Search

Active prosthetic and orthotic devices have the potential to increase quality of life for individuals with impaired mobility. However, more research into human-like control methods is needed to create seamless interaction between device and user. In forward simulations the reflex-based neuromuscular model (RNM) by Song and Geyer shows promising similarities with real human gait in unperturbed conditions. The goal of this work was to validate and, if needed, extend the RNM to reproduce human kinematics and kinetics during walking in unperturbed and perturbed conditions. The RNM was optimized to reproduce joint torque, calculated with inverse dynamics, from kinematic and force data of unperturbed and perturbed treadmill walking of able-bodied human subjects. Torques generated by the RNM matched closely with torques found from inverse dynamics analysis on human data for unperturbed walking. However, for perturbed walking the modulation of the ankle torque in the RNM was opposite to the modulation observed in humans. Therefore, the RNM was extended with a control module that activates and inhibits muscles around the ankle of the stance leg, based on changes in whole body center of mass velocity. The added module improves the ability of the RNM to replicate human ankle torque response in response to perturbations. This reflex-based neuromuscular model with whole body center of mass velocity feedback can reproduce gait kinetics of unperturbed and perturbed gait, and as such holds promise as a basis for advanced controllers of prosthetic and orthotic devices. [ABSTRACT FROM AUTHOR]

In this paper, we present the design, control, and preliminary evaluation of the Symbitron exoskeleton, a lower limb modular exoskeleton developed for people with a spinal cord injury. The mechanical and electrical configuration and the controller can be personalized to accommodate differences in impairments among individuals with spinal cord injuries (SCI). In hardware, this personalization is accomplished by a modular approach that allows the reconfiguration of a lower-limb exoskeleton with ultimately eight powered series actuated (SEA) joints and high fidelity torque control. For SCI individuals with an incomplete lesion and sufficient hip control, we applied a trajectory-free neuromuscular control (NMC) strategy and used the exoskeleton in the ankle-knee configuration. For complete SCI individuals, we used a combination of a NMC and an impedance based trajectory tracking strategy with the exoskeleton in the ankle-knee-hip configuration. Results of a preliminary evaluation of the developed hardware and software showed that SCI individuals with an incomplete lesion could naturally vary their walking speed and step length and walked faster compared to walking without the device. SCI individuals with a complete lesion, who could not walk without support, were able to walk with the device and with the support of crutches that included a push-button for step initiation Our results demonstrate that an exoskeleton with modular hardware and control allows SCI individuals with limited or no lower limb function to receive tailored support and regain mobility. [ABSTRACT FROM AUTHOR]

Human-like balance controllers are desired for wearable exoskeletons in order to enhance human-robot interaction. Momentum-based controllers (MBC) have been successfully applied in bipeds, however, it is unknown to what degree they are able to mimic human balance responses. In this paper, we investigated the ability of an MBC to generate human-like balance recovery strategies during stance, and compared the results to those obtained with a linear full-state feedback (FSF) law. We used experimental data consisting of balance recovery responses of nine healthy subjects to anteroposterior platform translations of three different amplitudes. The MBC was not able to mimic the combination of trunk, thigh and shank angle trajectories that humans generated to recover from a perturbation. Compared to the FSF, the MBC was better at tracking thigh angles and worse at tracking trunk angles, whereas both controllers performed similarly in tracking shank angles. Although the MBC predicted stable balance responses, the human-likeness of the simulated responses generally decreased with an increased perturbation magnitude. Specifically, the shifts from ankle to hip strategy generated by the MBC were not similar to the ones observed in the human data. Although the MBC was not superior to the FSF in predicting human-like balance, we consider the MBC to be more suitable for implementation in exoskeletons, because of its ability to handle constraints (e.g. ankle torque limits). Additionally, more research into the control of angular momentum and the implementation of constraints could eventually result in the generation of more human-like balance recovery strategies by the MBC. [ABSTRACT FROM AUTHOR]

Powered exoskeletons are among the emerging technologies claiming to assist functional ambulation. The potential to adapt robotic assistance based on specific motor abilities of incomplete spinal cord injury (iSCI) subjects, is crucial to optimize Human-Robot Interaction (HRI). Achilles, an autonomous wearable robot able to assist ankle during walking, was developed for iSCI subjects and utilizes a NeuroMuscular Controller (NMC). NMC can be used to adapt robotic assistance based on specific residual functional abilities of subjects. The main aim of this pilot study was to analyze the effects of the NMC-controlled Achilles, used as an assistive device, on chronic iSCI participants’ performance, by assessing gait speed during 10-session training of robot-aided walking. Secondary aims were to assess training impact on participants’ motion, clinical and functional features and to evaluate subjective perspective in terms of attitude towards technology, workload, usability and satisfaction. Results showed that 5 training sessions were necessary to significantly improve robot-aided gait speed on short paths and consequently to optimize HRI. Moreover, the training allowed participants who initially were not able to walk for 6 minutes, to improve gait endurance during Achilles-aided walking and to reduce perceived fatigue. Improvements were obtained also in gait speed during free walking, thus suggesting a potential rehabilitative impact, even if Achilles-aided walking was not faster than free walking. Participants’ subjective evaluations indicated a positive experience. [ABSTRACT FROM AUTHOR]

Electrical stimulation of arm and hand muscles can be a functional tool for patients with motor dysfunction. Sufficient stimulation of finger and thumb musculature can support natural grasping function. Yet it remains unclear how different grasping movements can be selectively supported by electrical stimulation. The goal of this study is to determine to what extent activation of individual fingers is possible with surface electrical stimulation for the purpose of rehabilitation following stroke. The extensor digitorum communis (EDC) muscle, flexor pollicis longus (FPL) muscle, and the thenar muscle group, all involved in grasp and release, were selected for stimulation. The evoked forces in individual fingers were measured. Stimulation thresholds and selective ranges were determined for each subject. Electrode locations where the highest selective range occurred were compared between subjects and influences of different isometric wrist positions were assessed. In all subjects selective stimulation of middle finger extension and thumb flexion was possible. In addition, selective stimulation of index and ring finger extension was possible in most cases. In nine out of the ten EDC subjects we were able to stimulate three or all four fingers selectively. However, large variability in electrode locations for high selectivity was observed between the subjects. Within the designs of grasping prostheses and grasping rehabilitation devices, the variability of electrode locations should be taken into account. The results of our study facilitate the optimization of such designs and favour a design which allows individualized stimulation locations. [ABSTRACT FROM AUTHOR]

The ankles play an important role in human balance. In most studies investigating balance control the contribution of the left and right leg is not separated. However, in certain pathologies such as stroke and Parkinson's disease, balance control can be asymmetric. Here, a bilateral ankle perturbator (BAP) is presented, which applies support surface rotations to both ankles independently. The device consists of two small foot-size support surfaces, which are independently actuated. The BAP device can operate in either angle or torque control mode. The device is able to apply support surface rotations up to 8.6° with a bandwidth of 42 Hz. Additionally the platforms can be replaced by 6-DoF force plates to measure the center of pressure underneath each foot. With the optional force plates the bandwidth decreases to 16 Hz as a result of the additional weight. Two possible applications of the device to investigate human balance control are demonstrated: ankle stiffness by applying minimum jerk profiles and sensory reweighting of the proprioceptive information. In conclusion, we developed a bilateral ankle perturbator which is able to apply support surface rotations to both ankles independently. The major application of the device will be to investigate the contribution of both ankles to human balance control, and the interactions in balance control between both legs. [ABSTRACT FROM AUTHOR]