Search

Summary: With the occurrence of reversible electrochemical reactions, mode switching considerably affects the electric performance of unitized regenerative fuel cells (URFCs) owing to the complicated mass and heat transfer. Although limited researches have been done, no such studies on mass and heat transfer through a three‐dimensional view are envisioned during mode switching. A three‐dimensional full‐cell model was developed and validated to study the dynamic characteristics of a proton exchange membrane‐based URFC during mode switching. Mode switching was performed by changing operation voltage from 0.60 to 1.65 V. Results showed that species and heat transfer affect the electric performance of the cell during mode switching, especially through the third dimensional. Local water starvation occurs on oxygen side catalyst layer and thus results in slight reduction on current density and hydrogen generation. Restricted to heat transfer capacity through ribs, heat transfer process adds total response time in URFCs. Heat flux and surface heat transfer coefficient are forecasted on the hydrogen and oxygen sides. A total time of 4 seconds is essential for URFC reaching a new relative balanced state. [ABSTRACT FROM AUTHOR]

Summary: In this work, a proton exchange membrane unitized regenerative fuel cell with a 25 cm2 active area and a transparent window was designed to study the influence of mode switching from the fuel cell mode to the electrolysis cell mode on the cell voltage and the gas‐liquid two‐phase flow behaviors in the oxygen flow channels. Results indicate that: the growth rate of electrolysis cell voltage before the water pumped to the oxygen flow channels decreases with the increase of the fuel cell current density; while the growth rate of electrolysis cell voltage before the water pumped to the oxygen flow channels increases with the cell temperature; the voltage of electrolysis cell mode before the water pumped to the oxygen flow channels decreases with the increase of water flow rate; the different voltage reduction speeds are attributed to the different water flow rates. The water temperature has an obscure influence on the cell voltage of electrolysis cell mode before the water pumped to the oxygen flow channels. [ABSTRACT FROM AUTHOR]

Summary: Mode switching between fuel cell and water electrolyzer of a unitized regenerative fuel cell alters two‐phase flow dynamics in the channels. To fully understand the mode switching, the observation of two‐phase flow is necessary. In this work, experiments are conducted to investigate the two‐phase flow in the flow field of a unitized regenerative fuel cell during mode switching. A transparent window is assembled at the oxygen side to allow a direct view of the serpentine flow field. The two‐phase flow are captured by a high‐speed camera. Water has a significant effect on the mode switching. The switching from water electrolyzer to fuel cell is difficult because of the flooding problem. High temperature causes insufficient water in water electrolyzer mode without water supply and membrane dehydration in fuel cell mode. The voltage in fuel cell mode decreases more rapidly with fuel cell current density during mode switching. [ABSTRACT FROM AUTHOR]