Search

Journal of physics / Conference series 1643, 012181 (2020). doi:10.1088/1742-6596/1643/1/012181, Published by IOP Publ., Bristol

Synopsis In order to study ultracold gases by photoionization within a Reaction Microscope (ReMi), we investigate a new magneto-optical trap (MOT) configuration for cooling and trapping the atoms. Here we present the simulation results. In comparison with the conventional MOT, the new MOT has four laser beam axes. Two radial laser beam axes along x and y directions and two laser beam axes inclined ± 450 to the MOT/Feshbach coil axis (z axis).

Synopsis We report on performing high resolution recoil ion momentum spectroscopy in a reaction microscope (ReMi) on a target of dipole-force trapped cold 6Li atoms in a non-interacting |1〉-|2〉 spin mixture and coincident detection of recoil ions and photoelectrons. Photo-ionization occurs from the electronic ground state of the 6Li atoms and IR photons significantly contribute to the ion yield via 3-photon resonances. High resolution time-of-flight spectra are obtained by modulating the trap depth synced with the arrival of the fs laser pulses.

An experiment utilizing a double fragmentation reaction was performed to study isobaric analogue states in A similar to 50 nuclei approaching the proton drip-line. gamma-ray spectroscopy will be used to identify excited states in the neutron-deficient nuclei produced in the second fragmentation reaction. Excited state level schemes will be obtained, through comparison with states in their well-known mirror partners, along with information on Coulomb effects through measurements of the Coulomb energy differences between isobaric analogue excited states. The validity of isospin symmetry for nuclei approaching the proton drip-line can also be investigated and the information gained will aid in testing and improving fp shell model calculations. The analysis of the collected data is at a preliminary stage and current status of this work is reported.

Time-of-flight (ToF) performances of large area diamond detectors based on polycrystalline samples of dimensions 20 mm × 20 mm and thickness of 0.3 mm are presented. The devices that feature segmented Cr/Au electrodes in a sandwich configuration were irradiated with a heavy ions 197Au beam of 1 GeV u−1 showing, when mounted with a separation distance of 2 cm, a ToF resolution of 37.5 ps averaged on 16 strip pairs. When ToF measurements were performed over a particle path of 30 m, a resolution σ of 45 ps was achieved. The detectors were mounted on high-vacuum compatible printed circuit boards (PCBs) with integrated processing electronics. This is the first time that ToF measurements have been performed using integrated electronics with such a large separation distance between the diamond detectors.

6th Nuclear Physics in Astrophysics Conference (NPA), Lisbon, Portugal, 19 May 2013 - 24 May 2013; Journal of physics / Conference Series 665, 012034 (2016). doi:10.1088/1742-6596/665/1/012034, Published by IOP Publ., Bristol

The Data Acquisition Backbone Core (DABC) is a software framework for distributed data acquisition. In 2013 Version 2 of DABC has been released with several improvements. For monitoring and control, an HTTP web server and a proprietary command channel socket have been provided. Web browser GUIs have been implemented for configuration and control of DABC and MBS DAQ nodes via such HTTP server. Several specific plug-ins, for example interfacing PEXOR/KINPEX optical readout PCIe boards, or HADES trbnet input and hld file output, have been further developed. In 2014, DABC v2 was applied for production data taking of the HADES collaboration's pion beam time at GSI. It fully replaced the functionality of the previous event builder software and added new features concerning online monitoring.

The future x-ray spectroscopy and polarimetry experiment program of the SPARC collaboration at GSI and FAIR relies strongly on the availability of two-dimensional position-sensitive, energy- and time-dispersive thick semiconductor detector systems, including the appropriate signal processing electronics. To meet these demands, the development of a compact and scalable data acquisition system that has higher rate acceptance compared to commercial VME electronics by employing digital pulse processing electronics was started.

In this work, the digital readout of semiconductor detectors in combination with digital filters was investigated. Both non-segmented high-purity germanium and segmented planar lithium-drifted silicon detectors were used. In each case, photons from a stationary americium (241Am) gamma source were detected. The resulting preamplifier output pulses were digitized at a fixed sampling frequency and stored entirely. Digital filters were applied to the stored waveforms to extract time and energy information. The performance of different digital filters was compared. The optimum energy resolution obtained was comparable with the value resulting from an analogue readout system based on standard nuclear instrumentation module and versatile module Europe bus electronics.

The Compressed Baryonic Matter (CBM) experiment is intended to run at the FAIR facility that is currently being built at GSI in Darmstadt, Germany. For testing of future CBM detector and read-out electronics prototypes, several test beam campaigns have been performed at different locations, such as GSI, COSY, and CERN PS. The DAQ software has to treat various data inputs: standard VME modules on the MBS system, and different kinds of FPGA boards, read via USB, Ethernet, or optical links. The Data Acquisition Backbone Core framework (DABC) is able to combine such different data sources with event-builder processes running on regular Linux PCs. DABC can also retrieve the instrumental set-up data from EPICS slow control systems and insert it into the event data stream for later analysis. Vice versa, the DIM based DABC control protocol has been integrated to the general CBM EPICS IOC by means of an EPICS-DIM interface. Hence the DAQ can be monitored and steered with a CSS based operator GUI. The CBM online monitoring analysis is based on the GSI Go4 framework which can directly connect to DABC online data via sockets, or process stored data from list-mode files. A Go4 sub-framework has been implemented to provide possibility of parallel development of analysis code for different sub-detectors groups. This allows divide the Go4 components up into independent software packages that can run either standalone, or together at the beam-time in a full set-up.

A 16-channel Time-to-Digital Converter (TDC) was implemented in a general purpose Field-Programmable Gate Array (FPGA). The fine time calculations are achieved by using the dedicated carry-chain lines. The coarse counter defines the coarse time stamp. In order to overcome the negative effects of temperature and power supply dependency bin-by-bin calibration is applied. The time interval measurements are done using 2 channels. The time resolution of channels are calculated for 1 clock cycle and a minimum of 10.3 ps RMS on two channels, yielding 7.3 ps RMS (10.3 ps/√2) on a single channel is achieved.

Neutron-rich nuclei beyond N = 126 in the lead region were populated by fragmenting a 238U beam at 1 GeV A on a Be target and then separated by the Fragment Separator (FRS) at GSI. Their isomeric decays were observed, enabling study of the shell structure of neutron-rich nuclei around the Z=82 shell closure. Some preliminary results are reported in this paper.

The RISING setup at the GSI-FRS facility was used to investigate the isomer and beta decays in N~Z~50 Cd, Ag and Pd isotopes. A preliminary analysis of the data has revealed new results on the Tz=1, 94Pd, 96Ag and 98Cd isotopes. In 94Pd a new high-spin isomer was observed, whilst in 96Ag 3 new isomeric states were identified, including core-excited states. In 98Cd a new high-energy isomeric γ-ray transition is observed, thus enabling us to confirm the previous spin assignment for the core-excited 12+ isomer.

Following the fragmentation of a 550 MeV u(-1)primary beam of Ni-58, time-and energy-correlated gamma decays from isomeric states in neutron-deficient nuclei in the 1f(7/2) shell have been identified using the GSI fragment separator in combination with the RISING Ge-detector array. The results on isomers in the mirror pairs Ti-43(22)21-Sc-43(21)22 (I-pi = 3/2(+) and 19/2(-)), Cr-45(24)21-Sc-45(21)24 (I-pi = 3/2(+)) and V-45(23)22-Ti-45(22)23 (I-pi = 3/2(-)) are discussed in the framework of large scale pf and sdpf shell-model calculations, the former in conjunction with isospin symmetry breaking effects with emphasis on effective charges.

We report on g-factor measurements of the 19/2+ T1/2=4.5(3) μs isomer in 127Sn and the 10+ T1/2=2.69(23) μs isomer in 128Sn. These isomers were produced and spin-aligned in relativistic heavy-ion fragmentation at GSI and were selected and separated by the GSI fragment separator (FRS). The γ-rays of the isomeric decay were detected by the RISING γ-ray spectrometer. The method of time-differential perturbed angular distributions was utilized. The measured g-factors, g(19/2+; 127Sn)=− 0.17(2) and g(10+; 128Sn)=− 0.20(4), are compared with shell model calculations. The measured g-factors confirm the predominantly νh11/2− 2 and ν(s1/2− 1h11/2−2) character of the 10+ and 19/2− isomers in 128Sn and 127Sn, respectively. The results demonstrate the feasibility of the method for similar measurements in exotic neutron-rich nuclei.

The Data Acquisition Backbone Core (DABC) is a general purpose software framework designed for the implementation of a wide-range of data acquisition systems – from various small detector test beds to high performance systems. DABC consists of a compact data-flow kernel and a number of plug-ins for various functional components like data inputs, device drivers, user functional modules and applications. DABC provides configurable components for implementing event building over fast networks like InfiniBand or Gigabit Ethernet. A generic Java GUI provides the dynamic control and visualization of control parameters and commands, provided by DIM servers. A first set of application plug-ins has been implemented to use DABC as event builder for the front-end components of the GSI standard DAQ system MBS (Multi Branch System). Another application covers the connection to DAQ readout chains from detector front-end boards (N-XYTER) linked to read-out controller boards (ROC) over UDP into DABC for event building, archiving and data serving. This was applied for data taking in the September 2008 test beamtime for the CBM experiment at GSI. DABC version 1.0 is released and available from the website.

The appearance of the pygmy-dipole-resonance is a recently observed phenomenon that can be related to neutron-matter properties. Its study can be a tool to determine the nuclear symmetry-energy parameters and thus can contribute constraining neutron star models. We present the ( γ,n ) cross sections for different Ni isotopes obtained from a measurement in inverse kinematics at about 500 MeV/u in the LAND reaction setup at GSI. The question of the disentanglement of the Coulomb and nuclear contributions is addressed.

In 98Cd a new high-energy isomeric γ-ray transition was identified, which confirms previous spin-parity assignments and enables for the first time the measurement of the E2 and E4 strength for the two decay branches of the isomer. Preliminary results on the 98Cd high-excitation level scheme are presented. A comparison to shell-model calculations as well as implications for the nuclear structure around 100Sn are discussed.