Search

Background: The use of a touchless automated hand sanitizer dispenser may play a key role to reduce contagious diseases. The key problem of the conventional ultrasonic and infra-red-based dispensers is their malfunctioning due to the interference of sunlight, vehicle sound, etc. when deployed in busy public places. To overcome such limitations, this study introduced a laser-based sensing device to dispense sanitizer in an automated touchless process., Method: The dispensing system is based on an Arduino circuit breadboard where an ATmega328p microcontroller was pre-installed. To sense the proximity, a light-dependent resistor (LDR) is used where the laser light is to be blocked after the placement of human hands, hence produced a sharp decrease in the LDR sensor value. Once the LDR sensor value exceeds the lower threshold, the pump is actuated by the microcontroller, and the sanitizer dispenses through the nozzle., Results and Discussion: A novel design and subsequent fabrication of a low-cost, touchless, automated sanitizer dispenser to be used in public places, was demonstrated. The overall performance of the manufactured device was analyzed based on the cost and power consumption, and environmental factors by deploying it in busy public places as well as in indoor environment in major cities in Bangladesh, and found to be more efficient and cost-effective compared to other dispensers available in the market. A comprehensive discussion on this unique design compared to the conventional ultrasonic and infra-red based dispensers, is presented to show its suitability over the commercial ones. The guidelines of the World Health Organization are followed for the preparation of sanitizer liquid. A clear demonstration of the circuitry connections is presented herein, which facilitates the interested individual to manufacture a cost-effective dispenser device in a relatively short time and use it accordingly. Conclusion: This study reveals that the LDR-based automated hand sanitizer dispenser system is a novel concept, and it is cost-effective compared to the conventional ones. The presented device is expected to play a key role in contactless hand disinfection in public places, and reduce the spread of infectious diseases in society.

While the consumption of seaweed and seaweed-based products is very common amongst East Asian nations, forming a notable component of the daily diet, relatively very few studies have concerned the concentrations of heavy metals in these together with potential effects on human health. The present study analyses the concentrations of 17 elements in locally resourced seaweed, also assessing potential noncarcinogenic and carcinogenic risks. The samples were ground, homogenized, and quantified using the ICP-OES technique. It has been found that the essential elements K, Ca, Mg, Zn, and Na typically show concentrations somewhat greater than a number of potentially toxic metals, in particular, Cd, Pb, Ag, and As, with exceptions being Ni, Cr-VI, and Si. Statistical analysis indicates all of the latter to have similar origin, with increased concentration of these metals within the marine ecosystem. While the daily estimated intake of most metals is seen to be within the daily dietary allowance level recommended by various international organizations, the noncarcinogenic risk shows a value greater than unity, estimated via the hazard quotient. This indicates a potential for adverse effects to health arising from consumption of the sampled seaweed. The carcinogenic risk resulting from nonessential elements shows values greater than the United States Environmental Protection Agency (US-EPA) reference limit of 10 -4 . Considering the nonbiodegradability of heavy metals and metalloids and their potential accumulation in seaweed, there is need for critical examination of metal levels in the seaweeds obtained from the present study locations, together with the introduction of practices of removal of heavy metals via bio-adsorbent techniques.