Search

PSR J1023+0038 is the first millisecond pulsar that was ever observed as an optical and UV pulsar. So far, it is the only optical transitional millisecond pulsar. The rotation- and accretion-powered emission mechanisms hardly individually explain the observed characteristics of optical pulsations. A synergistic model, combining these standard emission processes, was proposed to explain the origin of the X-ray/UV/optical pulsations. We study the phase lag between the pulses in the optical and X-ray bands to gain insight into the physical mechanisms that cause it. We performed a detailed timing analysis of simultaneous or quasi-simultaneous observations in the X-ray band, acquired with the XMM-Newton and NICER satellites, and in the optical band, with the fast photometers SiFAP2 (mounted at the 3.6 m Telescopio Nazionale Galileo) and Aqueye+ (mounted at the 1.8 m Copernicus Telescope). We estimated the time lag of the optical pulsation with respect to that in the X-rays by modeling the folded pulse profiles with two harmonic components. Optical pulses lag the X-ray pulses by $\sim$ 150 $\mu$s in observations acquired with instruments (NICER and Aqueye+) whose absolute timing uncertainty is much smaller than the measured lag. We also show that the phase lag between optical and X-ray pulsations lies in a limited range of values, $\delta \phi \in$ (0 $-$ 0.15), which is maintained over timescales of about five years. This indicates that both pulsations originate from the same region, and it supports the hypothesis of a common emission mechanism. Our results are interpreted in the shock-driven mini pulsar nebula scenario. This scenario suggests that optical and X-ray pulses are produced by synchrotron emission from the shock that formed within a few light cylinder radii away ($\sim$ 100 km) from the pulsar, where its striped wind encounters the accretion disk inflow., Comment: 13 pages, 6 figures, 5 tables, accepted for publication in A&A

We present the results of our project for the design and construction and on-sky test of silicon grisms. The fabrication of such devices is a complex and critical process involving litho-masking, anisotropic etching and direct bonding techniques. After the successful fabrication of the silicon grating, we have optimized the bonding of the grating onto the hypotenuse of a silicon prism to get the final prototype. After some critical phases during the experimentation a silicon grism with 363 grooves/mm and a blaze angle of 14 degrees has been eventually fabricated. The application of an A/R coating on both the surfaces has been the last step: this procedure is critical because of the groove geometry of the diffraction grating, whose performace might be compromised by the coating. Then, the grism was inserted in the filter wheel of the Near Infrared camera NICS, at the focal plane of the National Galileo Telescope (TNG), the 3.5 m Italian facility in the Canary Islands (E). The result of the on-sky tests are given in detail., Comment: 9 pages, 13 figures, 1 table. Presented at SPIE Astronomical Telescope + Instrumentation 2014 (Ground-based and Airbone Instrumentation for Astronomy, 9151-203). To be published in Proceeding of SPIE Volume 9151