Search

Abstract Background Although conventional polymerase chain reaction (PCR) methods are widely used in diagnosis, the titer of the pathogenic virus is difficult to determine based on the PCR. In our prior report, a long-range reverse-transcription quantitative PCR (LR-RT-qPCR) assay was developed to assess the titer of UV-irradiated influenza A virus (IAV) rapidly. In this research, we focused on whether the LR-RT-qPCR assay could evaluate the titer of IAV inactivated by other methods. Methods IAV was inactivated by: heating at 100 °C for periods ranging from 1 to 15 min, treating with 0.12% sodium hypochlorite for periods ranging from 3 to 30 min, or treating with 70% ethanol for periods ranging from 10 to 30 min. Fifty percent tissue culture infectious dose (TCID50) assay was performed to confirm the efficacy of the inactivation methods, followed by LR-RT-qPCR to investigate the correlation between infectivity and copy number. Results One minute heating, 3 min sodium hypochlorite treatment, or 10 min ethanol treatment was sufficient to deactivate IAV. Changes before and after the inactivations in the copy numbers on LR-RT-qPCR were significantly different among the inactivation methods. Heat-inactivation drastically decreased the copy number to below the cutoff value around 5 copies/μL after 5 min treatment. The inactivation time of heating estimated using LR-RT-qPCR was marginally higher than that determined using TCID50. However, the treatments with sodium hypochlorite or ethanol moderately and minimally affected the copy numbers obtained using LR-RT-qPCR (~ 1 digit or no copy number decrease), respectively. Conclusions In addition to good applicability in UV-irradiation previously reported, the LR-RT-qPCR method is suitable for evaluating the effect of heat-inactivation on IAV infectivity. However, minor modifications may be made and investigated in the future to reduce the time intervals with TCID50. Although this method is not applicable for the ethanol inactivation, rapid evaluation of the effects of chlorination on IAV can be determined by comparing copy numbers before and after treatment using the LR-RT-qPCR method.

Abstract Background The polymerase chain reaction (PCR) is commonly used to detect viral pathogens because of its high sensitivity and specificity. However, conventional PCR methods cannot determine virus infectivity. Virus infectivity is conventionally examined with methods such as the plaque assay, even though such assays require several days. Long-range reverse-transcription quantitative PCR (RT-qPCR) has previously been suggested for the rapid assessment of RNA virus infectivity where the loss of infectivity is attributable to genomic fragmentation. Methods IAV was irradiated with 253.7 nm ultraviolet (UV) rays to induce genomic strand breaks that were confirmed by a full-length RT-PCR assay. The IAV was then subjected to plaque assay, conventional RT-qPCR and long-range RT-qPCR to examine the relationship between infectious titer and copy number. A simple linear regression analysis was performed to examine the correlation between the results of these assays. Results A long-range RT-qPCR assay was developed and validated for influenza A virus (IAV). Although only a few minutes of UV irradiation was required to completely inactivate IAV, genomic RNA remained detectable by the conventional RT-qPCR and the full-length RT-PCR for NS of viral genome following inactivation. A long-range RT-qPCR assay was then designed using RT-priming at the 3′ termini of each genomic segment and subsequent qPCR of the 5′ regions. UV-mediated IAV inactivation was successfully analyzed by the long-range RT-qPCR assay especially when targeting PA of the viral genome. This was also supported by the regression analysis that the long-range RT-qPCR is highly correlated with plaque assay (Adjusted R 2 = 0.931, P = 0.000066). Conclusions This study suggests that IAV infectivity can be predicted without the infectivity assays. The rapid detection of pathogenic IAV has, therefore, been achieved with this sensing technology.

Abstract We developed a reliable high-performance liquid chromatographic analysis method using a relative molar sensitivity (RMS) technique that does not require an authentic, identical reference analyte material to quantify blood serum carbamazepine, phenytoin, voriconazole, lamotrigine, meropenem, mycophenolic acid, linezolid, vancomycin, and caffeine levels for routine blood concentration measurements. Carbamazepine and caffeine were also used as non-analyte reference materials to calculate the RMS of each analyte. The RMS was calculated from the ratio of the slope of the calibration equation (analyte/non-analyte reference material), then used to quantify analytes in control serum samples spiked with carbamazepine, phenytoin, voriconazole, meropenem, mycophenolic acid, linezolid or vancomycin. In addition, the concentrations of these six drugs in control serum samples determined by the proposed RMS method agreed well with that obtained using a conventional method. The proposed RMS method is a promising tool for the clinical determination of nine drugs, given the accuracy, precision, and efficiency of quantifying these analytes.