Search

Lung cancer is the number one killer among all cancer types. For decades, clinicians have been using conventional chemotherapeutics, but they can't rely on them alone anymore, because they poison bad cells and good cells as well. Researchers exploited nanotechnology as a potential tool to develop a platform for drug delivery to improve therapeutic efficiency. A quality by design synthesis of gefitinib-loaded starch nanoparticles (Gef-StNPs) has emerged as an essential tool to study and optimize the factors included in their synthesis. Therefore, we applied design of experiment (DOE) tools to attain the essential knowledge for the synthesis of high-quality Gef-StNPs that can deliver and concentrate the gefitinib (Gef) at A549 cells, thereby improving therapeutic efficacy and minimizing adverse effects. The in vitro cytotoxicity after exposing the A549 human lung cancer cells to the optimized Gef-StNPs was found to be much higher than that of the pure Gef (IC 50 = 6.037 ± 0.24 and 21.65 ± 0.32 μg/mL, respectively). The optimized Gef-StNPs formula showed superiority over the pure Gef regarding the cellular uptake in A549 human cell line (3.976 ± 0.14 and 1.777 ± 0.1 μg/mL) and apoptotic population (77.14 ± 1.43 and 29.38 ± 1.11 %), respectively. The results elucidate why researchers have a voracious appetite for using natural biopolymers to combat lung cancer and paint an optimistic picture of their potential to be a promising tool in battling lung cancer. [ABSTRACT FROM AUTHOR]

[Display omitted] According to the American College of Cardiology/American Heart Association (ACC/AHA), both aspirin and statin are used in the primary prevention of cardiovascular diseases. Aspirin (ASA) is contraindicated if there is gastrointestinal bleeding because it will exaggerate the condition. In this study, the effect of surfactant; sodium lauryl sulfate (SLS), in enhancing the in vitro dissolution of simvastatin (SIM) and ASA, as well as gastric irritation and upset, was studied. Oral tablets containing both ASA and SIM with and without the SLS were manufactured using the direct compression technique. The prepared tablets were characterized with respect to hardness, friability, uniformity of dosage units, in vitro disintegration, and dissolution. The effect of the addition of SLS in reducing the in vivo irritation and protection of gastric mucosa were also investigated. The results showed that the compressed tablets possessed sufficient hardness, acceptable friability, and are uniform with respect to disintegration, drugs contents, and tablet weight. The results showed that SIM alone exhibited a gastroprotective effect on the induced irritation. In addition, the incorporation of the SLS in the tablets containing SIM and ASA significantly enhanced the dissolution rates of both drugs and significantly decreased the gastric irritation and the ulcer index. The ulcer index of aspirin was decreased from 2.3 for tablets manufactured without SLS to 0.8 for tablets containing SLS. In a conclusion, the addition of pH modifier surfactant; SLS could enhance the dissolution rate of poorly soluble acidic drugs, reduce gastric upset and irritation without any effect on the main characters of the tablets. Moreover, the addition of SLS is very useful in improving the therapeutic activities and reducing the side effects of ASA and SIM for patients who require long-term administration of these drugs. [ABSTRACT FROM AUTHOR]

The delivery of drugs via fast dissolving films is an effective alternative for drugs with low bioavailability when administered by other routes. This is the case of domperidone (DMP) an anti-emetic drug with low water solubility and vulnerable to extensive first-pass effect. To overcome these limitations, in this work, we designed and produced fast dissolving muco-adhesive buccal films of domperidone using varying amount polyvinylpyrrolidone (PVP K-90) using the solvent casting method. Films loaded with more than 10% of drug were not homogenous and opaque as indicated by white patches of drug in the film matrix. Formulation of DMP in the film form resulted in conversion of the drug from crystalline state to the semi-crystalline state as indicated by X-ray powder diffraction analysis. Moreover, about 40% of drug loaded within the films was released during the first five minutes compared to only about only 6.5% of pure drug in drug dissolution assays in vitro. In vivo pharmacokinetics analysis revealed that the DMP-loaded film had higher maximum plasma concentration (C max) and shorter time to reach C max (T max) than a commercially available tablet formulation. In conclusion, the produced DMP buccal film formulation showed high absorption rate, rapid onset of action, and improved bioavailability compared with the conventional tablet. Our findings may support the development of novel dosage forms for the transmucosal delivery of DMP for convenient, rapid, and effective treatment of nausea and vomiting. [ABSTRACT FROM AUTHOR]

Abstract In this study, we aimed to optimize theophylline pellet formulations using a two-factor three-level full-factorial design (32) by monitoring the concentration of two pellet excipients, polyvinyl pyrrolidone K30 (PVP) binder solution (X1) and the hydrophilic excipient mannitol (X2). Their impact on pellet characteristics (responses) were evaluated. Increasing PVP concentration in the binder solution resulted in an increase in the wet mass torque value. The effect of mannitol, however, was antagonistic. Moreover, the pellet particle size was significantly influenced by the level of mannitol, PVP solution, and quadratic effect of mannitol. Mannitol significantly antagonized the pellet particle size. Furthermore, increased mannitol concentrations significantly enhanced drug dissolution rate from the pellets, whereas PVP concentration in the binder solution significantly reduced the drug dissolution rate. In conclusion, wet granulations can be controlled by monitoring the composition of the binder solution and pellet composition. [ABSTRACT FROM AUTHOR]

Abstract Ocular hypertension due to increased intraocular pressure is a major risk factor for the development of glaucoma. Rapid clearance and low ocular bioavailability are drawbacks of conventional ocular treatments. This requires frequent and long-term application of antiglaucoma drugs which in turn cause local side effects and are a major cause of therapeutic failure due to loss of persistence in using glaucoma therapy. In this study, a semisynthetic, biocompatible, oxidized sucrose crosslinker was developed and used in the formulation of chitosan-gelatin hydrogel for the sustained release of timolol to control ocular hypertension. The swelling properties of the hydrogel showed a strong relationship with the oxidized sucrose concentration. Mucoadhesive properties of the hydrogel were studied and the in vitro release profiles demonstrated that crosslinking with oxidized sucrose reduced the release rate of the entrapped timolol. The results of both in vitro and in vivo studies supported that the formulated hydrogel maintained the release and in turn the efficacy of timolol for a longer period of time compared to the conventional eye drops. This is expected to reduce the frequency of drug application onto the eye surface and in turn enhances patients' convenience. In conclusion, the developed formulation represents a promising platform for an effective and compliant treatment of ocular hypertension. [ABSTRACT FROM AUTHOR]

Abstract: Inclusion complex formation between β-cyclodextrin (β-CD) and suitable guest molecules has frequently been exploited to design self-assembled polymer networks. In this paper, we report on hydrogels composed of eight-armed poly(ethylene glycol) (PEG) grafted with β-CD (8armPEG20k-CD), adamantane (8armPEG20k-ad) or cholesterol (8armPEG20k-chol). Mixtures of 8armPEG20k-CD and 8armPEG20k-ad showed viscous behavior (G″ > G′); 8armPEG20k-CD and 8armPEG20k-chol formed elastic hydrogels (G′ > G″). To study the interaction of adamantane and cholesterol grafted PEG with β-CD, linear model compounds (mPEG5k-ad and mPEG5k-chol) were synthesized. Isothermal titration calorimetry (ITC) experiments showed a higher association constant for inclusion complexes formed with mPEG5k-chol (47,000 ± 1650) than for those formed with mPEG5k-ad (30,000 ± 900). Fluorescence spectroscopy and dynamic light scattering (DLS) measurements further showed the ability of mPEG5k-chol to self-assemble into micelles. Self-assembly of 8armPEG20k-chol further increased the strength of the formed hydrogels. Altogether, this study contributes to a better understanding of cyclodextrin based biomaterials. [Copyright &y& Elsevier]

Glaucoma is a chronic eye disease characterized by elevated intraocular pressure (IOP) which causes severe complications to the eyes and may lead to vision loss. The effective treatment of such diseases motivated the search for novel and unique drugs and delivery systems. It has been reported that, nifedipine (NF) is effective in reducing the elevated IOP due to vasodilatation of eye vascular smooth muscles. NF loaded thermo-sensitive in situ gels were prepared by the cold method using poloxamer 407 (P407) and hydroxypropyl methyl cellulose (HPMC) polymers adopting Box-Behnken experimental design. All the prepared formulae were tested for homogeneity, clarity, pH, isotonicity, gelling capacity, rheological behavior, in vitro drug release and were tested in vivo on rabbits. The prepared in situ gels were homogenous, transparent, having a pH ranged from 5 to 5.5 and undergo sol-gel transition within few seconds physiological temperature. The in situ gels showed sustained in vitro release of NF where about 76% of the loaded drug was released over 12 h. NF loaded in situ gels showed a 45.83 ± 2.91% reduction in the IOP, with no sign of toxicity or irritation to the eye in rabbits. The current investigations clarified the efficiency of this novel and unique NF loaded in situ gel for the control of the IOP compared to the conventional ophthalmic dosage forms. [ABSTRACT FROM AUTHOR]