Search

Not only can perovskite solar cells be exposed to high temperatures, up to 80 °C, depending on the operating environment, but absorbed energy is lost as heat, so it is important to have thermal stability for commercialization. However, in the case of the recently reported p-i-n structure solar cell, most of the electron and hole transport layers are composed of organic materials vulnerable to heat transfer, so the light absorption layer may be continuously exposed to high temperatures when the solar cell is operated. In this study, we attempted to improve the thermal conductivity of the electron transport layer using phenyl-C61-butyric acid methyl ester (PCBM) containing zinc oxide (ZnO). As a result, the thermal conductivity was improved by more than 7.4% and 23.5% by adding 6.57vol% and 22.38vol% of ZnO to PCBM, respectively. In addition, the insertion of ZnO resulted in changes in the electron transport behavior and energy level of the electron transport layer. As a result, it was confirmed that not only could the temperature stability of the perovskite thin film be improved, but the efficiency of the solar cell could also be improved from 14.12% to 17.97%. [ABSTRACT FROM AUTHOR]

Further improving the corrosion resistance of the ASTM Grade 13 (Gr13) titanium alloy was achieved by manipulating the cathodic modification effect. The cathodic modification of Gr13 was mainly related to the Ti2Ni precipitate, where minor Ru was contained and controlled the precipitate in terms of size and distribution, which could manipulate the cathodic modification effect. Parameters such as temperature and cooling rate during the recrystallization process were designed to control precipitation behavior, where the temperature at 850 °C was selected to allow the full dissolution of the Ti2Ni precipitate. The cooling rate, as high as 160.9 °C/min, was still enough for precipitation to occur during the cooling stage, leading to the formation of the Ti2Ni precipitate along with a grain boundary. The cooling rate of water quenching was too fast to cause the diffusion process, resulting in a large amount of the β-Ti phase without the precipitate, which was pre-formed while heated at 850 °C. Aging at 600 °C caused the re-precipitation of Ti2Ni, and, at that moment, the precipitate was refined and separated, as a good aspect of the catalyst for HER. Therefore, the aged sample after water quenching showed the lowest onset potential for HER with the highest corrosion potential, indicating that its passivation ability was improved by the strengthened cathodic modification effect. This improvement was confirmed by the OCP results, where passivation survival was observed for the aged sample due to the highest cathodic modification effect. Therefore, the aged sample, which had refined and separate precipitates, showed the lowest corrosion rate. [ABSTRACT FROM AUTHOR]