Search

The effect of helium plasma operation on the erosion of plasma-facing components at the low-field side divertor of ASDEX Upgrade was investigated during the 2022 helium experimental campaign. A set of tungsten-covered graphite samples with small platinum marker spots was exposed to both L-mode and H-mode plasma discharges. The highest net erosion of over 1.1 nm/s was observed around the H-mode strike point similar to the case in deuterium plasma. Significant helium inventories of about 6 × 1016 He/cm2 were measured in the scrape-off layer region of the divertor. Impurity deposition including boron and deuterium showed a distinct peak up to 2.4 × 1017 B/cm2 and 1.0 × 1016 D/cm2 between the strike points, and significant boron inventories up to 5.9 × 1016 B/cm2 were also measured on the scrape-off layer side of the H-mode strike point. Platinum re-deposition was not detected between the marker spots, suggesting that it occurs only very locally within the markers. Overall erosion was, as expected, higher than in deuterium discharges, and it also remained comparatively high towards the scrape-off layer, unlike with deuterium.

Laser Induced Breakdown Spectroscopy (LIBS) method is considered to be a promising tool for analyzing the retention of hydrogen isotopes (D and T) and helium (He) on the first walls and divertor regions of future fusion reactors. Helium will be produced in DT reactions but could also be used in the initial non-nuclear phases of DEMO concepts. The present study investigates the He detection by LIBS method in the Be coatings simulating the deposits on the divertor plasma-facing components of JET while the results are also relevant for He detection in the deposits of other wall materials. The study was carried out in a vacuum vessel filled with 2–40 mbar argon background gas. It was shown that 2.8 at. % of He was confidently detectable by LIBS at optimized measurement conditions and the estimated limit of detection at used experimental conditions is approximately 0.7 at. %. The intensity of the He emission line at 587.56 nm was the strongest at the center of the laser-induced plasma plume. The He line intensity increased with the pressure of Ar gas but the broadening of the He line and the increase of the background emission and noise set an upper limit to the Ar background pressure usable for He detection. The application of the calibration-free LIBS procedure resulted in the overestimation of the He/Be ratio by several orders of magnitude. The overestimation can be explained by the deviation of LIBS plasma from the local thermodynamic equilibrium, which is caused by the very high excitation energy of He atoms.

Co-deposited layers on surfaces of bulk tungsten divertor tiles (W lamellae) from the first campaign of JET with the ITER-Like Wall (JET-ILW, 2011–2012) were examined by means of a cross-sectional transmission electron microscope observation. The focus was on geometrical effects in impurity deposition, mainly beryllium (Be), on surfaces located in the poloidal gap separating adjacent lamellae. The study was carried out on the sides (gap surfaces) of two W lamellae from Stack C (located on the outboard part of the horizontal section of the lower divertor), from the region most exposed to the plasma (lamella C23) and in the magnetic shadow of the upstream divertor module (lamella C3). The tile manufacturing process (cold rolling) left shallow grooves, i.e. structures classified as convex (hill) and concave (valley) regions. These regions are decisive for the deposition structure. The main results were: (i) two kinds of impurity deposition features, “homogeneous” and “directional”, have been distinguished; (ii) the directional ones were characterized by nanoscale inclined vertical stripes in the deposition layer; (iii) homogeneous deposition without directional features were in the valley region. The results clearly indicate the impact of the surface finish, even in the tile gaps, on the qualitative and quantitative aspects of deposition.