Search

Light absorption and charge transport in oxide semiconductors can be tuned by the introduction, during deposition, of a small quantity of foreign elements, leading to the improvement of the photoelectrocatalytic performance. In this work, both unmodified and vanadium-modified TiO2 thin films deposited by radio-frequency magnetron sputtering are investigated as photoanodes for photoelectrochemical water splitting. Following a structural characterization by X-ray diffraction, atomic force microscopy, Raman spectroscopy, and X-ray photoelectron spectroscopy, photoelectrocatalysis is discussed based on ultrafast transient absorbance spectroscopy measurements. In particular, three different pump wavelengths from UV to the visible range are used (300, 390, and 530 nm) in order to cover the relevant photoactive spectral range of modified TiO2. Incident photon-to-current conversion efficiency spectra show that incorporation of vanadium in TiO2 extends water splitting in the visible range up to approximate to 530 nm, a significant improvement compared to unmodified TiO2 that is active only in the UV range less than or similar to 390 nm. However, transient absorbance spectroscopy clearly reveals that vanadium accelerates electron-hole recombination upon UV irradiation, resulting in a lower photon-to-current conversion efficiency in the UV spectral range with respect to unmodified TiO2. The new photoelectrocatalytic activity in the visible range is attributed to a V-induced introduction of intragap levels at approximate to 2.2 eV below the bottom of the conduction band. This is confirmed by long-living transient signals due to electrons photoexcited into the conduction band after visible light (530 nm) pulses. The remaining holes migrate to the semiconductor-electrolyte interface where they are captured by long-lived traps and eventually promote water oxidation under visible light.

We investigated the effects of ultrafast laser excitation of Au nanoparticles (NPs) having strong interparticle electromagnetic coupling by irradiating the NPs either at interband or plasmon-resonance wavelengths (13-100 J/m(2) fluence regime). We observed that interband excitation is significantly more efficient than plasmonic excitation in reshaping, coalescing, and ultimately sublimating the NPs, despite the light-absorption cross section of interband excitation being almost half that of plasmonic irradiation. We ascribed this to the different localizations of radiation-induced heat sources in the strongly coupled NPs in the two cases. Interband excitation induces homogeneous heat generation in Au, and so the conventional NP heating pathway is followed, eventually leading to overall melting, coalescence, and ablation of Au. Plasmonic irradiation, on the other hand, promotes strong localization of the heat sources within small energetic hot spots, a fact that we suggest may lead to nonthermal effects that melt and reshape the NPs only on the local scale, leaving the system otherwise relatively unscathed.

The assembly and the orientation of functionalized pentacene at the interface with inorganics strongly influence both the electric contact and the charge transport in organic electronic devices. In this study electronic spectroscopies and theoretical modeling are combined to investigate the properties of the bis(triisopropylsilylethynyl)pentacene (TIPS-Pc)/Au(111) interface as a function of the molecular coverage to compare the molecular state in the gas phase and in the adsorbed phase and to determine the thermal stability of TIPS-Pc in contact with gold. Our results show that in the free molecule only the acene atoms directly bonded to the ligands are affected by the functionalization. Adsorption on Au(111) leads to a weak coupling which causes only modest binding energy shifts in the TIPS-Pc and substrate core level spectra. In the first monolayer the acene plane form an angle of 33 +/- 2 degrees with the Au(111) surface at variance with the vertical geometry reported for thicker solution-processed or evaporated films, whereas the presence of configurational disorder was observed in the multilayer. The thermal annealing of the TIPS-Pc/Au(111) interface reveals the ligand desorption at similar to 470 K, which leaves the backbone of the decomposed molecule flat-lying on the metal surface as in the case of the unmodified pentacene. The weak interaction with the metal substrate causes the molecular dissociation to occur 60 K below the thermal decomposition taking place in thick drop-cast films.