Search

This paper focuses on the detection, from a stack of repeated-pass interferometric synthetic aperture radar (SAR) images, of such changes causing a target to completely lose the correlation between one epoch and another. This can be the consequence of human activities, such as construction, destruction, and agricultural activities, and also be the consequence of hazards, such as earthquake, landslides, or flooding, to buildings or terrains. The millimetric sensitivity of SAR makes it valuable for detecting such changes. This paper approaches two coherent change detection methods: a space coherent, time incoherent one and a full space and time coherent one, both based on the generalized likelihood ratiob (LR) test. A preliminary validation of the method is provided by processing two Sentinel-1 data stacks of 2016 Central Italy earthquake and by comparing the results with the map of damaged buildings in Amatrice and Accumoli made by Copernicus Emergency Management Service. [ABSTRACT FROM AUTHOR]

Continuity of the European Remote Sensing Satellite Synthetic Aperture Radar (ERS SAR) archive by means of Envisat Advanced SAR (ASAR) data acquired from March 2002 has introduced the problem of the coherent combination of images coming from sensors with slightly different frequencies. The spectral shift principle states that in case of extended distributed targets, the frequency shift is equivalent to a change of looking angle. In this paper, the same principle is exploited to analyze the behavior of permanent scatterers (PSs) with an extension that is smaller than the ground resolution cell. The conditions under which the PSs identified by ERS can be continued by Envisat are then theoretically determined and experimentally validated. Moreover, this analysis shows that acquisitions characterized by different frequencies can be used to identify the slant-range position of scatterers with high subcell accuracy (tens of centimeters). From the processing side, a very precise images coregistration step is required to get the results described in this paper. [ABSTRACT FROM AUTHOR]

The alpine village of Lamosano, Belluno, Italy, located near a wide and active landslide, has been seriously threatened by ground instabilities since 1960. In this paper, the results obtained by two different remote-monitoring techniques, synthetic aperature radar interferometry and three-dimensional laser-scanner imaging, planned for Lamosano hazard assessment, are presented. Both techniques compare images taken at different times to map and classify changes that occurred on the imaged scenario. The radar and laser data are gathered at the same dates with about ten-month temporal separation. The displacements measured separately by each of the two techniques highlight a similar sliding motion on the Lamosano village area, providing a good validation to each other and contributing to the definition of the village instability hazard. [ABSTRACT FROM AUTHOR]

This paper presents a differential synthetic aperture radar (SAR) interferometry (DIFSAR) approach for investigating deformation phenomena on full-resolution DIFSAR interferograms. In particular, our algorithm extends the capability of the small-baseline subset (SBAS) technique that relies on small-baseline DIFSAR interferograms only and is mainly focused on investigating large-scale deformations with spatial resolutions of about 100 x 100 m. The proposed technique is implemented by using two different sets of data generated at low (multilook data) and full (single-look data) spatial resolution, respectively. The former is used to identify and estimate, via the conventional SBAS technique, large spatial scale deformation patterns, topographic errors in the available digital elevation model, and possible atmospheric phase artifacts; the latter allows us to detect, on the full-resolution residual phase components, structures highly coherent over time (buildings, rocks, lava, structures, etc.), as well as their height and displacements. In particular, the estimation of the temporal evolution of these local deformations is easily implemented by applying the singular value decomposition technique. The proposed algorithm has been tested with data acquired by the European Remote Sensing satellites relative to the Campania area (Italy) and validated by using geodetic measurements. [ABSTRACT FROM AUTHOR]

This study aims at relating the stickiness parameter ($\tau$) of the dense media radiative transfer theory in quasi-crystalline approximation of Mie scattering of densely packed sticky spheres (DMRT-QMS), to the physical parameters of the layered snowpack. A relationship has been derived to express $\tau $ , which modulates the attractive contact force between ice spheres, as a function of ice volume fraction ($\phi $) and coordination number ($n_{c}$). Since $\tau $ is not a measurable parameter, this is a step forward with respect to what is commonly made in the literature, where $\tau $ is assumed as an arbitrary parameter, generally ranging between 0.1 and 0.3, to fit simulated backscattering data with those measured. As a first validation, DMRT-QMS was integrated with the SNOWPACK model to simulate backscattering at X-band (9.6 GHz) driven by nivo-meteorological data acquired on a test area located in Monti Alti di Ornella, Italy. The simulations were compared with Synthetic Aperture Radar COSMO-SkyMed (CSK) satellite observations. The results show a significant agreement ($R^{2} =0.68$), although for a limited dataset of eight points in a unique winter season. [ABSTRACT FROM AUTHOR]

The application of ground-based radar iterferometry for landslide monitoring is here analyzed: a case study based on an experimental campaign carried out in Italy in the year 2002 is discussed. Interferometric data obtained from coherent synthetic aperture radar (SAR) images acquired by means of C-band ground-based equipment are analyzed. The campaign was aimed at retrieving potential terrain movements of a small landslide observed hundreds of meters away. Critical aspects related to spatial and temporal decorrelation are discussed: the use of optical photogrammetry as a technique for evaluating mechanical stability and correcting geometric distortion is presented. Results also confirmed that the application of ground-based radar interferometry can be attractive and effective if the acquired SAR images maintain an adequate coherence on different dates. [ABSTRACT FROM AUTHOR]