Search

Interest in the human microbiome has grown in recent years because of increasing applications to biomedicine and forensic science. However, the potential for dating evidence at a crime scene based upon time-dependent changes in microbial signatures has not been established, despite a relatively straightforward scientific process for isolating the microbiome. We hypothesize that modifications in microbial diversity, abundance, and succession can provide estimates of the time a surface was touched for investigative purposes. In this proof-of-concept research, the sequencing and analysis of the 16 S rRNA gene from microbes present in fresh and aged latent fingerprints deposited by three donors with pre- and post-washed hands is reported. The stability of major microbial phyla is confirmed while the dynamics of less abundant groups is described up to 21 days post-deposition. Most importantly, a phylum is suggested as the source for possible biological markers to date fingerprints: Deinococcus-Thermus., Competing Interests: Declaration of Competing Interest Authors declare that they have no competing or conflicting interests., (Copyright © 2023 Elsevier B.V. All rights reserved.)

The toxicological profile of particulates released from carbon fibre-reinforced composites (CFC) incorporating nanoadditives, under impact and fire conditions (e.g. aircraft crash), is unknown to date. Our aim was to investigate the effects of simultaneous impact and fire on the physicochemical features of the particles released from CFCs produced from a graphene oxide (GO)-reinforced epoxy resin and the consequences on its toxicological profile. CFC samples with (CFC + GO) or without GO (CFC) were subjected to simultaneous impact and fire through a specific setup. Soot and residues were characterised and their toxicity was compared to that of virgin GO. Virgin GO was not cytotoxic but induced pro-inflammatory and oxidative stress responses. The toxicity profile of CFC was similar for soot and residue: globally not cytotoxic, inducing a pro-inflammatory response and no oxidative stress. However, an increased cytotoxicity at the highest concentration was potentially caused by fibres of reduced diameters or fibril bundles, which were observed only in this condition. While the presence of GO in CFC did not alter the cytotoxicity profile, it seemed to drive the pro-inflammatory and oxidative stress response in soot. On the contrary, in CFC + GO residue the biological activity was decreased due to the physicochemical alterations of the materials., (Copyright © 2021 Elsevier B.V. All rights reserved.)

Fires involving electrical cables are one of the main hazards in Nuclear Power Plants (NPPs). Cables are complex assemblies including several polymeric parts (insulation, bedding, sheath) constituting fuel sources. This study provides an in-depth characterization of the fire behavior of two halogen-free flame retardant cables used in NPPs using the cone calorimeter. The influence of two key parameters, namely the external heat flux and the spacing between cables, on the cable fire characteristics is especially investigated. The prominent role of the outer sheath material on the ignition and the burning at early times was highlighted. A parameter of utmost importance called transition heat flux, was identified and depends on the composition and the structure of the cable. Below this heat flux, the decomposition is limited and concerns only the sheath. Above it, fire hazard is greatly enhanced because most often non-flame retarded insulation part contributes to heat release. The influence of spacing appears complex, and depends on the considered fire property., (Copyright © 2017 Elsevier B.V. All rights reserved.)

Experimental results are reported on the resuspension of particles deposited on polymer samples representative of glove boxes used in the nuclear industry, under thermal degradation. A parametric study was carried out on the effects of heat flux, air flow rate, fuel type and particle size distribution. Small-scale experiments were conducted on 10 cm × 10 cm PolyMethyl MethAcrylate (PMMA) and PolyCarbonate (PC) samples covered with aluminium oxide particles with physical geometric diameters of 0.7 and 3.6 μm. It was observed for both polymer (fuel) samples that heat flux has no effect on the airborne release fraction (ARF), whereas particle size is a significant parameter. In the case of the PMMA sample, ARF values for 0.7 and 3.6 μm diameter particles range from 12.2% (± 6.2%) to 2.1% (± 0.6%), respectively, whereas the respective values for the PC sample range from 3.2% (± 0.8%) to 6.9% (± 3.9%). As the particle diameter increases, a significant decrease in particle release is observed for the PMMA sample, whereas an increase is observed for the PC sample. Furthermore, a peak airborne release rate is observed during the first instants of PMMA exposure to thermal stress. An empirical relationship has been proposed between the duration of this peak release and the external heat flux., (Copyright © 2013 Elsevier B.V. All rights reserved.)

Immature bovine oocytes were matured and fertilized in vitro, and the resulting zygotes were cultured to the blastocyst stage in droplets of tissue culture medium 199 (TCM 199) conditioned by oviduct cells in the absence of serum. In Experiment 1, the effect of the number of zygotes in a constant culture volume was investigated by culturing 1, 4 or 40 zygotes in 40 microl of culture medium. The cleavage rate was low with a single embryo (36%) but increased with the number of embryos, to reach 50% with 4 embryos/40 microl and 59% with 40 embryos/40 microl. Blastocyst formation was nil with 1 embryo per 40 microl, reaching 2.5% with 4 embryos/40 microl and 18% with 40 embryos/40 microl. The effect of the size of the drop was assessed in Experiment 2, the concentration of embryos remaining constant (1 embryo/1 microl). The volumes tested were 10, 20, 30 and 40 microl. Development into blastocysts increased gradually from 12% in the 10 10 group to 20% in the 40 40 group. Experiment 3 was designed to find a minimal droplet volume able to support the development of a single embryo to the blastocyst stage. The minimum tested volume was 5 microl and was not successful. These results show that bovine embryos cultured in oviduct-conditioned TCM 199 need to cooperate to reach the blastocyst stage. The mechanism of this cooperation is not known, but some autocrine/paracrine factors, probably growth factors, could promote embryo development as was demonstrated in mice. From Experiment 2 we can hypothesize that the surface volume ratio of the droplets could play a role in the culture conditions by interfering with the exchanges between the culture medium and the surrounding environment.