Search

In this study, the synthesis of tungsten carbides in a copper matrix by spark plasma sintering (SPS) is conducted and the microstructure formation mechanisms of the composite materials are investigated. The reaction mixtures were prepared by the high-energy mechanical milling (MM) of W, C and Cu powders. The influence of the MM time and SPS temperature on the tungsten carbide synthesis in an inert copper matrix was analyzed. It was demonstrated that the milling duration is a critical factor for creating the direct contacts between the W and C reactants and increasing the reactive transformation degree. A WC–W2C–Cu composite was fabricated from the W–C–3Cu powder mixture milled for 10 min and subjected to SPS at a temperature of 980 °C for 5 min. The formation of unconventional microstructures with Cu-rich regions is related to inter-particle melting during SPS. The WC–W2C–Cu composite showed a promising combination of mechanical and functional properties: a hardness of 300 HV, an electrical conductivity of 24% of the International Annealed Copper Standard, a residual porosity of less than 5%, a coefficient of friction in pair with a WC-6Co counterpart of 0.46, and a specific wear rate of the material of 0.52 × 10−5 mm3 N−1 m−1. [ABSTRACT FROM AUTHOR]

The cooperative thermomechanical properties of plant-derived polymers have been studied insufficiently, although this feedstock has a very high potential. In the present paper, we analyzed the changes in the structure and physicochemical properties of lignin-rich biomass induced by thermomechanical pretreatment. Low-temperature treatment allows one to retain the original supramolecular structure of the cell walls, while an appreciably high disintegration degree is reached. This increases the reactivity of the material in the subsequent heterogeneous reactions. Mechanical pretreatment at medium temperatures (10 °C), when almost all cell wall polymers except for low-molecular-weight lignin are in the glassy state, enhances the mobility of cell wall polymers and causes sufficient cellulose disordering, while the specific surface area is not significantly increased. High-temperature pretreatment of reed biomass is accompanied by pore formation and lignin release from the cell wall structure, which opens up new prospects for using this biomass as a matrix to produce core–shell-structured sorbents of heavy metals. The energy consumed by mechanochemical equipment for the activation of reed biomass was determined. [ABSTRACT FROM AUTHOR]

As a heterogeneous process, enzymatic hydrolysis depends on the contact area between enzymes and the cellulose substrate. The surface area of a substrate is typically evaluated through the sorption of gases (nitrogen, argon, or water vapor) or sorption of high-molecular-weight pigments or proteins. However, lignocellulosic biomass uninvolved in the reaction because of inefficient binding or even the complete inhibition of the enzymes on the surface consisting of lignin or inorganic compounds is erroneously taken into account under these conditions. The initial rate of enzymatic hydrolysis will directly depend on the number of enzymes efficiently sorbed onto cellulose. In this study, the sorption of cellulolytic enzymes was used to evaluate the surface accessibility of the cellulose substrate and its changes during mechanical pretreatment. It was demonstrated that for pure cellulose, mechanical activation did not alter the chemical composition of the surface and the initial rate of hydrolysis increased, which was inconsistent with the data on the thermal desorption of nitrogen. New active cellulose sorption sites were shown to be formed upon. the mechanical activation of plant biomass (wheat straw), and the ultimate initial rate of hydrolysis corresponding to saturation of the accessible surface area with enzyme molecules was determined. [ABSTRACT FROM AUTHOR]