Search

We conducted large-depth Ground-Penetrating Radar investigations of the seismogenic Casamicciola fault system at the volcanic island of Ischia, with the aim of constraining the source characteristics of this active and capable fault system. On 21 August 2017, a shallow (hypocentral depth of 1.2 km), moderate (Md = 4.0) earthquake hit the island, causing severe damage and two fatalities. This was the first damaging earthquake recorded on the volcanic island of Ischia from the beginning of the instrumental era. Our survey was performed using the Loza low-frequency (15–25 MHz) GPR system calibrated by TDEM results. The data highlighted variations in the electromagnetic signal due to the presence of contacts, i.e., faults down to a depth larger than 100 m below the surface. These signal variations match with the position of the synthetic and antithetic active fault system bordering the Casamicciola Holocene graben. Our study highlights the importance of employing large-depth Ground-Penetrating Radar geophysical techniques for investigating active fault systems not only in their shallower parts, but also down to a few hundred meters' depth, providing a contribution to the knowledge of seismic hazard studies on the island of Ischia and elsewhere. [ABSTRACT FROM AUTHOR]

Over the past two decades, the airborne Light Detection and Ranging (LiDAR) system has become a useful tool for acquiring high-resolution topographic data, especially in active tectonics studies. Analyzing Digital Terrain Models (DTMs) from LiDAR exposes morpho-structural elements, aiding in the understanding of fault zones, among other applications. Despite its effectiveness, challenges persist in regions with rapid deformation, dense vegetation, and human impact. We propose an adapted workflow transitioning from the conventional airborne LiDAR system to the usage of drone-based LiDAR technology for higher-resolution data acquisition. Additionally, drones offer a more cost-effective solution, both in an initial investment and ongoing operational expenses. Our goal is to demonstrate how drone-based LiDAR enhances the identification of active deformation features, particularly for earthquake-induced surface faulting. To evaluate the potential of our technique, we conducted a drone-based LiDAR survey in the Casamicciola Terme area, north of Ischia Island, Italy, known for the occurrence of destructive shallow earthquakes, including the 2017 Md = 4 event. We assessed the quality of our acquired DTM by comparing it with existing elevation datasets for the same area. We discuss the advantages and limitations of each DTM product in relation to our results, particularly when applied to fault mapping. By analyzing derivative DTM products, we identified the fault scarps within the Casamicciola Holocene Graben (CHG) and mapped its structural geometry in detail. The analysis of both linear and areal geomorphic features allowed us to identify the primary factors influencing the current morphological arrangement of the CHG area. Our detailed map depicts a nested graben formed by two main structures (the Maio and Sentinella faults) and minor internal faults (the Purgatorio and Nizzola faults). High-resolution DEMs acquired by drone-based LiDAR facilitated detailed studies of the geomorphology and fault activity. A similar approach can be applied in regions where the evidence of high slip-rate faults is difficult to identify due to vegetation cover and inaccessibility. [ABSTRACT FROM AUTHOR]

We performed a joined multitemporal and multiscale analysis of ground vertical movements around the main seismogenic source of Ischia island (Southern Italy) that, during historical and recent time, generated the most catastrophic earthquakes on the island, in its northern sector (Casamicciola fault). In particular, we considered InSAR (2015–2019) and ground-levelling data (1987–2010), attempting to better define the source that caused the recent 2017 earthquake and interpret its occurrence in the framework of a long-term behavior of the fault responsible for the major historical earthquakes in Casamicciola. Our results unambiguously constrain the location and the kinematics of the 2017 rupture and further confirm the presence of a relatively large sliding area west of the 2017 surface break. Overall, the studied seismogenic fault reveals a complex dynamic, moving differentially and aseismically in the pre- and post-seismic event, in response to the long-term subsidence of the central sector of the island, dominated by Mt. Epomeo. The fault segment that slipped coseismically also is evidence of post-seismic viscous relaxation. The long-term differential vertical movement on the apparently creeping eastern sector of the Casamicciola fault provides an estimate of the slip rate occurring on the fault (0.82 mm/y−1). The analysis of the time of occurrence and the magnitude of the known historical earthquakes reveals that this rate is consistent with the recurrence of the earthquakes that occurred during at least the past three centuries and suggests that the time to the next seismic event at Casamicciola might be a few decades. More generally, our findings provide evidence of the link between subsidence and earthquakes in volcanic areas indicating, in this case, a high hazard for the island of Ischia. Results might be also useful for characterizing capable faulting in similar volcano-tectonic settings worldwide. [ABSTRACT FROM AUTHOR]

Ischia shows intriguing and complex geology, which has been deeply investigated. In this paper, a reappraisal of the Quaternary geologic evolution of Ischia based on literature data is advised, concentrating on the volcanology of the island, based on field data and geochemistry, due to the happening of active fumarolic systems on the island and the marine geology and geophysics, which are intensively studied in the frame of the CARG Project. The literature studies have been incorporated with the geological interpretation of high-resolution seismic profiles, partly previously published and herein reorganized with the aim to highlight the geologic evolution of the different sectors of the island (northern Ischia, southern Ischia). The outcrop data have shown the deposits of ten explosive eruptions: among them, we focused on the S. Angelo Tephra. The laccolith model has been described in order to explain the resurgence of Ischia starting from 55 ky B.P. Geochemical information has been synthesized to reconstruct the volcano-tectonic development of Ischia during the last 55 ky B.P. Different models of block resurgence of Ischia have been discussed, based on literature studies. These aspects have supplemented the Quaternary geologic evolution of Ischia. While the northern Ischia offshore shows complex stratigraphic relationships between buried volcanic edifices, the southern Ischia offshore has been mainly commanded by erosional activities, progressive next to a dense system of submarine channels, and by the volcano-tectonic activities, which have triggered off the location of the Ischia Debris Avalanche. [ABSTRACT FROM AUTHOR]

The 56 ka Monte Epomeo Green Tuff (MEGT) resulted from the largest volume explosive eruption from Ischia island (south Italy). Its tephra is one of the main stratigraphic markers of the central Mediterranean area. Despite its importance, a detailed characterisation of the petrography and mineral chemistry of MEGT is lacking. To fill this gap, we present detailed petrographic description and electron microprobe mineral chemistry data on samples collected on-land from the MEGT. Juvenile clasts include pumice, scoria, and obsidian fragments with porphyritic/glomeroporphyritic, vitrophyric, and fragmental textures. The porphyritic index is 13–40 vol.%, and phenocryst phases include alkali-feldspar, plagioclase, clinopyroxene, ferrian phlogopite, and titano-magnetite, in order of decreasing abundance; accessory phases include sphene, hydroxy-fluor-apatite, and rare edenite. Plagioclase varies from predominant andesine to subordinate oligoclase, whereas alkali-feldspar is more variable from sanidine to anorthoclase; quasi-pure sanidine commonly occurs as either rim or recrystallisation overgrowth of large phenocrysts due to hydrothermal alteration. Secondary minerals include veins and patches of carbonate minerals, Fe-Mn oxyhydroxides, clay minerals, and zeolites. Clinopyroxene is ferroan diopside (En45–29Fs7–27) and never reaches Na-rich compositions. This feature allows the discrimination of MEGT from aegirine-bearing, distal tephra layers erroneously attributed to MEGT, with implications for the areal distribution of Ischia explosive deposits. [ABSTRACT FROM AUTHOR]

The Neapolitan volcanic area includes three active and high-risk volcanoes: Campi Flegrei caldera, Somma–Vesuvius, and Ischia island. The Campi Flegrei volcanic area is a typical example of a resurgent caldera, characterized by intense uplift periods followed by subsidence phases (bradyseism). After about 21 years of subsidence following the 1982–1984 unrest, a new inflation period started in 2005 and, with increasing rates over time, is ongoing. The overall uplift from 2005 to December 2019 is about 65 cm. This paper provides the history of the recent Campi Flegrei caldera unrest and an overview of the ground deformation patterns of the Somma–Vesuvius and Ischia volcanoes from continuous GPS observations. In the 2000–2019 time span, the GPS time series allowed the continuous and accurate tracking of ground and seafloor deformation of the whole volcanic area. With the aim of improving the research on volcano dynamics and hazard assessment, the full dataset of the GPS time series from the Neapolitan volcanic area from January 2000 to December 2019 is presented and made available to the scientific community. [ABSTRACT FROM AUTHOR]

Radiological risk affects the quality of the environment in buildings since population and workers can be potentially exposed to high levels of radiation. Radon gas emanating from both subsoil and building materials represents the most important source of radiation exposure for people. This study investigates the sustainability concept of a small rural village of Ischia Island, named Ciglio, in relation to radiation protection legislation concerning the radiological risk for workers. Radon activity concentration was measured in typical green-tuff dwellings and in water samples collected from a local waterfall E-Perm devices. Moreover, for green tuff as building material, the radon emanation coefficient was calculated by gamma spectroscopy. The results highlight the importance of performing environmental radon monitoring and investigating the radon content of building materials, especially in geographical areas characterized by traditional use of typical stones for constructions. In conclusion, the sustainable development of rural buildings is possible if the radiological risk for inhabitants and workers is assessed in line with the national radiation protection legislation. [ABSTRACT FROM AUTHOR]

High-resolution satellite images must undergo a geometric rectification process in order to be used for metrical purposes. This operation, called orthorectification, is necessary because of deformations mainly due to camera distortions and acquisition geometry. To correctly orthorectify an image, it is necessary to accurately reconstruct the photogrammetric-acquisition characteristics and the image position with respect to a reference system connected to the ground. This operation, called orientation, can be done using various mathematical models such as rigorous, rational polynomial function (RPF), and rational polynomial coefficient, or, according to some authors, rapid positioning coefficient (RPC) models. Orientation and orthorectification are usually performed within specific commercial software, but in QGIS, these complex operations can be performed using the open libraries of the Orfeo Tool Box (OTB). Unfortunately, instructions given by OTB developers lead to scarce results. In fact, the procedure proposed in OTB does not allow for the full exploitation of the potential of RPC models, on which OTB itself is based. As OTB is open-source software, a plugin was developed to overcome these limitations and exploit its full potential. In fact, OTB interfaces are unfortunately essential, and some necessary functions are missing. Therefore, a new QGIS plugin was developed in order to run the entire process in the most photogrammetrically and statistically correct way, and, at the same time, to simplify the relative procedures. [ABSTRACT FROM AUTHOR]

In the present paper, we analyse ground tilt and seismicity at Campi Flegrei caldera and Ischia Island, two volcanic areas located in the south of Italy. These areas have been well studied for many years from a petrological, volcanological and geophysical view point. Moreover, due to the high seismic and volcanic risk for the populations living there, they are continuously monitored by networks of geophysical and geochemical sensors. We summarize the most important results that we obtained so far, concerning the observations of relationships between seismic activity and ground tilt anomalies, focusing on the time interval 2015–2018. First, we present a detailed description of the tiltmeter and seismic networks in both the investigated areas, as well as their development and improvement over time that has enabled high quality data collection. From the joint analysis of the seismic and borehole tiltmeter signals, we often notice concurrence between tilt pattern variations and the occurrence of seismicity. Moreover, the major tilt anomalies appear to be linked with the rate and energy of volcano-tectonic earthquakes, as well as with exogenous phenomena like solid Earth tides and hydrological cycles. The analysis that we present has potential applicability to other volcanic systems. Our findings show how the joint use tilt and seismic data can contribute to better understanding of the dynamics of volcanoes. [ABSTRACT FROM AUTHOR]