Search

This study investigates the impact of pre-treatment options on the performances of soil columns simulating soil aquifer treatment (SAT). For this purpose a conventional activated sludge (CAS) process, a membrane bioreactor (MBR) and vertical flow reed beds were used as single units or in combination before SAT. The influent and effluent from each treatment train were monitored over three successive 6-month periods, corresponding to changes in the operational conditions of the MBR and CAS units from 6 days' sludge retention time (SRT) to 12 and 20 days. All the columns acted as efficient polishing steps for solids and bacteria. The column receiving effluent from the CAS system running at 6 days' SRT also presented high total nitrogen and total phosphorus removals, but this column was also associated with the lowest infiltration rates over that period. While the quality of the effluent from the column following the CAS process increased over 18 months of operation, the effluent quality of the columns receiving MBR effluent degraded. No correlations were found between variations in SRT of the MBR and CAS processes and the columns' performances. Overall, all columns, except the one receiving CAS effluent, underwent a reduction in infiltration rate over 18 months.

Energy consumption and sludge production minimization represent rising challenges for wastewater treatment plants (WWTPs). The goal of this study is to investigate howenergy is consumed throughout the whole plant and how operating conditions affect this energy demand. A WWTP based on the activated sludge process was selected as a case study. Simulations were performed using a pre-compiled model implemented in GPS-X simulation software. Model validationwas carried out by comparing experimental and modeling data of the dynamic behavior of the mixed liquor suspended solids (MLSS) concentration and nitrogen compounds concentration, energy consumption for aeration, mixing and sludge treatment and annual sludge production over a three year exercise. In this plant, the energy required for bioreactor aeration was calculated at approximately 44% of the total energy demand. A cost optimization strategy was appliedby varying the MLSS concentrations (from1 to 8 gTSS/L)while recordingenergy consumption, sludge production and effluent quality. An increase of MLSS led to an increase of the oxygen requirement for biomass aeration, but it also reduced total sludge production. Results permit identification of a key MLSS concentration allowing identification of the best compromise between levels of treatment required, biological energy demand and sludge production while minimizing the overall costs. [ABSTRACT FROM AUTHOR]

The efficacy of three different wastewater treatment configurations, conventional activated sludge (CAS), nitrifying activated sludge (NAS) and biological nutrient removal (BNR) for removal of selected micropollutants from authentic wastewater was investigated. The processes were also characterized based on their proficiency to reduce the estrogenic activity of the influent wastewater using the in vitro recombinant yeast assay. The removal efficiency of trimethoprim improved with the complexity of the three treatment process configurations. Ibuprofen, androstendione, sulfamethoxazole, nonylphenol, estrone and bisphenol-A had moderate to high removals (>65%) while carbamazepine and meprobamate remained recalcitrant in the three treatment process configurations. The removal of gemfibrozil was better in the NAS than in BNR and CAS treatment configurations. The yeast estrogen screen (YES) assay analyses showed an improvement in estrogenicity removal in the BNR and NAS treatment configurations as compared to the CAS treatment configuration. Comparing the estrogenic responses from the three treatment configurations, the removal efficiencies followed the order of BNR= NAS>CAS and all were greater than 81%. [ABSTRACT FROM AUTHOR]