Search

In construction projects, conducting dynamic load tests on all piles proves impractical. Selective testing estimates bearing capacity, while the remaining piles rely on penetration depth for management. This approach, however, faces reliability issues due to varying conditions among piles. Technological advancements, such as non-contact hammers and sensors, have enhanced the accuracy of penetration depth measurements during final driving. Nonetheless, relying solely on penetration depth for construction and quality management remains problematic. This study, therefore, focuses on enhancing the use of driving formulas to improve pile quality management, particularly for the widely used pre-stressed high-strength concrete (PHC) piles. To improve pile quality management, existing driving formulas underwent review and refinement. Utilizing 258 dynamic load test data from various sites, the Hiley, Gates, and Danish formulas underwent validation through statistical analysis and graphical comparison. Enhancements to the Gates formula, achieved through curve fitting with actual data and the application of segment-based coefficients, demonstrated increased accuracy in bearing capacity estimation. These improvements offer a more reliable approach to pile quality management in construction projects. [ABSTRACT FROM AUTHOR]

The nondestructive spectral analysis of surface waves (SASW) technique determines the shear wave velocities along the wide wavelength range using Rayleigh-type surface waves that propagate along pairs of receivers on the surface. The typical configuration of source-receivers consists of a vertical source and three vertical receivers arranged in a linear array. While this approach allows for effective site characterization, laterally variable sites are often challenging to characterize. In addition, in a traditional SASW test configuration system, where sources are placed in one direction, the data are collected more on one side, which can cause an imbalance in the interpretation of the data. Data interpretation issues can be resolved by moving the source to opposite ends of the original array and relocating receivers to perform a second complete set of tests. Consequently, two different Vs profiles can be provided with only a small amount of additional time at sites where lateral variability exists. Furthermore, the testing procedure can be modified to enhance the site characterization during data collection. The advantages of performing SASW testing in both directions are discussed using a real case study. [ABSTRACT FROM AUTHOR]