Search

Objective: To evaluate 3 formulations of copper (Cu)-based self-sanitizing surfaces for antimicrobial efficacy and durability over 1 year in inpatient clinical areas and laboratories., Design: Randomized control trial., Setting: We assessed 3 copper formulations: (1) solid alloy 80% Cu-20% Ni (integral copper), (2) spray-on 80% Cu-20% Ni (spray-on) and (3) 16% composite copper-impregnated surface (CIS). In total, 480 coupons (1 cm2) of the 3 products and control surgical grade (AISI 316) stainless steel were inserted into gaskets and affixed to clinical carts used in patient care areas (including emergency and maternity units) and on microbiology laboratory bench work spaces (n = 240). The microbial burden and assessment of resistance to wear, corrosion, and material compatibility were determined every 3 months. Participants included 3 tertiary-care Canadian adult hospital and 1 pediatric-maternity hospital., Results: Copper formulations used on inpatient units statistically significantly reduced bacterial bioburden compared to stainless steel at months 3 and 6. Only the integral copper product had significantly less bacteria than stainless steel at month 12. No statistically significant differences were detected in microbial burden between copper formulations and stainless-steel coupons on microbiology laboratory benches where bacterial counts were low overall. All mass changes and corrosion rates of the formulations were acceptable by engineering standards., Conclusions: Copper surfaces vary in their antimicrobial efficacy after 1 year of hospital use. Frequency of cleaning and disinfection influence the impact of copper; the greatest reduction in microbial bioburden occurred in clinical areas compared to the microbiology laboratory where cleaning and disinfection were performed multiple times daily.

Objective: To determine whether alcohol hand disinfection is an effective alternative to traditional agents for the pre-surgical scrub., Design: A prospective clinical trial of a 70% isopropanol pre-surgical hand disinfectant., Setting: The operating room suites at two hospital sites in British Columbia., Methods: Cases were selected to evaluate both short and longer procedures. The hand disinfectant was compared to agents in current use as surgical scrubs (4% chlorhexidine and 7.5% povidone-iodine). Surgical technique and glove use were not modified. Pre- and postoperative fingertip impression and "glove-juice" cultures were used to determine microbial burden, and hands were evaluated for skin integrity., Results: There was no statistical difference between the microbial hand counts following use of the alcohol-based product or the current agents, for cases less than 2 hours' duration. Comparison of longer surgical cases revealed significantly better pre- and postoperative culture results with the alcohol hand rinse, but analysis of matched pairs showed no significant difference in microbial counts. The alcohol hand rinse was equivalent to the operative scrub in terms of skin integrity and user acceptability., Conclusion: An alcohol hand rinse was equivalently effective in reducing microbial hand counts as the traditional pre-surgical scrub, both immediately after hand disinfection and at the end of the surgical procedure.

This retrospective case-control study examined whether there was a difference in length of time awaiting long-term-care placement for patients identified as having methicillin-resistant Staphylococcus aureus or vancomycin-resistant Enterococcus compared to controls. Thirty-nine patients with methicillin-resistant Staphylococcus aureus or vancomycin-resistant Enterococcus waited for placement an average of 61 days longer than controls (P<.0002). The average number of requests for placement was 2.5 compared to 1.7 for controls (P=.015).

A series of positive biological indicators in steam autoclaves from different hospital departments within the same building were traced to blocked steam traps on building condensate lines. The steps taken during the investigation and a protocol for management of positive biological indicators are described.

Objective: To evaluate the efficacy of the AbTox Plazlyte Sterilization System against selected microbial species using inoculated carriers and surgical instruments., Setting: The microbiology laboratory of a 700-bed adult tertiary-care hospital., Design: The study was conducted in two phases. In phase 1, microorganisms were inoculated to various metal, paper, plastic, and glass carriers, as well as surgical equipment, and processed in cycle II of the AbTox sterilizer. Phase 2 compared AbTox cycle III with ethylene oxide sterilization using stainless steel washers, penicylinders, and surgical equipment. In both phases, cultures of equipment and carriers were obtained after processing. The phenotypic profiles and antibiograms of positive cultures were compared to the original inoculate to rule out the possibility of contamination., Results: Of a total of 350 paper carriers, 375 metal washers, and 234 pieces of equipment processed in cycle II and using trypticase soy broth as the inoculating medium, 123 metal washers (32%) and 8 instruments (3%) failed to be sterilized. Similar failures were noted with cycle III. The presence of either salt or protein adversely affected the system's ability to sterilize in either cycle., Conclusion: Further studies are needed to evaluate the extent to which salt or organic material compromise low-temperature gas-plasma sterilization. Meanwhile, users should exercise caution and use care in the cleaning of instruments that will be processed in the plasma-based sterilization technologies.

A cluster of four cases of surgical and burn wound aspergillosis occurred in a 900-bed, adult, tertiary-care hospital. The source was traced to the outside packages of dressing supplies, which had become contaminated during construction in the central Inventory Control area. This resulted in patients with large exposed surface areas being inoculated directly with Aspergillus spores.

Objective: To evaluate the use of focused surveillance in following resistance patterns within an intensive care unit (ICU)., Design: Antibiograms of 167 gram-negative isolates from ICU patients were compared to the hospitalwide antibiograms. ICU isolates were examined for the newer forms of beta-lactamase resistance. An outbreak of multiresistant Pseudomonas aeruginosa during the survey illustrated the usefulness of focused surveillance in early intervention and containment., Setting: A 700-bed adult tertiary care hospital with a 16-bed medical and surgical ICU., Results: Hospitalwide and ICU antibiograms of the Enterobacteriaceae were similar. However, resistance of P aeruginosa in the ICU was underestimated by hospitalwide rates. Susceptibility of ICU isolates to ceftazidime, ciprofloxacin, and piperacillin was 54%, 54%, and 42%, compared with 81%, 77%, and 85%, respectively, in the hospital at large. Thirty-five percent of isolates exhibited one of the newer forms of beta-lactamase-mediated resistance, with 17% of isolates exhibiting Class I cephalosporinase production., Conclusion: Targeted survey of high antibiotic-use hospital units should be used to study bacterial epidemiology, rather than relying on general hospital data to evaluate patterns of antimicrobial resistance. Monitoring of potential problem areas leads to prompt identification of changes in resistance and allows early intervention.

Objective: To report the contamination of ventilator equipment with Bacillus cereus and to outline the measures taken to trace the source of the organism., Design: A prospective survey of all intensive care unit patients who were culture-positive for B cereus and obtaining of environmental cultures of the cleaning and assembly area of the respiratory services division between October 1991 and September 1992., Setting and Patients: Ventilated patients from a 16-bed medical and surgical intensive care unit (ICU) in a 1,000-bed adult tertiary care hospital., Interventions and Results: From October 1991 to April 1992, B cereus colonized the ventilator circuitry of patients in the ICU. One of two washer/decontaminators in the cleaning and assembly area of the respiratory services division was found to yield the microorganism consistently from the water intake port. The design of the machine precluded easy decontamination of the port with 2% glutaraldehyde and a second outbreak occurred. Following the second outbreak, aqueous chlorhexidine in a final concentration of 0.05% was added to the first of two pasteurization cycles in an attempt to achieve sporicidal activity. This ended the outbreak. Sixty-two patients became colonized with the organism including two with nonfatal Bacillus sepsis and one death due to pneumonia associated with the organism., Conclusion: This experience emphasizes the importance of obtaining cultures of machine parts to identify the source of contamination and thereby direct control measures. Use of chlorhexidine gluconate at high temperatures effectively eradicated B cereus from ventilator circuitry in a practical and cost-effective manner.