Search

Objective To compare the frequency or spectral components between different regions of the superficial masseter in young natural dentate and total edentulous older adults rehabilitated with removable prostheses and fixed-implant support. A secondary objective was to compare these components between the three groups. Design 21 young natural dentate and 28 edentulous (14 with removable prostheses and 14 with fixed-implant support) were assessed. High-density surface electromyography (sEMG) was recorded in four portions of the superficial masseter during submaximal isometric bites. Spectral components were obtained through a spectral analysis of the sEMG signals. An analysis of mixed models was used to compare the spectral components. Results In all groups, the spectral components of the anterior portion were lower than in the posterior region (p < 0.05). Both edentulous groups showed lower spectral components and median frequency slope than the natural dentate group (p < 0.05). The removable prostheses group showed the greatest differences with natural dentate group. Conclusions There were significant differences in the spectral components recorded in the different regions of the superficial masseter. The lower spectral components and fatigability of older adults rehabilitated with prostheses could be a cause of a greater loss of type II fibers, especially in the removable prostheses group. [ABSTRACT FROM AUTHOR]

It has been identified that the peroneus longus presents a regional activity. Specifically, a greater activation of the anterior and posterior compartments has been observed during eversion, whereas a lower activation of the posterior compartment has been reported during plantarflexion. In addition to myoelectrical amplitude, motor unit recruitment can be inferred indirectly from muscle fiber conduction velocity (MFCV). However, there are few reports of MFCV of the regions that make up a muscle, and even less, MFCV of the peroneus longus compartments. This study aimed to analyze the MFCV of peroneus longus compartments during eversion and plantarflexion. Twenty-one healthy individuals were assessed. High-density surface electromyography was recorded from the peroneus longus during eversion and plantarflexion at 10%, 30%, 50%, and 70% of maximal voluntary isometric contraction. The posterior compartment presented a lower MFCV than the anterior compartment during plantarflexion, and both compartments did not show differences in MFCV during eversion; however, the posterior compartment showed an increase in MFCV during eversion compared to plantarflexion. Differences observed in the MFCV of the peroneus longus compartments could support a regional activation strategy and, to some extent, explain different motor unit recruitment strategies of the peroneus longus during ankle movements. [ABSTRACT FROM AUTHOR]

Background Botulinum toxin (BTX) acts on the neuromuscular junction which can be located by the innervation zone (IZ). Clinically, the motor point (MP) is homologous to the IZ and it is used as the injection site of BTX. Differences in the effectiveness of the application of BTX between MP and IZ locations have been determined. Objective Compare the location of the MP obtained using electrical stimulation and the location of the IZ using a linear surface electrodes array on the biceps brachii muscle. Methods The biceps brachii muscle of twenty men was assessed. The MP was located using the torque measurement generated by electrical stimulation. The IZ was detected using a linear surface electrodes array. Results A difference between the MP and the IZ positions (75.8 vs. 86.5 mm, delta 10.7 mm; p = 0.003, post-hoc power 0.89) was observed. Discussion The magnitude of the difference between the MP and the IZ may be clinically relevant. The IZ location using surface electromyography as a guide to optimize BTX injection is proposed. [ABSTRACT FROM AUTHOR]

Abstract Background The most common surgical approaches in use for total hip arthroplasty are the lateral and posterior. When comparing these approaches in terms of gait biomechanics, studies usually rely on pre-defined discrete variables related to the events of gait cycle. However, this analysis may miss differences in other parts of the movement pattern that are not explored. We applied Statistical Parametric Mapping to compare hip kinematics between patients who underwent arthroplasty using either a lateral or posterior approach, contrasting these results with discrete variable analysis. Methods Twenty-two participants (11 lateral, 11 posterior; age between 50 and 80 years) underwent gait analysis before, 3 weeks and 12 weeks after hip arthroplasty. One-dimensional (e.g. time-varying) trajectories and zero-dimensional (e.g. peak extension) discrete variables were used to assess differences between groups in each plane of hip movement (sagittal, frontal, and transverse). Findings One-dimensional and zero-dimensional analyses found no significant differences between groups. Statistical Parametric Mapping revealed that both groups presented significant changes over time in hip adduction at 11–43% of the gait cycle. Zero-dimensional analysis seems to overstate sagittal plane changes over time since no such changes were found by Statistical Parametric Mapping. Interpretation Our results agreed with previous studies suggesting that surgical approach do not affect hip kinematics at the early post-operative stage after arthroplasty. However, Statistical Parametric Mapping revealed changes in frontal plane kinematics over time that were underestimated by the zero-dimensional variables. These findings suggest hip adduction impairment up to 12 weeks after arthroplasty. Highlights • The effect of hip arthroplasty surgical approach on gait mechanics is unsettled. • We used Statistical Parametric Mapping to explore hip kinematics after arthroplasty. • Lateral and posterior surgical approaches lead to similar hip kinematics. • Results revealed changes over time in hip adduction during weight acceptance. • Traditional analysis of gait parameters may miss/overstate hip kinematic features. [ABSTRACT FROM AUTHOR]