Search

Background For the biomechanical evaluation of cementless stems different sizes of composite femurs have been used in the literature. However, the impact of different specimen sizes on test results is unknown. Methods To determine the potential effect of femur size the biomechanical properties of a conventional stem (CLS Spotorno) were examined in 3 different sizes (small, medium and large composite Sawbones®). Primary stability was tested under physiologically adapted dynamic loading conditions measuring 3-dimensional micromotions. For the small composite femur the dynamic load needed to be adapted since fractures occurred when reaching 1700 N. Additionally, surface strain distribution was recorded before and after implantation to draw conclusions about the tendency for stress shielding. Findings All tested sizes revealed similar micromotions only reaching a significant different level at one measurement point. The highest micromotions were observed at the tip of the stems exceeding the limit for osseous integration of 150 μm. Regarding strain distribution the highest strain reduction after implantation was registered in all sizes at the level of the lesser trochanter. Interpretation Specimen size seems to be a minor influence factor for biomechanical evaluation of cementless stems. However, the small composite femur is less suitable for biomechanical testing since this size failed under physiological adapted loads. For the CLS Spotorno osseous integration is unlikely at the tip of the stem and the tendency for stress shielding is the highest at the level of the lesser trochanter.

Purpose Malposition of implant components in total knee arthroplasty (TKA) has consequences on tibiofemoral kinematics, contact forces and ligament tensions. To evaluate the impact of tibial baseplate malpositioning in the same knee, we conducted a computer simulation. Methods An established weight-bearing finite element model of a fixed bearing TKA was used for the computer simulation. To evaluate the influence of tibial baseplate malposition, calculations were consecutively performed in neutral position, at 3° and 6° of internal and external rotation and at 3 mm and 6 mm of medial and lateral translation. Results The highest effect of malposition was observed for ligament tensions, with a tendency of a greater influence for the 6 mm translation compared to 6° of rotation. Changes in contact forces and tibiofemoral kinematics were according to the alterations of ligament tensions. The highest ligament tension, contact force and femoral roll-back were registered for 6 mm medialization of the tibial baseplate. Discussion Tibial baseplate malposition effects ligament tensions, tibiofemoral contact forces and kinematics and has a risk of unfavorable clinical results due to postoperative pain, reduced range of motion, instability and a higher rate of early loosening. Therefore, surgeons should aim for a neutral position of the tibial baseplate.

Background Cementless hip prostheses with different offsets are frequently used to restore the rotation center of the hip. However, a rising offset is theoretically associated with a potential risk for increased interface stresses and early loosening. Methods To assess this potential risk for cementless stems, the primary stability of the CLS Spotorno stem was examined with respect to three different femoral neck versions (125°, 135° and 145°) measuring 3-dimensional micromotions. For this purpose 18 stems were implanted in composite femurs and tested dynamically using physiological loading conditions considering the necessary adaptation according to the different offsets. Additionally the deformations at the surface of the composite femur were recorded to draw conclusions about the tendency for stress shielding. Findings The micromotions of the different offset versions were not significantly different. The highest values were obtained at the tip of the stems, even exceeding the critical limit for osseous integration of 150 μm. Compared to untreated composite femurs the alteration of the deformations at the surface remained relatively low. A significant difference was only observed in the ventral measurement points. Interpretation According to the measured micromotions no offset version of the CLS Spotorno can be declared as superior. The assumption that the varus version is characterized by extended interface stresses could not be confirmed. Furthermore, it could be demonstrated that according to the principle of proximal load transfer of the CLS Spotorno stem an osseous integration of the distal part cannot be expected and that the risk for stress shielding appears to be relatively low.