Search

A hyperspectral camera (HSC-type Specim IQ) has been applied at the linear plasma device PSI-2 under steady-state conditions. The camera has the capacity of hyperspectral imaging (HSI) with the dimension of a data array 512 × 512 × 204 (x, y, λ) covering the spectral span from 400 to 1000 nm with moderate average spectral resolution (FWHM ∼7 nm). After radiometric calibration and background/continuum emission subtraction, two main applications of the camera, (i) plasma diagnostics in helium (He) plasmas and (ii) plasma–material interaction studies with tungsten (W) targets in neon (Ne) plasmas, have been carried out. The measurements were complemented by a movable Langmuir double probe system (LP) measuring electron temperature (Te) and electron density (ne) in radial direction r and a fiber-coupled cross-dispersion spectrometer with high spectral resolution (Spectrelle) recording neutral He, W, and Ne emission lines over the full plasma column. (i) Two-dimensional (2D) imaging of Te and ne radial profiles in axial direction z of the He plasma column were for the first time obtained by the regression analysis of Te and ne (from LP) and six He I line ratios (from HSC). The spatially resolved plasma parameters covered in these studies range between Te ∼ 0.8–13.4 eV and ne ∼ 0.2 × 1018–3.9 × 1018 m−3 and permit a reconstruction of the plasma conditions in PSI-2 in 2D without LP perturbation. (ii) W sputtering was studied in situ in Ne plasmas exposing W target samples (negatively biased at 100 V) under perpendicular Ne plasma impact. Simultaneously, the 2D distributions of W (W I line at 429.5 nm) in front of the target and the 2D Ne plasma distribution (Ne I line at 703.2 nm) were recorded with complete spectral separation as confirmed by the Spectrelle spectrometer. This permits the simultaneous measurement of the neutral W penetration and its angular distribution induced in the sputtering process and of the impinging plasma distribution. The HSI technique offers, despite a few technical drawbacks, such as the moderate spectral resolution and poor time resolution, a new possibility to distinguish multiple emission lines from plasma and impurities and complements the portfolio of existing Optical Emission Spectroscopy techniques, providing a good compromise regarding spectral, spatial, and temporal resolution. [ABSTRACT FROM AUTHOR]

In the process of tritium storage, the high-pressure storage vessel may be damaged due to accidental conditions, such as impact or drop, which results in tritium leakage. The tritium gas will be released and diffused into the space immediately, which inevitably causes radioactive hazards to personnel and the environment. Ventilation is considered to be the best emergency treatment method for a tritium leakage accident. According to the characteristics of fixed tritium amount and rapid release of tritium in the tritium leakage accident of the high-pressure storage vessel, the numerical simulation of high-pressure released tritium behavior in a confined space is carried out based on Fluent and compared with CATS test data. The error is no more than 5%. The ventilation conditions are optimized according to different ventilation positions and different ventilation rates. It is founded that the tritium removal efficiency when the vent is set on the roof is 30% higher than that on the side wall. The tritium concentration in a confined space can be reduced to the background level after ventilation for 30 min at a rate of 0.5 m3 s−1. The optimal recovery time of the environment is given, which provides technical support for the emergency treatment of the tritium leakage accident of the high-pressure storage vessel. [ABSTRACT FROM AUTHOR]