Search

Increased oil production in Canada has resulted in proposals to extend or develop new oil pipelines. Many of these proposals have been met by concerns from the public over potential environmental impacts related to construction and the potential for oil spills to negatively affect groundwater quality. Crude oil sourced from the Alberta oil sands represents a significant proportion of this increase in production. This crude oil is produced as bitumen, which is subsequently diluted with light hydrocarbons to lower viscosity to allow for pipeline transport producing diluted bitumen. In this study, we pumped water through tanks filled with sand to simulate groundwater flow. Tanks were injected with either conventional crude or diluted bitumen to simulate a crude oil spill from a pipeline rupture occurring below the water table representing a pipeline river crossing scenario. Water samples were collected from the downstream end of the tanks throughout the experiment period (∼two months). Compared to water quality guidelines, effluent waters from both conventional crude and diluted bitumen tanks contained elevated concentrations of dissolved organic compounds, particularly benzene, ethylbenzene, toluene and xylenes (BTEX). The effluent from each tank had similar concentrations of benzene, whereas discharge water from conventional crude tanks contained higher concentrations of ethylbenzene, toluene and xylenes. In both tanks, and as expected, the BTEX concentrations appeared to be proportional to those determined in their injected crude oils. The measured dissolved concentrations of benzene, ethylbenzene and toluene are lower than predicted which is attributed largely due to dilution along the flow path. In addition to organic constituents, effluent sampled from the diluted bitumen tank contained some metals (Co, Cr, Fe and V) which measured constituents of the oil., Competing Interests: Declaration of Competing Interest No conflicts of interest., (Copyright © 2022. Published by Elsevier B.V.)

Wastewater recovered from hydraulic fracturing is referred to as flowback and produced water (FPW), and is often saline, contains numerous organic and inorganic constituents, and may pose threats to groundwater resources. Hundreds of spills of FPW have been reported to the Alberta Energy Regulator each year. Recently, samples of FPW derived from hydraulic fracturing of the Duvernay Formation, AB, were found to contain a previously unidentified class of aryl phosphates, including diphenyl phosphate (DPP), triphenyl phosphate (TPP), and others. Aryl phosphates are also used in a variety of other industries and their constituents can be found in flame retardants, plasticizers, lubricants, hydraulic fluids, and oxidizers. Many of these aryl phosphates break down into DPP. Therefore, it is important to determine the environmental fate and potential impact of DPP if spilled in the near-surface, as DPP is an emerging contaminant in soil and groundwater systems. This study was aimed at determining 1) the sorption behavior of DPP onto various surficial sediments collected within the Fox Creek, AB region, and 2) the toxicity of DPP toward aquatic ecosystems. We report that the sorption of DPP onto both clay-rich soils and sandy sediment was low compared to that of other aryl phosphates, with an average log K OC value of 2.30 ± 0.42 (1σ). Therefore, the transport of DPP in groundwater would be rapid due to its low degree of sorption on surficial materials. We also determined the acute 96 h-LC 50 of DPP on zebrafish embryos to be 50.0 ± 7.1 mg/L. Su et al. (2014) studied the toxic effects of DPP and TPP on chicken embryonic hepatocytes and found that DPP had less cytotoxic effects than TPP but altered more gene transcripts. From the results our study, we infer that DPP may pose an environmental risk to aquatic ecosystems if released into the environment., (Crown Copyright © 2019. Published by Elsevier B.V. All rights reserved.)