Search

Abstract: This paper proposes a frequency compounding method to reduce speckle interferences, where a concentric annular type high-frequency dual element transducer is used to broaden the bandwidth of an imaging system. In frequency compounding methods, frequency division is carried out to obtain sub-band images containing uncorrelated speckles, which sacrifices axial resolution. Therefore, frequency compounding often deteriorates the target-detecting capability, quantified by the total signal-to-noise ratio (SNR), when the speckle’s SNR (SSNR) is not improved as much as the degraded axial resolution. However, this could be avoided if the effective bandwidth required for frequency compounding is increased. The primary goal of the proposed approach, hence, is to improve SSNR by a factor of two under the condition where axial resolution is degraded by a factor of less than two, which indicates the total SNR improvement to higher than 40% compared to that of an original image. Since the method here employs a dual element transducer operating at 20 and 40MHz, the effective bandwidth necessary for frequency compounding becomes broadened. By dividing each spectrum of RF samples from both elements into two sub-bands, this method eventually enables four sets of the sub-band samples to contain uncorrelated speckles. This causes the axial resolution to be reduced by a factor of as low as 1.85, which means that this method would improve total SNR by at least 47%. An in vitro experiment on an excised pig eye was performed to validate the proposed approach, and the results showed that the SSNR was improved from 2.081±0.365 in the original image to 4.206±0.635 in the final compounding image. [Copyright &y& Elsevier]

• SAF and CFW have been used for enhanced resolution of ultrasound imaging. • We ascertained the effectiveness of SAF and CFW for intravascular ultrasound (IVUS) imaging. • From the results, it was found that SAF is not effective for IVUS imaging. • A focused transducer without SAF and CFW may be the best choice for enhanced resolution. Synthetic aperture focusing (SAF) and coherence factor weighting (CFW) have been used to improve the lateral resolution of ultrasound images. Although the two methods are effective for array-based ultrasound imaging, many researchers have also employed the methods for single-element-based imaging including intravascular ultrasound (IVUS) imaging. For single-element-based imaging, CFW is generally calculated from the scanlines obtained by SAF and applied to the scanline obtained after coherent summation of the SAF delayed scanlines, which is called a SAF-CFW method. In the paper, a theoretical model was derived to explore the effectiveness of SAF and CFW for single-element-based imaging, and the model was used to explain that SAF is not effective for IVUS imaging in terms of enhancing the spatial resolution, although it has the advantage of improving a contrast-to-noise ratio (CNR). This means that the SAF-CFW method is not optimal for improving the spatial resolution of IVUS imaging. In contrast, it was found in simulations and experiments that applying CFW to the target scanline itself is beneficial for the spatial resolution rather than a coherent summed scanline for IVUS SAF imaging, but CNR was not as good as SAF and SAF-CFW. As a result of both simulation and experimentation, it could be concluded that focused IVUS transducers without the application of those methods may be more advantageous to improve the spatial and contrast resolution simultaneously, considering the system complexity in the implementation of such imaging methods. [ABSTRACT FROM AUTHOR]

• Ultrasound therapy requires real-time monitoring during treatment. • The use of focused ultrasound (FUS) transducers for the purpose is limited due to their inability to provide high quality of images. • The proposed coded excitation and Wiener deconvolution can enhance the resolution, SNR, and CNR of images acquired by FUS transducers. • The performance of the proposed method was confirmed by imaging experiments. To enhance the effectiveness and safety of focused ultrasound (FUS) therapy, ultrasound image-based guidance and treatment monitoring are crucial. However, the use of FUS transducers for both therapy and imaging is impractical due to their low spatial resolution, signal-to-noise ratio (SNR), and contrast-to-noise ratio (CNR). To address this issue, we propose a new method that significantly improve the quality of images obtained by a FUS transducer. The proposed method employs coded excitation to enhance SNR and Wiener deconvolution to solve the problem of low axial resolution resulting from the narrow spectral bandwidth of FUS transducers. Specifically, the method eliminates the impulse response of a FUS transducer from received ultrasound signals using Wiener deconvolution, and pulse compression is performed using a mismatched filter. Simulation and commercial phantom experiments confirmed that the proposed method significantly improves the quality of images acquired by the FUS transducer. The −6 dB axial resolution was improved 1.27 mm to 0.37 mm that was similar to the resolution achieved by the imaging transducer, i.e., 0.33 mm. SNR and CNR also increased from 16.5 dB and 0.69 to 29.1 dB and 3.03, respectively, that were also similar to those by the imaging transducer (27.8 dB and 3.16). Based on the results, we believe that the proposed method has great potential to enhance the clinical utility of FUS transducers in ultrasound image-guided therapy. [ABSTRACT FROM AUTHOR]