Search

Abstract: A major problem with fermentative ethanol production is the formation of large amounts of numerous organic pollutants. In an industrial distillery, stillage, fermenter and condenser cooling water are the main sources of wastewater. However, the selection of a proper technology makes it possible to almost completely avoid emissions of such kind of wastewater to the environment. This study examines the effect of stillage recirculation on fuel ethanol production. It is based on the use of Saccharomyces cerevisiae and a granular starch hydrolyzing enzyme in a simultaneous saccharification and fermentation process using a native starch obtained from corn flour. It was shown that the yield of the ethanol production was not influenced by the recycled stillage, a mean yield being 83.38% of the theoretical value. No significant trend for change in the ethanol concentration or in the residual starch was observed during any particular run, even after the 75% of fresh water was replaced with stillage. Thus, by applying this new clean technology it is possible to significantly reduce the rate of water consumption and in this way the production of by-products such as stillage. [Copyright &y& Elsevier]

Abstract: Cross-flow microfiltration of fermented mash containing native corn starch granules from a simultaneous saccharification and fermentation process, was investigated with respect to the process performance. Influence of transmembrane pressure and cross-flow velocity on normalized permeate flux rate decline and membrane fouling were examined. The microfiltration system was equipped with a tubular ceramic membrane with 0.45μm pore size. A combined pore-blockage–cake-filtration model was successfully used to determine the process performance and identify principal fouling mechanisms. Experimental results revealed that the fouling phenomenon taking place during microfiltration of the fermented mash follows a pattern of initial complete pore blockage and subsequent cake formation. As a result, initial rapid flux decline is followed by gradual flux decline. Fouled membranes were characterized using scanning electron microscopy (SEM). The membrane surface characteristics examined by SEM images evidenced formation of dense deposit on the upper membrane surface. Rinsing the fouled membrane with water followed by investigation of the permeate flux rate indicated occurrence of increased fouling, when microfiltration was carried out at high transmembrane pressure. The highest normalized flux decline was observed for microfiltration operated at the highest transmembrane pressure (1.4bar) and the lowest cross flow velocity (1ms−1). It is recommended to use high cross-flow velocity (4.55ms−1) and low transmembrane pressure (0.35bar) to minimize membrane fouling, triggered by components of the fermented mash. [Copyright &y& Elsevier]