Search

Relating soil moisture content to soil suction, the soil–water characteristic curve (SWCC) represents an essential feature in unsaturated soil mechanics that enables estimation of different unsaturated soil property functions and modeling of the macro-scale soil behavior. However, depending on the soil and processes under consideration, proper hydraulic characterization of a soil through direct laboratory measurements can be difficult, time-consuming, and involve many uncertainties. In the case of uniformly graded sands, there is a highly nonlinear and steep shape of the SWCC, with only a few kPa of soil suction separating saturated and residual soil moisture conditions, which makes measurements for determinations of SWCC especially challenging. This study encompasses an investigation of the sandy type of soil's behavior and presents some preliminary results and experiences on the determination of SWCC through the use of physical slope model tests. The 30 cm deep slope, inclined at 35 degrees and instrumented with soil moisture and pore water pressure sensors, was exposed to series of rainfall intensities, ranging from 37 up to 300 mm/h. The results indicated that the data on hydraulic response in monitored points are not only useful for the determination of SWCC, but that the approach is useful for investigation of hydraulic hysteresis phenomena, as well as its effects on soil moisture and pore water pressure conditions, which also affects the stability conditions of a slope. In particular, the best-fit parameters of the van Genuchten model suggested air entry values of 1.6 and 1.1 kPa for the drying and the wetting curves of the SWCC, respectively, with the two branches shifted by about 1 kPa of soil suction. [ABSTRACT FROM AUTHOR]

The Krbavčići landslide occurred in January 1979 near the town of Buzet, Croatia, after a long period of heavy rainfall. It is located in Northern Istria in the area built of flysch rock mass where numerous mass movements in the past and recent history have been recorded. A flysch rock mass is highly susceptible to weathering, which leads to material disintegration, changes in geotechnical properties, and shear strength decrease, finally resulting in instability processes in flysch slopes. This paper describes existing information about the Krbavčići landslide occurrence, laboratory testing of siltstone samples from a flysch rock mass, and numerical slope stability analyses of a possible landslide reactivation caused by possible long rainy periods and further weathering of the flysch rock mass. Slope stability analysis using the Rocscience, Slide software, as well as landslide numerical simulations using the LS-Rapid simulation software were performed on the basis of the digital elevation model (DEM) and laboratory test results of siltstones with different weathering grades. A DEM of the Krbavčići landslide was obtained on the basis of the unmanned aerial vehicle (UAV) survey conducted in March 2016. The residual shear strength of siltstones to predict a reactivation of landslides is of highest importance and was determined by ring shear and direct shear tests on siltstone samples with different weathering grades. The results of the numerical simulations show that an increase of the groundwater level in the landslide body in combination with the further weathering of the flysch rock material at the sliding surface would have the main influence on a possible landslide reactivation and the further development of the landslide displacement. [ABSTRACT FROM AUTHOR]