Search

Wetting properties and capillary parameters are of first interest for composite and especially bio-composite manufacturing, interface compatibility between reinforcement and matrix, and durability. Few studies have been dedicated in literature to continuous textile fibers and uncured liquid resins wetting properties, and particularly the methods used may be ambiguous, revealing a wide dispersion in results. In this work a reliable method is proposed to determine properly the wetting properties of fibers and some resins commonly used for composite applications. Firstly, a procedure to characterize dispersive and polar components of surface tension for an epoxy and a partially bio-based resin with a tensiometer is proposed. Then a new method was applied on single fibers of semi-synthetic cellulose (viscose), which allows deriving representative values of contact angles from a series of measurements, minimizing the measurement scatter even when using a conventional tensiometer. Resin components and contact angles between cellulose fibers and test liquids, including resins, led to characterize dispersive and polar components of fiber surface energy. [ABSTRACT FROM AUTHOR]

Abstract: Over the last few years, intensive research has been devoted to the exploitation of “green products” based on natural resources for both matrices and as reinforcements in composite systems. The mechanical properties of reinforced biocomposites, such as flax/polylactic acid (PLA), are largely governed by interfacial properties between the two constituents apart from their intrinsic properties. Although many papers indirectly demonstrate the importance of optimising the interface between these two polymers, the exact nature of the interaction between the natural fibre and the polymeric matrix has not been clearly investigated on a fundamental level and is presently a major technological limitation of these materials. This work presents the first direct study of adhesion forces, by colloidal force microscopy, between smooth PLA films representing the polymer matrix, and a microbead of cellulose that mimic the cellulose material in flax fibres. Normalised adhesion force measurements have shown the importance of capillary forces when experiments were carried out under ambient conditions. Experiments, conducted under dry air, allowed for the deduction of the contribution of pure van der Waals forces, and our results, through the calculation of the Hamaker constant, show that these forces, for the PLA/cellulose/air system, were lower than those obtained for the cellulose/cellulose/air system and hence underlined the importance of optimising the interface among these materials. This study demonstrates the capacity of AFM to probe direct interactions in complex systems by adjusting the nature of the surface and the probe to mimic the materials in contact. Furthermore, the technique can be operated in a variety of environments, consistent with composite making and provides particular opportunity for testing and improving the properties of these new classes of composite materials. [Copyright &y& Elsevier]

Abstract: In this work, a starch-based biopolymer was reinforced with flax strands. Composite materials at different fiber content were obtained by means of high-shearing mixing followed by injection molding processing. The evaluation of the mechanical properties gave a significant increase of the strength and stiffness of composites with the percentage of flax strands. The enhancement was analyzed in terms of compatibility and extension of the adhesion at fiber–matrix interface. The intrinsic mechanical properties of the reinforcement were measured and the behavior of the obtained composites was studied in terms of the modified rule of mixtures and the modified Halpin–Tsai equations. [Copyright &y& Elsevier]