Search

The hydrodynamics in the Upper Klamath Lake (UKL) plays a significant role in the water quality conditions of the lake. In order to provide a quantitative evaluation of the impacts of hydrodynamics on water quality in UKL, a detailed hydrodynamic model was implemented using an unstructured grid 3-D hydrodynamic model known as the UnTRIM model. The circulation in UKL is driven primarily by wind. Wind speed and direction time-series records were used as input, the numerical model reproduced the wind set-up and set-down at down wind and upwind ends of the lake, respectively. Of the two acoustic Doppler current profiler (ADCP) records, the UnTRIM model reproduced the measured velocity at the deep station. At the shallow station, the model results showed diurnal patterns that correlated well with wind variations, but the measured velocity showed water velocity sustained at 3 to 5 cm/sec or above. Discrepancies between the model results and observations at the shallow ADCP station is discussed on the basis of correct physics. If the field measurements are inconsistent with the known physics, there exists the possibility that the field data are suspect or the field data are revealing some physical processes that are not yet understood.

Many streams and rivers for which the US Geological Survey must provide discharge measurements are too shallow to apply existing acoustic Doppler current profiler techniques for flow measurements of satisfactory quality. Because the same transducer is used for both transmitting and receiving acoustic signals in most Doppler current profilers, some small time delay is required for acoustic “ringing” to be damped out of transducers before meaningful measurements can be made. The result of that time delay is that velocity measurements cannot be made close to the transducer thus limiting the usefulness of these instruments in shallow regions. Manufacturers and users are constantly striving for improvements to acoustic instruments which would permit useful discharge measurements in shallow rivers and streams that are still often measured with techniques and instruments more than a century old. One promising area of advance appeared to be reduction of time delay (blank) required between transmitting and receiving signals during acoustic velocity measurements. Development of a low- or zero-blank transducer by RD Instruments 4 held promise that velocity measurements could be made much closer to the transducer and thus in much shallower water. Initial experience indicates that this is not the case; limitation of measurement quality appears to be related to the physical presence of the transducer itself within the flow field. The limitation may be the result of changes to water flow pattern close to the transducer rather than transducer ringing characteristics as a function of blanking distance. Results of field experiments are discussed that support this conclusion and some minimum measurement distances from transducer are suggested based on water current speed and ADCP sample modes.