Search

Different from single-bus dc microgrids (MGs), a multibus MG normally bridge multiple dc buses via a complex line impedance network. This intricate configuration together with tickling constant power loads may cause severe stability issues. For system stability improvement, conventional ways include designing small-signal stabilizers in a decentralized way and constructing large-signal stabilizers by solving Lyapunov equation in a central controller. Note that centralized methods may be vulnerable to single point of failures, while decentralized patterns are commended to reinforce MG reliability and scalability. To implement large-signal stabilization in decentralized mechanisms, which has rarely been investigated in the existing literature, a novel uniform nonsmooth control scheme (UNCS) is proposed, in this article. UNCS has the following fourfold advantages. First, UNCS helps to express commonly used dc/dc converters, boost, buck, and buck–boost, into a uniform model. The model substantially facilitates a uniform stabilizer design that accommodates the preceding three converters despite their differences in topology. Second, UNCS assigns each converter based distributed generator (DG) with a composite large-signal stabilizer comprising a nonsmooth observer and a nonsmooth controller. The controller neutralizes the disturbances estimated by the observer, and it also rigorously stabilizes the internal states in DG uniform model. Third, the stabilizer also provides an additional control degree of freedom, a finetuning factor, to refine DG dynamic responses to meet high requirements for voltage and power qualities. Fourth, when numerous DGs with the proposed stabilizer congregate to build a multibus MG, the overall system large-signal stabilization is autonomously attained without communication links, which is mathematically justified by Lyapunov stability analyses. As such, DGs are allowed to randomly plug in/out without worrying about impairing system level stability. Simulations help to properly select relevant key parameters. Experiments show that UNCS outperforms the standardly designed PI controls, and it will stabilize the multibus MG in a large operation range. [ABSTRACT FROM AUTHOR]

A virtual synchronous generator (VSG) control based on adaptive virtual inertia is proposed to improve dynamic frequency regulation of microgrid. When the system frequency deviates from the nominal steady-state value, the adaptive inertia control can exhibit a large inertia to slow the dynamic process and, thus, improve frequency nadir. And when the system frequency starts to return, a small inertia is shaped to accelerate system dynamics with a quick transient process. As a result, this flexible inertia property combines the merits of large inertia and small inertia, which contributes to the improvement of dynamic frequency response. The stability of the proposed algorithm is proved by Lyapunov stability theory, and the guidelines on the key control parameters are provided. Finally, both hardware-in-the-loop and experimental results demonstrate the effectiveness of the proposed control algorithm. [ABSTRACT FROM AUTHOR]