Search

Foredunes provide many environmental and ecosystem services including protection from wave erosion and flooding hazards during storm events. While the impact of human interventions on the short-term evolution of coastal dunes is reasonably well understood, less is known about their contemporary influence on current wind and sediment dynamics several decades after implementation. The coastal dunes in Leucate (SE, France) have been anthropogenically constructed and are dominated by offshore wind conditions. Since their construction 20 years ago, a distinct variation in their longshore morphology has developed that is inherited from its original construction. The northern part of the dune has a symmetrical profile with a 28° degree stoss slope, 30° lee slope and a single crest. The southern part is asymmetric, with a gentler stoss slope (12°), 26° lee slope, and a double crest. To explore the potential geomorphic impacts of this distinct difference in morphology, several numerical simulations with varying wind speeds and direction were conducted. We used Computational Fluid Dynamics (CFD) to explore the spatial variations of the near surface wind flow, shear stress and aeolian sediment transport. show that for each scenario, near surface wind speed accelerated toward the dune crest on the windward slope of the dune. The maximum wind speed varied with incident wind direction, the highest speeds occurring when incident wind flow was perpendicular to the dune crest. The double crest in the southern section of the dune affected the wind flow by inducing two consecutive speeds-up zones, with a greater maximum wind speed than on the single crested dune. Wind flow separation was observed where a steep lee slope was present (single crested dune), and only during perpendicular winds. This suggests that the shape of the dune and the direction of the wind are key parameters rather than wind speed. The area affected by reversed separated flow was spatially limited and did not extend beyond the dune toe but was below the threshold for aeolian sediment transport. Elsewhere in the lee of the dune, the wind was only deflected by an order of 15° for the oblique winds (310 and 330°), and less than 10° for the perpendicular wind (290°) on the southern part. In these locations, the shear velocity exceeded the threshold, notably on the southern dune, which coincided with the formation of undulating aeolian deposits in the lee of vegetation on the dune crest. The spatial differences observed in wind flow and aeolian sediment transport processes on this human-made dune were directly inherited from differences in their construction two decades ago. These results demonstrate the importance of the constructed dune profile, due to its potential impact on the long-term evolution of the landscape and the sediment budget of the system. • Dune construction methods impact their morphology even after several decades. • A relatively small coastal dune can lead to airflow separation. • The pattern of wind flow perturbation depends on dune shape and wind direction. [ABSTRACT FROM AUTHOR]

Dune dynamics and associated sedimentary fluxes have been estimated over a period of a week in the river Seine characterised by limited sediment supply. Distributed into two corridors, typical medium and small dunes associated with fluvial environments have been characterised from multibeam data acquired on four dates, 23-29 March 2021, after a limited peak flood. Dune morphometric parameters have been quantified on cross-dune 1 m spacing of bed elevation profiles and dune migration rates have been calculated by analysing successive multibeam acquisitions. Evidence of limited sediment supply conditions have been recognised from areas uncovered by mobile sediment in the troughs between medium dunes. Under such conditions, bedload transport associated with dune migration has been estimated using three methods: differential bathymetry, dune tracking and the Van Rijn empirical formula using a correction factor accounting for limited sediment supply conditions. The three methods provide similar bedload fluxes (less than an order of magnitude difference), and the small differences are related to input data uncertainties and the capability of these methods to capture sediment transport processes, such as sediment bypassing dunes. Based on field observations, this paper brings new constrains to the relationships between dune morphological parameters, migration rates and sedimentary fluxes and environmental parameters (sediment grain size, flow velocity and water depth) under limited supply conditions in a real river. • Dune morphologies and shapes are constrained by sediment availability • Limited supply of sediment restricts bedload transport associated with dune migration • Differential bathymetry captures a portion of suspended bedload bypassing dunes [ABSTRACT FROM AUTHOR]

Over the last two centuries, rivers worldwide have been affected by human interventions, including dams, river training, and gravel mining. Such actions have often involved river fragmentation and sediment starvation. In this regard, gravel augmentation is an increasingly common restoration practice for mitigating sediment starvation in gravel-bed rivers. However, uncertainties remain on how to better implement and design such operations. This is the case for the Rhône River at Péage-de-Roussillon, France, where 6885 m3 of gravels were augmented in 2017. This work raised some concerns from river managers about the potential threat posed to a downstream reservoir from the arrival of the sediment, and explains why they were interested in the timeframe of sediment propagation, and travel distances and velocities of the augmented sediment. To answer these questions, we propose a modelling framework for simulating the long-term downstream propagation of a pulse of augmented sediment, with this framework being based on a combination of particle tracking data collected in the field and bedload transport capacity estimates. This workflow allowed us to successfully model propagation of gravels along the study reach, and provided useful information on how the sediment wave would behave over the long term. We believe that the methodology proposed in this study has much potential for exploring and investigating the kinematics of sediment wave propagation in gravel-bed rivers. [ABSTRACT FROM AUTHOR]

Wind waves breaking at an angle with the shoreline force the drifting of littoral sediments, which is known for contributing to the formation and growth of barrier spits. Intriguingly, increased rates of longshore wave power have also been associated with the erosion of some barrier spits on the updrift margin of tidal inlets. Therefore, a numerical experiment was designed and is presented here, which investigates the possible links between the longshore wave power and the shortening of these elongated coastal barriers. Based on a process-based model, the experiment provides new insights into the forces at play in the redistribution of sediments between a sandspit and its adjacent inlet, respectively the Cap Ferret and the Bay of Arcachon's tidal inlet, in SW France. More particularly, model scenarios were defined that show how combined waves and tide create gradients of residual sediment transport responsible for a sediment deficit at the spit – inlet boundary. The deficit was also found to deepen with increasing longshore wave energy, as if the transfer of sediment from the spit to inlet shoals was accelerated. This physically explains the previously observed retreat of the spit's distal end during periods dominated by the positive phase of North Atlantic Oscillation (NAO) in winter. Indeed, according to model results, higher and/or more oblique waves associated with the positive phase of the NAO are expected to increase the transfer and storage of the drifting sediments to and by the inlet shoals, and this at the expense of the spit. While these conclusions remain valid, we noticed that the sensitivity of model results to the bottom friction enhanced the importance of accurately representing the spatio-temporal distribution of bed roughness when investigating the morphodynamic interactions between real-world tidal inlets and their margins. • Residual sediment transport is modelled at a mixed energy tidal inlet. • Waves with tides create transport gradients near the inlet's updrift spit extremity. • Larger or more oblique waves deepen this gradient and reinforce the sand deficit. • Physically sounded explanation to enhanced spit erosion during NAO + winters. • Bed roughness models need to be improved for 2DH inlet-spit morphodynamic modelling. [ABSTRACT FROM AUTHOR]

Polybromodiphenyl ethers (PBDEs) in superficial sediments from the Gulf of Lion were studied. They were largely predominated by BDE 209 (98.7% of all PBDEs) indicating that the main source of these pollutants was the commercial mixture deca-BDE. This compound and the less brominated BDE exhibited a southwestward decreasing concentration gradient following the dominant marine currents and bottom relief, e.g. the Mud Belt, the submarine canyons and the Open Continental Slope. All PBDEs exhibited statistically significant correlations confirming the common origin. However, a progressive transformation of the dumped BDE 209 was identified showing a depletion paralleled by increases of the less brominated BDEs (from 8.6% to 22%). These less brominated compounds were accumulated at about 100–140km away from the Rhone prodelta, e.g. at the end of the submarine canyons, evidencing that these transformation compounds can be accumulated at long distances from the dumping sites in the marine system. [Copyright &y& Elsevier]

Abstract: On 10th March 2008, the high energy storm Johanna hit the French Atlantic coast, generating severe dune erosion on Vougot Beach (Brittany, France). In this paper, the recovery of the dune of Vougot Beach is analysed through a survey of morphological changes and hydrodynamic conditions. Data collection focused on the period immediately following storm Johanna until July 2010, i.e. over two and a half years. Results showed that the dune retreated by a maximum of almost 6m where storm surge and wave attack were the most energetic. Dune retreat led to the creation of accommodation space for the storage of sediment by widening and elevating space between the pre- and post-storm dune toe, and reducing impacts of the storm surge. Dune recovery started in the month following the storm event and is still ongoing. It is characterised by the construction of “secondary” embryo dunes, which recovered at an average rate of 4–4.5cm per month, although average monthly volume changes varied from −1 to 2m3.m−1. These embryo dunes accreted due to a large aeolian sand supply from the upper tidal beach to the existing foredune. These dune-construction processes were facilitated by growth of vegetation on low-profile embryo dunes promoting backshore accretion. After more than two years of survey, the sediment budget of the beach/dune system showed that more than 10,000m3 has been lost by the upper tidal beach. We suggest that seaward return currents generated during the storm of 10th March 2008 are responsible for offshore sediment transport. Reconstitution of the equilibrium beach profile following the storm event may therefore have generated cross-shore sediment redistribution inducing net erosion in the tidal zone. [Copyright &y& Elsevier]

Abstract: Since 1834 the Seine estuary (France) has been the site of numerous construction projects with the aim to accommodate and secure boat traffic. Since 1978, the increasing of the activities of Le Havre port, located at the mouth of the estuary, has accelerated the construction work rate. Several dykes, a bridge, and new port facilities have been constructed in rapid succession, modifying considerably the hydrodynamic conditions which sustain a partially vegetated sandy–muddy tidal flat located in the North bank of the estuary between the new port of Le Havre and the Normandy bridge achieved in 1995. The present study deals with the morphological evolution of this zone from 1978 to 2005. The use of a low altitude remote sensing technique combined with traditional methods of ground survey and probes allow to demonstrate the impact of human activities on sedimentary and vegetation dynamics. The Northern mudflat of the estuary is the most affected by these human activities, which surface have reduced of 62% during the last 27 years with an intensified local erosion during the last 27 months corresponding to a loss 1250000 m3 of fine-grained sediment. At the same time, the general sanding up in the channel of the zone has caused a loss of more than 31% of the tidal prism, more than three quarters of which occurred during the last three years. Results also establish that the response times of the sedimentary or topographic readjustment to an installation depend on the extent and the nature of the construction. In fact, the sedimentary readjustments to an installation can be delayed by up to 10 years in the case of the Seine estuary. This delay is explained by a rapid succession of construction works which may occult the effect of a single installation. Except in the case of a dyke built perpendicular to ebb and flood currents, the impacts of these installations reach a hydro-sedimentary equilibrium on the level between 1 and 7 years after their completion. [Copyright &y& Elsevier]

The impact of combined sewer overflows on the Seine River was studied for the scientific interest of understanding highly transient situations and for the management challenges they represent.Measurements were made in the Seine River downstream of a combined sewer overflow (CSO) to identify the relevant variables describing the evolution of water quality. The combined effects of various processes influencing oxygen depletion after a rain event were analysed given all the available data. A complete oxygen balance was established to rank the relative importance of the processes.The model ProSe used for these tasks was designed in the framework of a long term multidisciplinary research program devoted to the Seine River catchment. A comparison of the model we used with existing models was done. The conceptual model was especially adapted for this highly impacted urban ecosystem. Apart from usual processes considered in river ecological modelling, sedimentation and erosion of particles, a biologically active and mobile benthic boundary layer (BBL), exchange of particles and diffusion of solutes between this BBL and the water column, detailed descriptions of algal and bacteria physiology were taken into account.To explain the oxygen depletion in the river, the more relevant variables appear to be the quantity of bacteria brought by the overflow and the biodegradable dissolved organic carbon concentrations. Specific contribution to the evolution of water quality of the river of particles that are sedimenting, was investigated, including the micro organisms brought by the overflows.For this highly eutrophicated river, the influence of the reduction of photosynthesis activity due to cloud cover was quantified. The influence of the toxicity of the CSO on the phytoplanktonic photosynthesis was studied experimentally and taken into account in the model. The resulting effect is a delayed oxygen depletion inside the plume of polluted water. [Copyright &y& Elsevier]