Search

Objective: Implantable electrodes, such as electrocorticography (ECoG) grids, are used to record brain activity in applications like brain computer interfaces. To improve the spatial sensitivity of ECoG grid recordings, electrode properties need to be better understood. Therefore, the goal of this study is to analyze the importance of including electrodes explicitly in volume conduction calculations., Approach: We investigated the influence of ECoG electrode properties on potentials in three geometries with three different electrode models. We performed our simulations with FEMfuns, a volume conduction modeling software toolbox based on the finite element method., Main Results: The presence of the electrode alters the potential distribution by an amount that depends on its surface impedance, its distance from the source and the strength of the source. Our modeling results show that when ECoG electrodes are near the sources the potentials in the underlying tissue are more uniform than without electrodes. We show that the recorded potential can change up to a factor of 3, if no extended electrode model is used. In conclusion, when the distance between an electrode and the source is equal to or smaller than the size of the electrode, electrode effects cannot be disregarded. Furthermore, the potential distribution of the tissue under the electrode is affected up to depths equal to the radius of the electrode., Significance: This paper shows the importance of explicitly including electrode properties in volume conduction models for accurately interpreting ECoG measurements.

Objective: We investigate volume conduction effects in transcranial direct current stimulation (tDCS) and present a guideline for efficient and yet accurate volume conductor modeling in tDCS using our newly-developed finite element (FE) approach., Approach: We developed a new, accurate and fast isoparametric FE approach for high-resolution geometry-adapted hexahedral meshes and tissue anisotropy. To attain a deeper insight into tDCS, we performed computer simulations, starting with a homogenized three-compartment head model and extending this step by step to a six-compartment anisotropic model., Main Results: We are able to demonstrate important tDCS effects. First, we find channeling effects of the skin, the skull spongiosa and the cerebrospinal fluid compartments. Second, current vectors tend to be oriented towards the closest higher conducting region. Third, anisotropic WM conductivity causes current flow in directions more parallel to the WM fiber tracts. Fourth, the highest cortical current magnitudes are not only found close to the stimulation sites. Fifth, the median brain current density decreases with increasing distance from the electrodes., Significance: Our results allow us to formulate a guideline for volume conductor modeling in tDCS. We recommend to accurately model the major tissues between the stimulating electrodes and the target areas, while for efficient yet accurate modeling, an exact representation of other tissues is less important. Because for the low-frequency regime in electrophysiology the quasi-static approach is justified, our results should also be valid for at least low-frequency (e.g., below 100 Hz) transcranial alternating current stimulation.