Search

Pollen is the most common cause of seasonal allergies, affecting over 33 % of the European population, even when considering only grasses. Informing the population and clinicians in real-time about the actual presence of pollen in the atmosphere is essential to reduce its harmful health and economic impact. Thus, there is a growing network of automatic particle analysers, and the reproducibility and transferability of implemented models are recommended since a reference dataset for local pollen of interest needs to be collected for each device to classify pollen, which is complex and time-consuming. Therefore, it would be beneficial to incorporate the reference dataset collected from other devices in different locations. However, it must be considered that laser-induced data are prone to device-specific noise due to laser and detector sensibility. This study collected data from two Rapid-E bioaerosol identifiers in Serbia and Italy and implemented a multi-modal convolutional neural network for pollen classification. We showed that models lost their performance when trained on data from one and tested on another device, not only in terms of the recognition ability but also in comparison with the manual measurements from Hirst-type traps. To enable pollen classification with just one model in both study locations, we first included the missing pollen classes in the dataset from the other study location, but it showed poor results, implying that data of one pollen class from different devices are more different than data of different pollen classes from one device. Combining all available reference data in a single model enabled the classification of a higher number of pollen classes in both study locations. Finally, we implemented a domain adaptation method, which improved the recognition ability and the correlations of transferred models only for several pollen classes., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2022 Elsevier B.V. All rights reserved.)

Common ragweed (Ambrosia artemisiifolia L.) is a widely distributed and harmful invasive plant that is an important source of highly allergenic pollen grains and a prominent crop weed. As a result, ragweed causes huge costs to both human health and agriculture in affected areas. Efficient mitigation requires accurate mapping of ragweed densities that, until now, has not been achieved accurately for the whole of Europe. Here we provide two inventories of common ragweed abundances with grid resolutions of 1 km and 10 km. These "top-down" inventories integrate pollen data from 349 stations in Europe with habitat and landscape management information, derived from land cover data and expert knowledge. This allows us to cover areas where surface observations are missing. Model results were validated using "bottom-up" data of common ragweed in Austria and Serbia. Results show high agreement between the two analytical methods. The inventory shows that areas with the lowest ragweed abundances are found in Northern and Southern European countries and the highest abundances are in parts of Russia, parts of Ukraine and the Pannonian Plain. Smaller hotspots are found in Northern Italy, the Rhône Valley in France and in Turkey. The top-down approach is based on a new approach that allows for cross-continental studies and is applicable to other anemophilous species. Due to its simplicity, it can be used to investigate such species that are difficult and costly to identify at larger scales using traditional vegetation surveys or remote sensing. The final inventory is open source and available as a georeferenced tif file, allowing for multiple usages, reducing costs for health services and agriculture through well-targeted management interventions., (Copyright © 2019 Elsevier B.V. All rights reserved.)