Search

Due to extensive applications of microfluidic devices, manufacturing of these apparatus has recently been noticed. Production of multiple emulsions is one of the main goals of manufacturing microfluidic devices. Design and fabrication of microfluidics are functions of the size of emulsion droplets, properties of fluids applied for emulsification, and considered stability for emulsions. In this article, we have manufactured a novel microfluidic device using simple fabrication and accessible materials. Capillary tubes, PTFE (polytetrafluoroethylene) chassis, a medical needle of gauge 32, and O-rings are the primary materials used to produce this device. The production procedure is explained completely, and all the drawings are represented. Concerning probable interactions between glues and flowing fluids, we tried to fabricate and seal the device without applying chemical agents. The device is tested by n-heptane and deionized water to produce multiple water-in-oil-in-water (W/O/W) emulsions. A sensitivity analysis on the rate of injection is performed. Considering the HLB (hydrophilic–lipophilic balance) as an important property of emulsifiers, the effects of two different types of emulsifiers (sodium dodecyl sulfate with HLB of 40 and glycerol monostearate with HLB of 3.8) at various concentrations are investigated. Due to the results, the injection rate of the mediate phase should be less than half of the outer phase for the formation of emulsions. Consequently, the rate of injection for the inner phase should be less than half of that for the mediate phase. The simplicity of production and accessible raw materials could be considered as the strengths of our microfluidic device. [ABSTRACT FROM AUTHOR]

This paper presents a microfluidic device that can automatically transport a droplet on a plastic plate. This device consists of a Cyclo Olefln Polymer (COP) plate and a SiO2 membrane and has wettability gradient surface. Lithographic patterns of hydrophilic SiO2 permitted wettability modification of a hydrophobic COP surface. A series of alternate hydrophobic and hydrophilic wedge-shaped patterns generated a required gradient in wettability. When we dropped a droplet on the wettability gradient surface, it moved along the wettability gradient due to an imbalance between surface tension forces acting on the opposite sides of the droplet edge. The droplet transportation test was carried out using water of 5µl. As a result, we succeeded in automatically transporting the droplet on the SiO2/COP wettability gradient pattern. We also carried out droplet transportation in an enclosed microchannel for preventing droplet evaporation using DI (Deionized) water of 5µl. In this case, the droplet was automatically transported by forming the wettability gradient pattern at the top and bottom in an enclosed microchannel without evaporation. [ABSTRACT FROM AUTHOR]

A microfluidic device that is able to perform dielectric spectroscopy is developed. The device consists of a measurement chamber that is 250 μm thick and 750 μm in radius. Around 1000 cells fit inside the chamber assuming average quantities for cell radius and volume fraction. This number is about 1000 folds lower than the capacity of conventional fixtures. A T-cell leukemia cell line Jurkat is tested using the microfluidic device. Measurements of deionized water and salt solutions are utilized to determine parasitic effects and geometric capacitance of the device. Physical models, including Maxwell-Wagner mixture and double shell models, are used to derive quantities for sub-cellular units. Clausius-Mossotti factor of Jurkat cells is extracted from the impedance spectrum. Effects of cellular heterogeneity are discussed and parameterized. Jurkat cells are also tested with a time domain reflectometry system for verification of the microfluidic device. Results indicate good agreement of values obtained with both techniques. The device can be used as a unique cell diagnostic tool to yield information on sub-cellular units. [ABSTRACT FROM AUTHOR]