Search

Background: Stair climbing is a complex and demanding daily activity with increased physical loads. Therefore, analyzing stair climbing abilities is a frequently used diagnostic tool. Leg length inequalities (LLIs) are a common condition in the population, with individual consequences like lower back pain, scoliosis, and osteoarthritis. Despite its high prevalence, the necessary treatment, for mild LLIs, is still controversial. Previously, the focus was to analyze the effects of LLIs during static standing and walking. To create a holistic view on the dynamic effects of LLIs, and since climbing stairs produces a similar biomechanical imbalance as LLIs, the compensation mechanics during stair climbing are of special interest., Research Question: What are the biomechanical compensation mechanisms of (simulated) LLIs during ascending and descending stairs?, Methods: Thirty-five healthy participants were measured with the inertial measurement system MyoMotion during stair climbing with simulated LLIs of 0-3 cm. The maximum estimated lower limb joint angles of the long and short leg were analyzed with statistically repeated measurement models., Results: The long leg showed significantly increased hip and knee flexion, while the short leg showed decreased hip and knee flexion, decreased dorsiflexion, and significantly increased plantarflexion. Different mechanisms were found in the case of 1 cm LLI when compared to greater LLIs. In the former, increased hip and knee flexion in the short leg accompanied by increased dorsiflexion in the long leg was observed. In the latter, the dorsiflexion of the long leg was reduced., Significance: Except for the reduced dorsiflexion of the long leg (LLI >1 cm), during stair climbing compared compensation mechanisms as during walking were presented, with the long leg functionally shortened and the short leg lengthened. Although the feet were already on different levels, during stair climbing with the step-over-step technique, significant compensation mechanisms were found as a consequence of LLIs., (Copyright © 2021 Elsevier B.V. All rights reserved.)

Background: Smartphones have become increasingly more popular and complicated tasks can be performed with these devices. However, the increasing use is associated with shoulder and neck pain, as well as with psychological addiction., Research Question: Do different smartphone tasks lead to changes in spinal posture and pelvic position? Is there a relationship between smartphone addiction and changes in posture?, Methods: A cross-sectional study including 50 participants was performed. Test subjects completed the Smartphone Addiction Scale and the SF-36 health questionnaire. Subjects spinal posture and pelvic position during different smartphone tasks were measured through a surface topography system. The different tasks were: standing in an upright position, simulating a phone call, texting with one or two hands during standing or while walking on a treadmill. Paired T-tests and ANOVA tests were performed to evaluate differences. The Kendall rank test was used to investigate the association between clinical scores and changes in spinal posture., Results: All smartphone tasks lead to a significant increase in thoracic kyphosis and trunk inclination during standing and while walking. A significant increased lumbar lordosis was also found. Texting with one or two hands correlated with increased surface rotation. No associations between smartphone addiction and changes of the spinal posture were reported., Significance: This represents the first surface topography study that investigated the influence of different smartphone tasks on the spinal posture and pelvic position during standing and while walking. With the results of this study we demonstrated that smartphone use leads to significant changes of sagittal and frontal spine parameters. Further research should focus on the evaluation of possible detrimental effects of long-term smartphone use on the spinal posture and on the development of preventive measures., (Copyright © 2021 Elsevier B.V. All rights reserved.)

Background: Surface topography can be used for the evaluation of spinal deformities without any radiation. However, so far this technique is limited to posterior trunk measurements due to the use of a single posterior camera., Research Question: Purpose of this study was to introduce a new multi camera surface topography system and to test its reliability and validity., Methods: The surface topograph uses a two-camera system for imaging and evaluating the subjects front and back simultaneously. Inter- and intra-rater reliability was tested on 40 human subjects by two observers. For validation human, subjects were scanned by MRI and surface-topography. For additional validation we used a phantom with an anthropomorphic body which was scanned by CT and surface topography., Results: Inter- (0.97-0.99) and intra-rater reliability (0.81-0.98) testing revealed good and excellent results in the detection of the body surface structures and measurement of areas and volumes. CT based validation revealed good correspondence between systems in the imaging and evaluation of the phantom model (0.61-10.52 %). Results on validation of human subjects revealed good to moderate results in the detection and measurements of almost all body surface structures (1.36-13.34 %). Only measurements using jugular notch as a reference showed moderate results in validity (0.62-27.5%) testing., Significance: We have introduced a novel and innovative surface topography system that allows for simultaneous anterior and posterior trunk measurements. The results of our reliability and validity tests are satisfactory. However, in particular around the jugular notch region further improvements in the surface topography reconstruction are needed., Competing Interests: Declaration of Competing Interest The „a.p.-scan “was provided by Diers International GmbH, Schlangenbad, Germany. However, this did not influence the work and neutrality of the authors., (Copyright © 2020 Elsevier B.V. All rights reserved.)

Background: Surface-topography has been used for almost two decades in the radiation-free clinical evaluation of spinal posture. So far, it was limited to the analysis of back surface and spine. In order to better understand, diagnose and treat complex spinal pathologies, it is important to measure the whole torso., Research Question: Purpose of this study was to introduce and test an application that allows 360° reconstruction and analysis of the patient's torso., Methods: The application uses the information gathered from eight distinct scans and angles. For validation we used an Alderson phantom as an anthropomorphic body. Defined areas and volumes were measured by CT and surface-topography. Inter- and intra-rater reliability was tested in 35 healthy subjects by two observers., Results: The results revealed good correspondence between systems in the imaging and evaluation of the Alderson model (5.3-0.5%). Inter- (0.9-0.98) and intra-rater reliability (0.8-0.95) testing revealed good and excellent results in the detection of almost all body surface structures and measurement of areas and volumes. Only area and volume measurements using jugular notch as a reference showed partly moderate results in reliability (0.62-0.93) testing., Significance: We were able to introduce a novel 360° torso scan application using surface topography to reconstruct torso measurements. The results of our study showed its high validity and reliability. In the future, this application needs to be tested in patients with spinal pathologies. In summary, this new application may help to better understand, diagnose and treat patients with pathologies of torso and spine., (Copyright © 2019 Elsevier B.V. All rights reserved.)

Background: The purpose of forefoot off-loader shoes (FOS) is to unload the operated region of the foot in order to allow early mobilization and rehabilitation. However, little is known about the actual biomechanical effects of different designs of FOS on gait, pelvis and spine., Research Question: Aim of this study was to analyse and compare the effects of two different designs of forefoot unloader shoes., Methods: Ortho-Wedge (FOS A) and Relief-Dual® (FOS B) were evaluated in this study during standing and while walking. Changes of the pelvic position and spinal posture were measured with a surface topography system and an instrumented treadmill. Gait phases were detected automatically by a built-in pressure plate., Results: Both FOS resulted in a significant increase of pelvic obliquity, pelvic torsion, lateral deviation and surface rotation (p < 0.001) while standing. Between both shoe models, pelvic obliquity and lateral deviation (p < 0.05) were significantly different. During walking, both FOS had a significant effect on spine and pelvis (p < 0.05), however only minor differences were found between the designs. All gait parameters were affected more, wearing FOS A than B. Step length were significantly longer by wearing FOS (p < 0.005). However stance phase raised and swing phase is reduced on the leg wearing FOS A (p < 0.001)., Significance: The study showed that FOS lead to significant changes in pelvic position and spinal posture during standing and while walking. A compensating shoe on the contralateral side is therefore recommend. Gait parameters however were affected more by the traditional FOS A half-shoe. The sole- design and shape of FOS B leads to a more physiological roll-over of the foot., (Copyright © 2019 Elsevier B.V. All rights reserved.)

Background: Leg length inequalities (LLI) are a common problem in medicine. So far, the diagnosis and treatment are performed under static conditions. Surface Topography (ST) is an optical, non-invasive technique that uses the principle of triangulation to measure spinal posture and pelvic position. This technique offers the opportunity to detect and treat LLIs and their effects under dynamic conditions., Research: question The aim of the study is to show that ST can detect simulated LLIs under dynamic conditions and to prove if there are differences between the effects on the human body under static and dynamic conditions., Methods: In the clinical study a total of 30 test subjects were examined with a ST measuring device. LLIs (1 to 4 cm) were simulated using a custom- built sandal and insoles of various thickness. The pelvic obliquity, the surface rotation and lateral deviation of the spine were detected on a treadmill under static and dynamic conditions (3 km/h)., Results: Under static and dynamic conditions LLIs lead to a significant increase of all measured parameters. The pelvic obliquity reaches a significant level of p < 0.0001 under static and p = 0.0001-0.0421 under dynamic conditions. However, for all examined parameters the magnitudes of the parameters under dynamic conditions were smaller than under static conditions., Significance: The study showed that simulated LLIs also have a significant effect on the human pelvis and spine under dynamic conditions, but with a smaller magnitude than under static conditions. The human individuum is a dynamic one. Because of that, for the future it should be of great interest to use dynamic measurements to detect and treat LLIs to provide an over correction of LLIs., (Copyright © 2018 Elsevier B.V. All rights reserved.)