Search

The bis and tris adducts of [6,6]phenyl-C(61)-butyric acid methyl ester (PCBM) offer lower reduction potentials than PCBM and are therefore expected to offer larger open-circuit voltages and more efficient energy conversion when blended with conjugated polymers in photovoltaic devices in place of PCBM. However, poor photovoltaic device performances are commonly observed when PCBM is replaced with higher-adduct fullerenes. In this work, we use transmission electron microscopy (TEM), steady-state and ultrafast time-resolved photoluminescence spectroscopy (PL), and differential scanning calorimetry (DSC) to probe the microstructural properties of blend films of poly(3-hexylthiophene-2,5-diyl) (P3HT) with the bis and tris adducts of PCBM. TEM and PL indicate that, in as-spun blend films, fullerenes become less soluble in P3HT as the number of adducts increases. PL indicates that upon annealing crystallization leads to phase separation in P3HT:PCBM samples only. DSC studies indicate that the interactions between P3HT and the fullerene become weaker with higher-adduct fullerenes and that all systems exhibit eutectic phase behavior with a eutectic composition being shifted to higher molar fullerene content for higher-adduct fullerenes. We propose two different mechanisms of microstructure development for PCBM and higher-adduct fullerenes. P3HT:PCBM blends, phase segregation is the result of crystallization of either one or both components and is facilitated by thermal treatments. In contrast, for blends containing higher adducts, the phase separation is due to a partial demixing of the amorphous phases. We rationalize the lower photocurrent generation by the higher-adduct fullerene blends in terms of film microstructure.

Nanostructured composites of inorganic and organic materials are attracting extensive interest for electronic and optoelectronic device applications. In this paper, we introduce a general method for the fabrication of metal sulfide nanoparticle/polymer films employing a low-cost and low temperature route compatible with large-scale device manufacturing. Our approach is based upon the controlled in situ thermal decomposition of a solution processable metal xanthate precursor complex in a semiconducting polymer film. To demonstrate the versatility of our method, we fabricate a CdS/P3HT nanocomposite film and show that the metal sulfide network inside the polymer film assists in the absorption of visible light and enables the achievement of high yields of charge photogeneration at the CdS/P3HT heterojunction. Photovoltaic devices based upon such nanocomposite films show solar light to electrical energy conversion efficiencies of 0.7% under full AM1.5 illumination and 1.2% under 10% incident power, demonstrating the potential of such nanocomposite films for low-cost photovoltaic devices.