Search

Clotting and anticoagulation of blood samples may give rise to different metabolic profiles of serum and plasma samples, respectively. The anticoagulant used for blood plasma preparation may affect the resulting metabolic profile due to different mechanisms involved in anticoagulation by various agents, e.g. heparin, EDTA and citrate. In the present study, we looked into metabolite and other differences in matched serum and plasma samples and different plasma preparations by using untargeted UPLC-ESI-QTOF/MS profiling and multivariate data analysis (PCA and OPLS-DA). Metabolite differences between serum and plasma samples were mainly related to small peptides reflecting presence or absence of coagulation. Only subtle metabolite differences between the different plasma preparations were noticed, which were primarily related to ion suppression or enhancement caused by citrate and EDTA anticoagulants. For the first time, we also report that anticoagulant counter cation (Na+ or K+) in Na-citrate and K-EDTA plasma can make some metabolites more dominant in ESI-MS. Polymeric material residues originating from blood collection tubes for serum preparation were observed only in serum samples. Hypoxanthine and xanthine were found at higher levels in serum than in plasma samples, possibly due to release from the clot. Mass spectral features of sodium formate and potassium formate ion clusters were detected in citrate and EDTA plasma samples, respectively, originating from formate in mobile phase and Na(+) (in Na-citrate tubes) and K(+) (in K-EDTA tubes). Among the anticoagulants, heparin is recommended for plasma samples used for LC-ESI/MS-based metabolomics of hydrophilic compounds because no plasma interferences or matrix effects were noticed for this polarity range. Citrate and EDTA should be avoided since interferences and serious matrix effects were encountered on some co-eluting polar metabolites. Serum is recommended as a second choice and an alternative to plasma. In conclusion, heparin plasma or serum should be the order of best choice for LC-ESI/MS-based metabolomics research., (Copyright © 2013 Elsevier B.V. All rights reserved.)

Metabolomics and metabolic fingerprinting are being extensively employed for improved understanding of biological changes induced by endogenous or exogenous factors. Blood serum or plasma samples are often employed for metabolomics studies. Plasma protein precipitation (PPP) is currently performed in most laboratories before LC-MS analysis. However, the impact of fat content in plasma samples on metabolite coverage has not previously been investigated. Here, we have studied whether PPP procedures influence coverage of plasma metabolites from high-fat plasma samples. An optimized UPLC-QTOF/MS metabolic fingerprinting approach and multivariate modeling (PCA and OPLS-DA) were utilized for finding characteristic metabolite changes induced by two PPP procedures; centrifugation and filtration. We used 12-h fasting samples and postprandial samples collected at 2h after a standardized high-fat protein-rich meal in obese non-diabetic subjects recruited in a dietary intervention. The two PPP procedures as well as external and internal standards (ISs) were used to track errors in response normalization and quantification. Remarkably and sometimes uniquely, the fPPP, but not the cPPP approach, recovered not only high molecular weight (HMW) lipophilic metabolites, but also small molecular weight (SMW) relatively polar metabolites. Characteristic SMW markers of postprandial samples were aromatic and branched-chain amino acids that were elevated (p<0.001) as a consequence of the protein challenge. In contrast, some HMW lipophilic species, e.g. acylcarnitines, were moderately lower (p<0.001) in postprandial samples. LysoPCs were largely unaffected. In conclusion, the fPPP procedure is recommended for processing high-fat plasma samples in metabolomics studies. While method improvements presented here were clear, use of several ISs revealed substantial challenges to untargeted metabolomics due to large and variable matrix effects., (Copyright © 2012 Elsevier B.V. All rights reserved.)

A hollow-fibre supported liquid membrane (HF-SLM) extraction method has been developed for determination of 11 heterocyclic aromatic amines (HCAs) in human urine samples by using high performance liquid chromatography (HPLC) equipped with an ultraviolet (UV) absorbance detector. These compounds were extracted from an alkaline urine sample (donor phase) into the organic solvent residing in the pores of a polypropylene hollow fibre and then back extracted into an acidic solution (acceptor phase) inside the lumen of the hollow fibre. After extraction, HCAs were analyzed by injecting the analyte enriched acceptor phase into the HPLC. The analyte enrichment factors ranged between 241 and 339 obtained in a 90 min extraction time, and method detection limits (MDL) ranged between 0.1 and 0.5 microg L(-1) with relative standard deviation (RSD) values between 3.4% and 11%. The extraction technique employed in this work is easy to use and rapid as it involves only a few minutes manipulation of each sample. It is the most economical sample preparation/preconcentration technique to our knowledge as compared to other microextraction techniques.

This review article focuses on advances and technical developments of the realm of membrane extraction techniques for the analytes that are (made) amenable to gas chromatographic analysis, and sheds light on the analytical applications to biological and environmental samples. In this review, the state of the art in this growing area of membrane extraction for gas chromatography is presented and several selected examples from our work and that of other groups are discussed. The published articles on the techniques and their applications, found in the scientific literature between the years 2000 and May 2007 and cited in over than 100 references, are perused and commented. A good deal of light will be thrown on the novelty of the techniques, instrumentations and applications. The mentioned techniques are mainly microporous membrane liquid-liquid extraction, extracting syringe, two-phase hollow-fibre-protected liquid-phase microextraction and its modifications, and membrane extraction with sorbent interface and its variants. The merits and demerits of the techniques will be highlighted.

In this study, a method was developed for determination of the free concentration of 4-isobutylacetophenone, a toxic degradation product of ibuprofen, in river and sewage water samples from Sweden. Sample preparation and analysis were performed by a hollow-fibre microporous membrane liquid-liquid extraction (HF-MMLLE) set-up and gas chromatography-mass spectrometry (GC-MS), respectively. In this novel approach, only the liquid in the membrane pores is utilised for non-depleting extraction. Several parameters were studied, including: type of organic solvent, sample pH, and salt and humic acid content. The optimised method allowed the determination of the analyte at the ng L(-1) level in river and sewage water. A linear plot gave a correlation coefficient better than 0.992 and resulted in a limit of detection of 7 and 14 ng L(-1) for river and sewage water, respectively. The enrichment factor was over 2000 in the fibre and over 300 after dilution. The repeatability and reproducibility were better than 5% and 10%, respectively. For the first time, 4-isobutylacetophenone was found at free concentrations of 40 ng L(-1) or below in sewage waters, while it could not be quantified in a river downstream from a municipal sewage treatment plant.

The use of the extracting syringe (ESy), a fully automated membrane-based extraction technique, for analysis of phthalate esters in complex aqueous samples has been investigated. The ESy, working as an autosampler that combines the extraction process and injection into the gas chromatograph (GC) in one single step, is placed on top of the GC equipped with a flame ionisation detector. The aqueous samples are loaded in a tray and automatically extracted by employing microporous membrane liquid-liquid extraction principle. After the extraction, the extract is directly injected into the GC's programmable temperature vaporisation injector. Six different phthalate esters were used as model compounds. Four extraction solvents were tested and the addition of sample organic modifier was examined. Toluene was the optimal solvent to use for extraction. Due to the large variation in polarity of phthalate esters, 50% methanol as organic modifier had to be added to the samples so as to extract the most nonpolar phthalate esters; di-2-ethylhexylphthalate and di-n-octylphthalate, whereas the other four relatively polar phthalate esters were extracted from unmodified samples. No significant difference between extraction of river water, leachate water from a landfill and reagent water was noted, except for minor deviations. The extraction time was 20 min for extraction of a 1-mL sample, resulting in a good linearity for all aqueous media investigated, good enrichment factors (54-110 folds) and low LOD values (0.2-10 ng mL(-1)) and relative standard deviation (%R.S.D.; 0.9-3.7%).

In this study, we present a simple and easy-to-use extraction method that is based on a hollow-fiber microporous membrane liquid-liquid extraction (HF-MMLLE), as an extraction technique, followed by gas chromatography-mass spectrometry (GC-MS) to determine a group of brominated flame retardants (BFRs), polybrominated diphenyl ethers (PBDEs), at trace levels in aqueous samples. The hollow-fiber membrane (HF) filled with organic solvent was immersed into the aqueous sample, spiked with the analytes at ng l(-1) level, and stirred for 60 min. The proposed method could attain enrichment factors (E(e)) up to 5200 times, after optimising parameters, such as organic solvent, stirring speed and extraction time, that affect the extraction. The HF-MMLLE-GC-MS method was successfully applied to the extraction of PBDEs from tap, river and leachate water samples with spike recoveries ranging from 85% to 110%. The method validation with reagent and leachate water samples provided good linearity, detection limits of 1.1 ng l(-1) or lower, both in reagent and leachate water, as well as satisfactory precision in terms of repeatability and reproducibility with values of % relative standard deviation (%RSD) lower than 8.6 and 16.9, respectively.

The Extracting Syringe (ESy), a novel membrane-based sample preparation technique directly coupled as an autosampler to gas chromatography, has been employed for the analysis of organochlorine pesticides (OCPs) in raw leachate water. The ESy has also been applied for extraction of OCPs from contaminated soil samples and its performance has been compared to liquid-solid extraction (LSE) and accelerated solvent extraction (ASE). Extraction of 3-mL leachate sample at the optimised conditions resulted in enrichment factors from 32 (Endrin aldehyde) to 242 (Endrin) and detection limits from 1 to 20 ng/L. The inter-day and intra-day repeatability (% RSD) at 100 and 500 ng/L were <6% and <24%, respectively. The relative recovery at 100 and 500 ng/L ranged from 68% (Aldrin) to 116% (Endrin aldehyde); except Heptachlor that showed 51 and 60%, respectively. The ESy extraction of the slurry-made soil samples revealed occurrence of Endosulfan I (18.2 microg/g soil), 4,4'-DDE (2.6 ng/g soil), Endosulfan II (8.7 microg/g soil) and Endosulfan sulfate (1.1 microg/g soil); showing good agreement with LSE results. The total ESy consumption of organic solvents was 4.2 mL from which only 0.6 mL n-undecane was used during the extraction step (7 microL for the extraction per se), while in the LSE and ASE, it was 420 and 18.1 mL, respectively. The ESy extraction time (0.5 h) was comparable to the ASE time (0.6 h); and the time required for the LSE was 3.75 h. To sum up, the ESy has shown its competency to LSE and ASE technologies, demonstrating its applicability for environmental analysis of organic pollutants, towards green techniques for green environment.