Search

This paper presents the results of a study on the thermal conductivity of a soft saturated clay (Bangkok clay) carried out in relation to an investigation into thermal ground improvement using prefabricated vertical drains. The thermal conductivity of clay specimens was measured, at different porosities and temperature levels, using a simple nondestructive steady-state test method. In addition, a theoretical mixture model to simulate the evolution of thermal conductivity of saturated fine-grained soils has been introduced. It is formulated in terms of thermal conductivity and volume fraction of each soil phase (solid and water), and a morphological parameter controlled by the soil fabric condition. The proposed model has been validated against thermal conductivity results reported in the literature and results obtained from the present investigation. Reasonable agreement has been obtained between the predicted and measured thermal conductivity values. [ABSTRACT FROM AUTHOR]

This note studies settlement ratio, Rs, of pile groups in sandy soils, defined as the ratio of the settlement of a pile group to that of a single pile at the same average load per pile. 31 cases of field pile-group load tests and the corresponding field single-pile load tests were collected for this study. More than one-half of the cases consist of 3-diameter spaced, 9-pile groups. Based on the field test data, statistical analyses of Rs at different load levels were conducted for pile groups with cap-ground contact (PGCs) and pile groups with freestanding caps (PGFs), respectively. The mean of Rs decreases with the load level for both PGCs and PGFs, whereas the coefficient of variation of Rs increases with the load level. The influence of cap-ground contact on Rs does not appear to be significant based on a comparison of the mean Rs values of these PGCs and PGFs. In addition, a comparative study on Rs and group resistance ratio Rr, which is defined as the ratio of the average resistance of a pile in a group to that of a single pile at the same settlement, was conducted to clarify possible misunderstanding between Rs and pile group efficiency factor η for driven pile groups in sandy soils. The value of Rs compares settlement at the working load and is often larger than unity. The value of η compares failure loads, which occur at different settlements for pile groups and their respective single piles. η is usually larger than unity due to soil densification and additional contributions from the cap-ground contact for PGCs. [ABSTRACT FROM AUTHOR]

The article presents response on the comment regarding the study on the minimum foundation mass for vibration control. It agrees with the discusser's findings that the dynamics of embedded foundations on layered soil cannot be studied through the simple design method proposed by the authors. It also recognizes the clearness of the author's method, which is based on the analog models of force vibration of a rigid disk.

The authors focus on research into deep building foundations and its behavior under axial and lateral loading. They mention that the prediction of load-transfer curves, both for side resistance and for end bearing, allow for the analysis of deep foundations under a range of conditions. They talk about soil properties around deep foundations after installation and how the pile capacity under axial load differs depending on if the pile was driven into consolidated clay or loose cohesionless soil. They state that research can lead to an improvement of design methods of deep foundations.