Search

This paper describes the forming characteristics and mechanics of magnetic field–assisted single point incremental forming (M-SPIF) in which an Nd-Fe-B magnet ball tool is placed on top of a piece of sheet metal and is driven by an Nd-Fe-B magnet placed below the workpiece. To gain an understanding of the force mechanics that power M-SPIF, the tool motion and forming force were experimentally analyzed. In M-SPIF, the forming force is applied multi-directionally, and the resultant force direction is nearly colinear with the polarity of the permanent magnet ball tool. This suggests that the forming characteristics in M-SPIF may be controllable by controlling the magnetic polarity of the tool.

Explosion welding (EXW) is a solid-state joining process used to produce lap joints out of metal plates of dissimilar materials. During the process, a controlled explosive detonation results in a pressure wave pushing one of the plates to be welded, called flyer, against the other with high velocity. The high pressure and temperature generated, because of the impact energy decaying into heat, create the conditions for solid bonding phenomenon to take place. Due to the complexity of experimental tests, numerical simulation is considered a fundamental design tool for the process. Different approaches are found in literature to simulate the process. In this paper, a dual step Lagrangian–Eulerian approach is proposed to evaluate the effect of different explosives on the final quality of the weld. The numerical model was developed using the commercial software ABAQUS. A three dissimilar materials joint is considered, made of two outer plates of AA5083 aluminum alloy and A516 steel, respectively, and an intermediate layer made of AA1050 aluminum alloy. The model was first validated by comparing the wavy profile of the intermediate layer after the weld, and then used to evaluate the effect of different explosive by analyzing the distribution of the main process parameters as well as the presence of voids.

In the paper, a numerical and experimental study was carried out to highlight the effect of the distance d between the weld seam and the reinforcement on the residual stress distribution in Friction Stir Welded AA6082-T6 structures. An L-shaped profile was welded to a sheet metal with varying tool rotation and distance d from the weld seam. The Cut Compliance method was used to determine the resulting longitudinal residual stress. A dedicated FE model for FSW was set up, validated and utilized to predict the longitudinal residual stress in the assembled part. The analysis allowed the identification of a few design guidelines in order to reduce the detrimental effects of the residual stresses.