Search

The physicochemical properties of a homologous series of sodium p-n-alkylbenzoates have been investigated. The objective was to determine whether there is a clear transition point from hydrotropic to surfactant-like behavior with increasing alkyl chain length n, so as to shed clear light on the aggregation mechanism of so-called "hydrotropes". Electrical conductivity measurements were used for a first estimation of the critical aggregation concentrations (cac). As for classical surfactants, log(cac) depends on alkyl chain length n, but two branches of behavior were observed: one having a gradient typical of long chain fatty acid salts and the other with a more shallow dependence. Surface tension (γ) measurements of high purity aqueous solutions were used to generate limiting headgroup areas A(cac), which were in the range (40-50 Å(2)) being consistent with monolayer formation. Small-angle neutron scattering conclusively shows that the lower chain length homologues (classed as hydrotropes) exhibit sharp transitions in aggregation as a function of bulk concentration, typical of regular surfactants. As such, there is little to suggest from this study that hydrotropes differ in association behavior from regular surfactants.

The synthesis of amphoteric polystyrene latex particles, using a mixture of cationic (amidinium based) and anionic (carboxylic acid based) initiators in a surfactant-free emulsion polymerization reaction is investigated; this extends work described in an earlier paper by Bolt et al. Electrophoretic mobility measurements show the effect of the initiator concentration ratio on the isoelectric point (IEP) of the particles. A good correlation with theoretical predictions is obtained. Particle size and polydispersity are determined as a function of the lag time between the addition of each initiator. An increase in particle size and polydispersity is observed at short lag times. It is shown that this is due to the ratio of the cationic to anionic surface charge approaching unity during the reaction. At long lag times an increase in polydispersity may occur due to late-stage, secondary nucleation upon addition of the second initiator. Increasing the reaction pH to reduce the degree of ionization of the cationic initiator greatly reduces the polydispersity and has a significant effect on the IEP of the particles. This effect is ascribed to the burial of a fraction of the neutral amidine groups below the particle surface due to their increased solubility in the monomer. Slow addition of the second initiator was found to reduce the polydispersity of the particles, while maintaining an IEP value consistent with that expected for the ratio of initiators added.