Search

This study presents design, analysis and experiment of a miniaturized rotary generator in size of 10 times 10 times 2 mm3 and its compact energy harvest circuit chip. The designed generator consists of patterned planar copper coils and a multipolar hard magnet ring made of NdFeB. To perform modeling, a harmonic-like magnetic field model along the circumferential path of each magnetic pole is assumed with the assistance from measured peak magnetic flux densities. This is followed by the application of Faraday's law to predict generated electromotive forces (EMFs) in terms of the relative rotational speed between the magnet ring and coils. The genetic algorithm (GA) is next applied to optimize the critical dimensions of the miniaturized generator. The theoretical model of this power microgenerator is evaluated and compared with experimental results, and it is found that the analytical simulation shows a good agreement with the experimental results. The optimized generator offers 4.5 V and 7.23 mW in root mean square (rms) at 10 000 r/min. With microgenerator successfully fabricated, a novel energy harvest circuit employing Dickson charge pump is designed and fabricated via the 0.35-mum process offered by National Chip Implementation Center (CIC) of Taiwan. This charge pump circuit owns the merit of almost-zero thresholds of employed metal-oxide-semiconductor (MOS) transistors, enabling the conversion of low-power alternating current (ac) signals by the microgenerator to direct current (dc) ones.

Recent design trends for modern mobile phones are evolving to be miniaturized and versatile sounds in quality. To these ends, a microspeaker with a corrugated diaphragm is employed to broaden the sound frequency range. Due to the fact that diaphragm corrugation and air closures were not considered in any past studies, this study presents comprehensive modeling with the consideration of diaphragm corrugations and air closures. It starts with the modeling on the subsystems of the voice coil motor (VCM) in the speaker. The magnetic field of the VCM is modeled by one set of finite elements, while the corrugated diaphragm is modeled by another set of finite elements. In addition, the air closures above or below the diaphragm are modeled by the third group of finite elements based on basic acoustics. Simulations are conducted with and without air closures. It is found that: 1) the speaker with 45deg corrugation exhibits overall higher (better) sound pressure levels (SPLs), while 2) the 75deg corrugation leads to unsatisfied, low SPLs below 1 kHz and two undesired antiresonances at higher frequencies. The theoretical findings are successfully validated by experiments