Search

A cascode configuration with inverse-mode (IM) common-emitter silicon-germanium (SiGe) heterojunction bipolar transistors (HBTs) is proposed for the mitigation of single-event transients (SETs) in low-noise amplifiers (LNAs). Conventionally, despite their SET-mitigation capability, IM SiGe HBTs have been considered to be unsuitable for active gain stages due to severe degradation in RF performance. However, with the benefits of aggressive technology scaling, the high frequency performance of IM SiGe HBTs has been significantly improved, thereby enabling them to be utilized in active gain stages with acceptable RF performance. The cascode with IM common-emitter and common-base SiGe HBTs is used for a 2.4 GHz prototype LNA and it achieves adequate RF gain (10 dB) and noise figure (1.9 dB). With regard to SET mitigation, a through-wafer two-photon absorption pulsed-laser experiment is conducted to test the efficacy of this radiation-hardening approach in an advanced 90 nm SiGe BiCMOS platform. The proposed IM-SiGe-HBT-based LNA exhibits 85% reduction in transient peaks compared to the conventional forward-mode cascode LNA. [ABSTRACT FROM PUBLISHER]

The capability of inverse-mode (IM) silicon- germanium (SiGe) heterojunction bipolar transistors (HBTs) for the mitigation of single-event transients (SETs) under large-signal operation was investigated in an RF down-conversion single- balanced mixer using a through-wafer, two-photon absorption pulsed-laser beam experiment and TCAD heavy-ion simulations. The IM SiGe HBTs replace conventional forward-mode (FM) SiGe HBTs in the differential pair, which provides full current steering for frequency mixing operation. Under steady-state conditions, the IM SiGe HBT differential pair exhibits smaller transient peaks with shorter durations compared to the FM SiGe HBTs. In addition, under the injection of a local oscillator (LO) signal with large swing, the IM SiGe HBTs show faster recovery (50% reduction in the best case) from the impact of SETs. In the frequency domain, it is observed that IM SiGe HBTs produce less distortion at the output for an intermediate frequency below 1 GHz. Based on the performance comparison between FM and IM SiGe HBT down-conversion mixers, system design guidelines to compensate the noise figure degradation associated with using IM SiGe HBTs are discussed. [ABSTRACT FROM AUTHOR]

Single-event transient (SET)-hardened SiGe HBT RF single-pole single-throw (SPST) switches were designed and fabricated for the first time. TCAD-based heavy-ion simulations and two-photon absorption (TPA) laser-induced beam experiments were used to optimize the switch core configuration for SET mitigation. Among different configurations, the reverse-connected series and shunt device core, where both emitter terminals are connected to the output, exhibits the smallest transient peaks and shortest durations at the output terminal of the switch. Based on this finding, the design considerations for maximizing the RF performance of SiGe HBT SPST RF switches are discussed. In addition, a comparison of the SET response and RF performance of CMOS (nFET) SPST and SiGe HBT SPST switches provides additional information on the trade-offs in the SET mitigation strategy and potential RF capabilities. [ABSTRACT FROM PUBLISHER]

A SiGe RF low-noise amplifier (LNA) with built-in tolerance to single-event transients is proposed. The LNA utilizes an inverse-mode SiGe HBT for the common-base transistor in a cascode core. This new cascode configuration exhibits reduced transient peaks and shorter transient durations compared to the conventional cascode one. The improved SET response was verified with through-wafer two-photon absorption pulsed-laser experiments and supported via mixed-mode TCAD simulations. In addition, analysis of the RF performance and the reliability issues associated with the inverse-mode operation further suggests this new cascode structure can be a strong contender for space-based applications. The LNA with the inverse-mode-based cascode core was fabricated in a 130 nm SiGe BiCMOS platform and has similar RF performance to the conventional schematic-based LNA, further validating the proposed approach. [ABSTRACT FROM PUBLISHER]

Shapes of single event transients (SETs) in a linear bipolar circuit (LM124) change with exposure to total ionizing dose (TID) radiation. SETs shape changes are a direct consequence of TID-induced degradation of bipolar transistor gain. A reduction in transistor gain causes a reduction in the drive current of the current sources in the circuit, and it is the lower drive current that most affects the shapes of large amplitude SETs. [ABSTRACT FROM PUBLISHER]