Search

The rapid progress in biomedical imaging technology has generated considerable interest in new non-invasive photoacoustic endoscopy imaging techniques. This emerging technology offers significant benefits, including high spectral specificity, strong tissue penetration, and real-time multidimensional high-resolution imaging capabilities, which enhance clinical diagnosis and treatment of prostate cancer. This paper delivers a thorough review of current prostate cancer screening techniques, the core principles of photoacoustic endoscopy imaging, and the latest research on its use in detecting prostate cancer. Additionally, the limitations of this technology in prostate cancer detection are discussed, and future development trends are anticipated. [ABSTRACT FROM AUTHOR]

Silicon nitride (Si3N4) and silicon powder (Si) are two kinds of harmful solid waste in industrial production. As an environmental and low-consumption method, the cold-bonding technique is a novel method to utilize the problem of powder resource cycling. In this experiment, mechanical and high-temperature properties of Si and Si3N4 briquettes were studied after cold bonding. The results are as follows: (1) The compressive strength of the Si and Si3N4 briquettes increased with the improvement of molding pressure. With the same binder (1 wt.%) and water (10 wt.%) addition, the compressive strength of the Si3N4 briquette arrived at 12,023.53 N under 40 Mpa molding pressure, which is much higher than that of the Si briquette (942.40 N). The Si particles are uneven and irregular, which leads to an intense arch bridge effect in the Si briquette and the compressive strength decrease. Compared with Si powder, the particle size and shape of Si3N4 is small, uniform, and regular. The influence of the arch bridge effect is smaller than that in the Si briquette. (2) After being treated at 1473 K for 1 h, the compressive strength of the Si briquette increased to 5049.83 N, and the compressive strength of the Si3N4 briquette had a slight change. The surface of the briquettes was contacted with oxygen and reacted to form an outer shell which mainly contains SiO2 in the high-temperature treatment. FT-IR results have shown there were no extra impurities in cold-bonded briquettes when using the organic binder. (3) The microstructure of the cross section of the Si and Si3N4 briquettes after high-temperature treatment presented that oxygen entered the briquette through the pores and continued to react with the Si and Si3N4. The outer shell of the Si briquette grew and thickened continuously with the oxygen spreading in the Si briquette. However, because of the smaller particle size and regular shape, little oxygen diffused in the Si3N4 briquette. The outer shell of the Si3N4 briquette is fairly thin, so the compressive strength did not change too much. [ABSTRACT FROM AUTHOR]

The physical meaning of Basset force is first studied via polynomial approximation and the Fourier series representation method. After compiling the Basset force into the coupling interface with Visual C, a dynamic mathematical model is set up to describe the upward motion behavior of a single bubble by adopting the CFD-DEM method. Afterwards, the coupling interface with Basset force proposed in this study is verified experimentally and shows very good agreements. The initial velocity, releasing depth, bubble size, density ratio and viscosity ratio are studied qualitatively due to their great importance to Basset force. The ratio of Basset force to the sum of Basset force and drag force and to buoyancy, F → B a /( F → D + F → B a ) and | F → B a / F → B |, are employed to quantify the contribution of Basset force quantitatively. In addition, some instructive outlooks and recommendations on a further development of appropriate and justifiable use of Basset force are highlighted at last. [ABSTRACT FROM AUTHOR]

Hypertension during pregnancy may increase the risk of anemia in the offspring. However, few studies have investigated the effects of elevated blood pressure during the preconception period on childhood anemia. This large population-based birth cohort study was performed to determine whether abnormal preconception blood pressure has long-term consequences for childhood health. Data were obtained from the China–US Collaborative Project for Neural Tube Defect Prevention. The study consisted of 40,638 women with singleton live births who were registered in a monitoring system before pregnancy in southern China during the period 1993–1996. Children were assessed by hemoglobin measurement at approximately 53 months of age. The incidences of childhood anemia were 19.80% in the hypertension group and 16.07% in the non-hypertension group. Compared with the non-hypertension group, the hypertension group had an increased risk of childhood anemia (adjusted risk ratio (RR): 1.25; 95% confidence interval (CI): 1.11–1.41). After categorization according to blood pressure, combined systolic and diastolic hypertension was associated with a significantly increased risk of childhood anemia, compared with normotension (adjusted RR: 1.37; 95% CI: 1.16–1.63). Compared with women who had normal blood pressure, the adjusted RRs for childhood anemia were 1.20 (95% CI: 1.13–1.28), 1.26 (95% CI: 1.08–1.47), and 1.38 (95% CI: 1.14–1.67) among women with prehypertension, stage-1 hypertension, and stage-2 hypertension, respectively. Our results suggest a linear association between prepregnancy hypertension and the risk of childhood anemia in the Chinese population. Interventions targeting preconception blood pressure may have a positive effect on childhood health. [ABSTRACT FROM AUTHOR]

An industrial furnace, such as a blast furnace, molten salt furnace and a basic oxygen furnace, is a popular reactor, where the distribution of liquid, flow pattern of the fluid and the velocity of the fluid determine the energy distribution and chemical reaction in the reactor. Taking a furnace as the research object, this paper studies the effects of different inlet velocities, liquid densities and viscosity on bubble and velocity distribution. A three-dimensional mathematical model of the furnace is set up by a numerical simulation, and the volume-of-fluid (VOF) method is used to study the behavior of bubbles. The accuracy of the simulation parameters selected in the simulation calculation is verified by comparing the simulation with the experimental results. The findings show that an excessive or too small an inlet velocity will lead to an uneven distribution of chlorine in the furnace, therefore, an inlet velocity of about 30 m/s is more appropriate. In addition, changing the liquid density has little effect on the bubble and velocity distribution while choosing the appropriate liquid viscosity can ensure the proper gas holdup and fluidity of chlorine in the furnace. [ABSTRACT FROM AUTHOR]

Gestational hypertension may interfere with the placental iron metabolism, thus probably increasing the risk of childhood anemia. We aim to examine the association between gestational hypertension and childhood anemia at different ages in two large Chinese birth cohorts. Cohort 1 was conducted in 5 counties in northern China and was comprised of 17,264 mother–children pairs (97.3%) during 2006–2009, whereas cohort 2 was conducted in 21 counties in southern China and was comprised of 185,093 mother–children pairs (93.8%) during 1993–1996. All pregnant women were registered in a monitoring system and followed up until the termination of pregnancies. The childhood anemia was diagnosed at 6 month and 12 month in cohort 1 and at 55 month in cohort 2. The overall incidence of childhood anemia was 6.78% and 5.28% at 6 month and 12 month, respectively, in cohort 1 and 13.18% at 55 month in cohort 2. Gestational hypertension was associated with increased risk of anemia at 6 month (adjusted Odds Ratio (OR): 1.31; 95% confidence interval (CI): 1.05, 1.63) and at 12 month (adjusted OR: 1.50; 95% CI: 1.18, 1.90) in cohort 1 and at 55 month (adjusted OR: 1.06; 95% CI: 1.01, 1.12) in cohort 2. The hemoglobin values of children at different ages were lower among gestational hypertension group in the linear models, which was consistent with the results of binary regression analysis. Our study found gestational hypertension may associate with an increased risk of childhood anemia. It suggests a possible need for exploring changes in prenatal care that might prevent childhood anemia. [ABSTRACT FROM AUTHOR]

The main trough of a blast furnace (BF) is a main passage for hot metal and molten slag transportation from the taphole to the torpedo and the slag handling. Its appropriate working status and controlled erosion ensure a safe, stable, high-efficiency and low-cost continuous production of hot metal. In this work, the tapping process of a main trough of a BF in the east of China was numerically studied with the help of a CFD library written in C++, called OpenFOAM, based on the use of the Finite Volume Method (FVM). The results show that turbulence intensity downstream of the hot metal impact position becomes weaker and the turbulence area becomes larger in the main trough. During the tapping, thermal stress of wall refractory reaches the maximum value of 1 . 7   ×   10 7 Pa at the 4 m position in the main trough. Furthermore, baffles in the main trough placed between 5.8 m and 6.2 m were found to control and reduce the impact of the turbulence on the refractory life. The metal flowrate upstream of the baffles can be decreased by 6%, and the flow velocity on the upper sidewall and bottom wall decrease by 9% and 7%, respectively, compared with the base model. By using baffles, the minimum fatigue life of the refractory in the main trough increases by 15 tappings compared with the base model, so the period between the maintenance stops can be prolonged by about 2 days. [ABSTRACT FROM AUTHOR]

Bubble coalescence and breakup play important roles in physical-chemical processes and bubbles are treated in two groups in the interfacial area transport equation (IATE). This paper presents a review of IATE for bubble coalescence and breakup to model five bubble interaction mechanisms: bubble coalescence due to random collision, bubble coalescence due to wake entrainment, bubble breakup due to turbulent impact, bubble breakup due to shearing-off, and bubble breakup due to surface instability. In bubble coalescence, bubble size, velocity and collision frequency are dominant. In bubble breakup, the influence of viscous shear, shearing-off, and surface instability are neglected, and their corresponding theory and modelling are rare in the literature. Furthermore, combining turbulent kinetic energy and inertial force together is the best choice for the bubble breakup criterion. The reviewed one-group constitutive models include the one developed by Wu et al., Ishii and Kim, Hibiki and Ishii, Yao and Morel, and Nguyen et al. To extend the IATE prediction capability beyond bubbly flow, two-group IATE is needed and its performance is strongly dependent on the channel size and geometry. Therefore, constitutive models for two-group IATE in a three-type channel (i.e., narrow confined channel, round pipe and relatively larger pipe) are summarized. Although great progress in extending the IATE beyond churn-turbulent flow to churn-annual flow was made, there are still some issues in their modelling and experiments due to the highly distorted interface measurement. Regarded as the challenges to be addressed in the further study, some limitations of IATE general applicability and the directions for future development are highlighted. [ABSTRACT FROM AUTHOR]

The aim of this study was to investigate the properties of an organic binder used in cold-bonded briquettes (CBBs) prepared from two different iron bearing materials. The applied binder is a type of starch as indicated by chemical analysis, iodine-starch staining and Fourier transform infrared analyses. Thermogravimetric differential scanning calorimetry showed that the binder pyrolysis undergoes four stages: moisture desorption, ash volatilization, pyrolysis of organic matter and decomposition of materials with high activation energy. The difference between the dry and heat-treated samples during the macroscopic failure process is the instability propagation of the crack. The CBB shows a low decrepitation index at 700 °C. The returned fines of CBBs used with the organic binder were applied in two blast furnaces. The industrial trials showed that the CBBs do not influence the performance of the blast furnace and can reduce the fuel consumption rate. The curing rate of the binder decreases, and the growth rate of compressive strength decreases during the curing process. Iron ore particles are bonded together and exist in the form of aggregation after mixing with water and binder. The edges and corners of the particles become blurred, and the original surfaces of the particles are covered with binder film, the surface of which is covered with fine particles. The multi-branched structure of amylopectin provides omnibearing adhesion sites, thus forming binder agglomeration and film leading to a strong adhesion between binder and iron ore particles. Binder film and binder agglomeration work together to make the CBB perform well. [ABSTRACT FROM AUTHOR]