Search

Anaerobic digestion and fermentation processes in wastewater sludge treatment are limited by several factors, including the slow breakdown of complex organic matter and solubilization of solids. In this study, thermochemical pretreatment of thickened waste activated sludge using high temperature (>170 °C) was investigated to understand the impact of the pretreatment on the volatile fatty acids (VFA) production and its fractions during the fermentation process. Furthermore, the influence the thermochemical pretreatment on sludge disintegration and methane recovery was investigated. A range of acidic and alkaline conditions over the pH range of 4.5-10 was examined. Sludge (pH adjusted) was exposed to hydrothermal pretreatment (HTP) at a temperature of 170 °C for 30 min. Pretreated samples were then subjected to batch fermentation and methane potential tests which revealed that acidic and alkaline conditions resulted in increased sludge solubilization during HTP. Acidic conditions were associated with a higher VFA production yield of up to 185 mg chemical oxygen demand/g total chemical oxygen demand. Alkaline conditions led to a higher methane production yield where the maximum yield (276 mL CH 4 /g total chemical oxygen demand added ) was found to occur at pH 10. Therefore, alkaline sludge used for fermentation has shown technical and economic feasibility for sludge carbon recovery.

For proper treatment, recycling, or disposal of the pulp and paper mill secondary sludge qualitative and quantitative determination of its characteristics are necessary. Chemical extraction, quantitative characterization, and spectroscopic experiments have been performed to determine the molecular composition and chemical functionality of a pulp and paper mill secondary sludge. In order to extract the low-molecular-weight substances, soxhlet extraction with polar and non-polar solvents was performed where most of the target substances (17±1.3%.) were extracted after 2 hours. Over time, this extraction followed a first-order kinetics. Fiber analyses have shown 12±3% lignin, 28±3% cellulose, and 12±4% hemicelluloses content. The ash content was about 17±0.5%. In this work, 7 and 16% intra- and extracellular polymeric substances, respectively, were extracted from the secondary sludge. EPS and mixture of intra- and extracellular biopolymers have shown similar chemical functionalities. These analyses confirmed that the paper secondary sludge consisted mainly of wood fiber, i.e. lignocellulosic substances, along with proteins and polysaccharides originated from microorganisms.

The effect of limiting P in activated sludge was investigated in laboratory scale sequencing batch reactors (SBRs) fed effluent from a container board mill. Floc characterization included measurement of hydrophobicity, surface charge, and analysis of extracellular polymeric substances (EPS). Reactor performance was assessed by monitoring COD and inorganic P removal, MLSS, and sludge settleability (SVI and batch settling flux) over a period of eight months. Control reactors (BOD:N:P of 100:5:1) were compared to reactors run under P-limited conditions (100:5:0.3; 100:5:0.1). Reactor performance at lower temperatures (14 degrees C; control = 26 degrees C) was also studied to assess the impact of P-limitation. Changes in floc structure and the composition of EPS occurred within 1 to 3 days following a reduction in P levels. There was an insignificant increase in SVI; however, gravitational settling velocity and batch settling flux values for low P floc were consistently higher than for floc generated under control conditions. Lower temperatures (14 degrees C) resulted in a deterioration in floc settling properties at a BOD:N:P of 100:5:1. This impact on settling was significantly reduced at a BOD:P of 100:0.1. Reducing P concentrations in the wastewater treatment system has the potential to improve sludge settleability and reduce final P discharges.

The effect of limiting phosphorus (P) in activated sludge was investigated in laboratory-scale sequencing batch reactors (SBRs). Correlative microscopy revealed that P-limitation (COD:N:P = 100:5:0.05) leads to morphological changes in floc structure and the composition of extracellular polymeric substances (EPS). This was found to be accompanied by expression of quorum-sensing in an acyl homoserine lactone bioassay. Differential gene expression in relation to P-limitation was examined in a global profile using the Affymetrix Escherichia coli antisense genomic microarray. Three separate experiments were conducted where the impact of P-limitation was examined under batch conditions and in SBRs at stable operating conditions and within 3-7 days following a down-shift in P. Significant changes in open reading frames (ORF) and intergenic regions based on the E. coli microarray were observed. Several genes associated with cell structure, including slt, wbbH, fimH, amB, rfaJ and slp were found to be expressed. Quorum regulated genes were also found to be expressed including psiF which is known to be induced by P-starvation (92% confidence level; 1.45 log ratio).

Correlative microscopy was applied to study the influence of solids retention time on activated sludge floc structure. Conventional optical microscopy revealed flocs at lower SRTs (4 and 9 days) to be irregular in shape while flocs at higher SRTs (16 and 20 days) had a more spherical and compact structure. Flocs were examined by environmental scanning electron microscopy (ESEM) and by transmission electron microscopy (TEM) coupled with energy-dispersive spectroscopy (EDS). Distinctive differences in floc structure and the arrangement of EPS were revealed. Flocs from higher SRTs were less hydrated and were found to possess a dense EPS layer that covers much of the surface. Extracellular osmiophilic granules present in these flocs indicate that the cells at the higher SRT may produce more lipid-like material. This EPS layer appears to decrease the floc surface roughness and protects the interior cells from disruption by changes in the external environment. Sludge flocs at higher SRTs were found to be physically more stable than those at lower SRTs.