulate matter less than 2.5 microns in diameter (PM2.5), and the larger aerosol fraction (PM10). We explore the observed composition of the atmosphere within this urban air-shed during the MUMBA campaign and discuss the different influences on air quality in the city. Our findings suggest that further improvements to our ability to simulate air quality in this coastal city can be made through more accurate anthropogenic and biogenic emissions inventories and better understanding of the impact of extreme temperatures on air quality. The challenges in modelling air quality within the urban air-shed of Wollongong, including difficulties in accurate simulation of the local meteorology, are likely to be replicated in many other coastal cities in the Southern Hemisphere.

The Total Carbon Column Observing Network (TCCON) is a global network dedicated to the precise and accurate measurements of greenhouse gases (GHG) in the atmosphere. The TCCON station in Burgos, Ilocos Norte, Philippines was established with the primary purpose of validating the upcoming Greenhouse gases Observing SATellite-2 (GOSAT-2) mission and in general, to respond to the need for reliable ground-based validation data for satellite GHG observations in the region. Here, we present the first 4 months of data from the new TCCON site in Burgos, initial comparisons with satellite measurements of C O 2 and model simulations of C O . A nearest sounding from Japan’s GOSAT as well as target mode observations from NASA’s Orbiting Carbon Observatory 2 (OCO-2) showed very good consistency in the retrieved column-averaged dry air mole fractions of C O 2 , yielding TCCON - satellite differences of 0.86 ± 1.06 ppm for GOSAT and 0.83 ± 1.22 ppm for OCO-2. We also show measurements of enhanced C O , probably from East Asia. GEOS-Chem model simulations were used to study the observed C O variability. However, despite the model capturing the pattern of the C O variability, there is an obvious underestimation in the C O magnitude in the model. We conclude that more measurements and modeling are necessary to adequately sample the variability over different seasons and to determine the suitability of current inventories.

n/a

Understanding the atmospheric distribution of water (H 2 O) is crucial for global warming studies and climate change mitigation. In this context, reliable satellite data are extremely valuable for their global and continuous coverage, once their quality has been assessed. Short-wavelength infrared spectra are acquired by the Thermal And Near-infrared Sensor for carbon Observation-Fourier Transform Spectrometer (TANSO-FTS) aboard the Greenhouse gases Observing Satellite (GOSAT). From these, column-averaged dry-air mole fractions of carbon dioxide, methane and water vapor (XH 2 O) have been retrieved at the National Institute for Environmental Studies (NIES, Japan) and are available as a Level 2 research product. We compare the NIES XH 2 O data, Version 02.21, with retrievals from the ground-based Total Carbon Column Observing Network (TCCON, Version GGG2014). The datasets are in good overall agreement, with GOSAT data showing a slight global low bias of −3.1% ± 24.0%, good consistency over different locations (station bias of −1.53% ± 10.35%) and reasonable correlation with TCCON (R = 0.89). We identified two potential sources of discrepancy between the NIES and TCCON retrievals over land. While the TCCON XH 2 O amounts can reach 6000–7000 ppm when the atmospheric water content is high, the correlated NIES values do not exceed 5500 ppm. This could be due to a dry bias of TANSO-FTS in situations of high humidity and aerosol content. We also determined that the GOSAT-TCCON differences directly depend on the altitude difference between the TANSO-FTS footprint and the TCCON site. Further analysis will account for these biases, but the NIES V02.21 XH 2 O product, after public release, can already be useful for water cycle studies.