Search

This paper presents a uniform control strategy for the bidirectional ac/dc interlinking converter (BIC) in hierarchical controlled hybrid microgrid. The uniform control strategy unifies different control structures for multifunctional BIC in terms of power management, ac and dc voltage support. With the unified control structure, various triggering mechanisms for BIC mode-switch are not compulsory in response to the relevant scenario changes in the power network. Therefore, the negative consequences, such as unsmooth transition and system collapse due to the inaccurate or slower mode switch, can be avoided. Moreover, the uniform control strategy is also applicable for the hierarchical controlled hybrid microgrid, whose control architecture is typically comprised of the centralized and decentralized levels. This enables the communication fault ride-through capability and the impact from the communication failures can thus be mitigated. To sum up the above two features, the proposed control strategy is able to provide a smooth operation for the BIC without control mode switch in the event of unintentional scenario changes in power or communication network. To verify the validity of the proposed uniform control strategy, the controller hardware-in-the-loop experimental results have been provided in this paper. [ABSTRACT FROM PUBLISHER]

Multiple-voltage-region control, in which the bus-voltage range is divided into several regions, is usually implemented for dc microgrid operation in distributed manner. Voltage/power droop relationships are imposed for active power sharing among slack terminals. Conventionally, threshold voltages for voltage region partition are determined with fixed percentage of variation around the nominal value, which may result in unevenness of droop coefficients in different regions. If system droop coefficient is too high, significant bus-voltage step change due to load variation will occur. On the other hand, significant power sharing error among slack terminals will be induced if the droop coefficient is too low. In this paper, a compromised solution with power-capacity-based bus-voltage region partition is proposed to equalize the droop coefficients in different regions. However, the droop coefficients are determined based on the rated power capacity of system units. Bus-voltage discontinuity appears when the power capacity reduces in actual implementation. To eliminate the voltage discontinuity, online droop coefficient tuning according to the real-time power capacity is implemented. Algorithms for local power capacity estimation of solar photovoltaic (PV) and battery energy storage have been proposed. A lab-scale dc microgrid has been developed for verification of the proposed methods. [ABSTRACT FROM AUTHOR]

The penetration level of photovoltaic (PV) keeps increasing in modern distribution networks, which leads to various severe voltage limits violation problems. This article aims to aggregate and utilize the PV inverters for voltage regulation by a fully distributed two-level Volt/VAr control (VVC) scheme. In the lower-level VVC (real-time scale), the rooftop PV inverters are aggregated via consensus algorithms and then governed by droop controllers in medium-voltage networks. The droop controller adjusts the reactive power output of each PV aggregator in real-time from its dispatched value depending on the bus voltage variations. In the upper-level VVC (15-min timescale), the reactive power of PV aggregators is dispatched for power loss minimization, where control signals are set as base values for PV aggregators. This problem is formulated as second-order cone programming and solved by the alternating direction method of multipliers. The simulation results demonstrate the effectiveness of the proposed method in both short-term and long-term scenarios with different system scales. [ABSTRACT FROM AUTHOR]