Search

Background: Flexor hallucis longus (FHL) tendon rupture is a challenging injury to lead with clawing of the great toe when the FHL tendon is repaired too tight. When the diagnosis is delayed, the tendon ends may not be opposable because of contracture or poor tendon tissue., Methods: A technique to reconstruct FHL tendon rupture without a free tendon graft is described. A split tendon lengthening is performed at the midfoot around the knot of Henry. Ankle block anesthesia is used to allow the patient's active movement of the interphalangeal (IP) joint to determine the appropriate length of the reconstructed tendon for maintaining balance and preventing the tendon from being too tight or too loose. Between May 2012 and September 2015, five patients with a total rupture of the FHL tendon, having tendon defect distal to the knot of Henry, were treated with split tendon lengthening., Results: Four patients could actively plantarflex the great toe IP joint. One patient who was operated under spinal anesthesia could not actively plantarflex the great toe IP joint, but did not have extension deformity and did not want another procedure. The mean American Orthopedic Foot and Ankle Society (AOFAS) score at a mean follow-up of 44 months was 92 points (range, 80-100)., Conclusions: This technique is described to overcome the difficulty of reconstructing the FHL tendon with tendon defect. The tendon defect could be repaired after split tendon lengthening without a free tendon graft.

Background: Open reduction and plate fixation is the standard operative treatment for displaced midshaft clavicle fracture. However, sometimes it is difficult to achieve anatomic reduction by open reduction technique in cases with comminution., Methods: We describe a novel technique using a real-size three dimensionally (3D)-printed clavicle model as a preoperative and intraoperative tool for minimally invasive plating of displaced comminuted midshaft clavicle fractures. A computed tomography (CT) scan is taken of both clavicles in patients with a unilateral displaced comminuted midshaft clavicle fracture. Both clavicles are 3D printed into a real-size clavicle model. Using the mirror imaging technique, the uninjured side clavicle is 3D printed into the opposite side model to produce a suitable replica of the fractured side clavicle pre-injury., Results: The 3D-printed fractured clavicle model allows the surgeon to observe and manipulate accurate anatomical replicas of the fractured bone to assist in fracture reduction prior to surgery. The 3D-printed uninjured clavicle model can be utilized as a template to select the anatomically precontoured locking plate which best fits the model. The plate can be inserted through a small incision and fixed with locking screws without exposing the fracture site. Seven comminuted clavicle fractures treated with this technique achieved good bone union., Conclusions: This technique can be used for a unilateral displaced comminuted midshaft clavicle fracture when it is difficult to achieve anatomic reduction by open reduction technique. Level of evidence V.