Search

This work investigated the small signal performance of Fabry-Perot Ge-on-Si lasers by modeling and simulations. The 3dB bandwidth dependence on the structure parameters such as poly-Si cladding thickness, Ge cavity width and thickness, and minority carrier lifetime were studied. A 3dB bandwidth of 33.94 GHz at a biasing current of 270.5 mA is predicted after Ge laser structure optimization with a defect limited carrier lifetime of 1 ns.

Low-defect-density Ge thin films are critical in Ge based optical devices (optical detectors, LEDs and Lasers) integrated with Si electronic devices for low-cost, highly integrated photonic circuits. In this work, Ge thin films prepared by wet etching with four different solutions were studied in terms of the surface morphology, defect density and achievable thickness. Both nanostrip-based solution (1:1:10) and HCl-based solution (1:1:5) were able to wet-etch 535 micron thick bulk-Ge substrates to Ge films thinner than 10 micron within 53 hours. The corresponding RMS surface roughness was 32 nm for the nanostrip-based solution and 10 nm for the HCl-based solution. The good quality of bulk-Ge was preserved before and after the etching process according to the HRXRD results. The low threading dislocation density of 6000-7000 cm-2 was maintained in the process of wet etching without introducing extra defects. This approach provides an inexpensive and convenient way to prepare sub-10-micron thick Ge thin films, enabling future studies of low-defect-density Ge-based devices such as photodetectors, LEDs, and lasers.

We present a novel p-GaN gate HEMT structure with reduced hole concentration near the Schottky interface by doping engineering in MOCVD, which aims at lowering the electric field across the gate. By employing an additional unintentionally doped GaN layer, the gate leakage current is suppressed and the gate breakdown voltage is boosted from 10.6 to 14.6 V with negligible influence on the threshold voltage and on-resistance. Time-dependent gate breakdown measurements reveal that the maximum gate drive voltage increases from 6.2 to 10.6 V for a 10-year lifetime with a 1% gate failure rate. This method effectively expands the operating voltage margin of the p-GaN gate HEMTs without any other additional process steps.

We investigated 10 to 200 nm thick black phosphorus flakes on SiO2/Si and polyimide substrates by Angle-resolved Polarized Raman spectra (ARPRS) using 442 nm excitation wavelength. The results revealed that ARPRS with 442 nm excitation can provide unambiguous, convenient, non-destructive and fast determination of BP's crystallographic orientation. The substrate and thickness dependencies of Raman spectra and Raman tensor elements were studied. These dependencies were shown to be influenced by Raman excitation laser heating effect. By comparing with in-situ Raman measurements at elevated temperatures, we were able to quantify the laser-heating effect, which is significant and hard to avoid for Raman measurements of BP on polyimide substrates due to the poor thermal conductivity of the substrate. Thermal processing by substrate heating was shown to have a significant impact on BP on SiO2/Si substrate, but not for BP on polyimide due to smaller thermal expansion mismatch. Our results give important insights on Raman Spectroscopy characterizations of BP on different substrates., Comment: 45 pages, 300 figures